User Manual

1. Introduction

Thank you for choosing the newstyle 348LED Solar Garden Light. This product is designed to provide efficient and reliable outdoor lighting for various applications, including yards, garages, gardens, parking lots, and entryways. Featuring 3 ultra-bright adjustable LED heads, a sensitive PIR motion sensor, and IP65 waterproofing, this solar light offers versatile illumination and enhanced security. Please read this manual carefully before installation and use to ensure optimal performance and longevity of your device.

2. Safety Information

• Ensure the solar panel is placed in direct sunlight for maximum charging efficiency.
• Avoid installing the light in areas where it might be obstructed by objects, which could reduce solar charging.
• Do not shine other light sources directly onto the solar panel at night, as this may cause the light to interpret it as daytime and prevent it from activating.
• The performance of the solar light is dependent on sunlight intensity, geographical location, weather conditions, and other environmental factors.
• This product is designed for outdoor use and is IP65 waterproof.
• Keep out of reach of children.

3. Package Contents

Upon opening the package, please verify that all components are present and in good condition:

• 348LED Solar Light Unit (with integrated solar panel and motion sensor)
• Remote Control
• Ground Stake Accessories (multiple segments for adjustable height)
• Mounting Hardware (screws and wall plugs)
• User Manual (this document)

Refer to the unboxing video for a visual guide to package contents:

Video: Unboxing and assembly demonstration.

4. Specifications

Product dimensions: Solar panel 14cm/5.51in x 8cm/3.14in. Light unit 28cm/11in wide, 11cm/4.3in high. Ground stake 16.5cm/6.4in.

Image: Product dimensions and included components.

5. Setup and Installation

The newstyle solar light offers two installation options: wall mount or ground stake. Choose the method that best suits your lighting needs.

General Installation Tips:

• **Initial Charge:** It is recommended to fully charge the solar light for 1-2 days in direct sunlight before the first use to ensure optimal battery performance.
• **Solar Panel Placement:** Install the solar panel in a location that receives ample direct sunlight throughout the day. Ensure no objects block the solar panels.
• **Avoid Nighttime Light Interference:** Do not install the light in an area where other strong light sources (e.g., streetlights, other floodlights) might shine directly onto the solar panel at night. This can prevent the light from activating automatically.
• **Testing during the day:** To test the light during the day, cover the solar panel completely to simulate darkness.

Wall Mount Installation:

1. Choose a suitable wall location that receives direct sunlight and provides the desired illumination area.
2. Mark the drilling points for the mounting bracket.
3. Drill holes and insert wall plugs.
4. Secure the mounting bracket to the wall using the provided screws.
5. Attach the solar light unit to the mounting bracket, adjusting the angle as needed.

Image: Solar light installed on a wall and as a ground stake in a garden.

Ground Stake Installation:

1. Assemble the ground stake by connecting the segments.
2. Attach the solar light unit to the top of the assembled ground stake.
3. Select a soft ground area in your garden or lawn that receives direct sunlight.
4. Insert the ground stake firmly into the soil.
5. Adjust the angle of the light heads and solar panel for optimal coverage and charging.

Image: Diagram illustrating installation steps and initial charging.

6. Operating Instructions

The solar light operates automatically, turning on at dark and charging during the day. It features a motion sensor and multiple lighting modes, which can be selected using the button on the back of the light panel or the included remote control.

Adjusting Light Heads:

The three light heads are independently adjustable, allowing you to direct light precisely where needed. The two side heads offer a 135° illumination range, and the entire unit can be adjusted up to 360°.

Image: 360° adjustable lighting angle.

Motion Sensor:

The sensitive PIR motion sensor has a 180° detection angle and a range of 3-5 meters (up to 40 feet in optimal conditions). For best performance, mount the light at a height of 6-8 feet.

Image: Sensitive PIR sensors with detection angle and range.

Lighting Modes:

The product's default state is OFF mode. You can cycle through the modes by pressing the black button on the back of the light panel or using the remote control.

• **Mode 1 (Motion Sensor Mode):** The light remains off until motion is detected. When motion is detected, it turns on at full brightness for approximately 20 seconds, then turns off.
• **Mode 2 (Dim Light Sensor Mode):** The light stays on at a dim level at night. When motion is detected, it brightens to full intensity for approximately 20 seconds, then returns to dim light.
• **Mode 3 (Constant Light Mode):** The light automatically turns on at a constant medium brightness at dusk and stays on until dawn or until the battery runs out.
• **OFF Mode:** To turn off the light, cycle through the modes until it reaches the OFF state.

Image: Remote control for mode selection.

7. Maintenance

• **Cleaning:** Regularly clean the solar panel surface with a soft, damp cloth to remove dust, dirt, or debris. A clean panel ensures efficient charging.
• **Battery Care:** The integrated lithium battery is designed for long-term use. Avoid prolonged storage in a completely discharged state. If storing for an extended period, ensure the battery is fully charged and recharge every few months.
• **Environmental Protection:** The light is IP65 waterproof, meaning it is protected against dust and low-pressure water jets. However, avoid submerging the unit in water.
• **Inspection:** Periodically check the mounting hardware to ensure it remains secure.

8. Troubleshooting

• **Light does not turn on at night:**
  • Ensure the solar panel is clean and receiving direct sunlight for at least 6-8 hours during the day.
  • Verify that the light is not in OFF mode. Press the mode button to cycle through modes.
  • Check for any external light sources shining on the solar panel at night, which might prevent activation.
  • If testing during the day, ensure the solar panel is completely covered.
• **Light duration is short:**
  • Insufficient sunlight during the day can lead to reduced battery charge. Relocate the light to a sunnier spot.
  • Cloudy or rainy weather will reduce charging efficiency.
  • Ensure the solar panel is clean.
• **Motion sensor not detecting:**
  • Ensure the sensor is not obstructed.
  • Verify the light is in Mode 1 or Mode 2.
  • Check the mounting height (recommended 6-8 feet) and ensure the detection area is clear.
• **Remote control not working:**
  • Ensure the remote control has a working battery.
  • Point the remote directly at the light's sensor.
  • Check for any obstructions between the remote and the light.

9. User Tips

• **Optimal Placement:** For security lighting, position the light to cover key entry points or dark areas. For ambient lighting, consider placing multiple units along pathways or in garden beds.
• **Seasonal Adjustment:** In winter or during prolonged cloudy periods, the solar light may receive less charge. Consider adjusting the lighting mode to conserve battery life if needed.
• **Angle Adjustment:** Experiment with the angles of the three light heads to achieve the best spread and intensity for your specific area.
• **Remote Convenience:** Keep the remote control handy to easily switch between lighting modes without needing to access the physical button on the unit.

10. Warranty and Support

This newstyle solar light comes with a 1-YEAR Warranty from the date of purchase. Please retain your proof of purchase for warranty claims.

For detailed warranty information, technical support, or further inquiries, please refer to the official product documentation. A comprehensive user manual in PDF format is available for download:

User manual (PDF): View PDF