SANPKON EMS Muscle Stimulator

Contents

SANPKON EMS Muscle Stimulator User Manual

Model: EMS Muscle Stimulator

Introduction

The SANPKON EMS Muscle Stimulator is designed to provide low-frequency electrical muscle stimulation (EMS) for body shaping, muscle training, and relaxation. This device utilizes safe and stable pulse energy to induce muscle movement, helping to relieve fatigue, improve muscular paralysis, and offer a massage-like effect. It is suitable for various body parts including the abdomen, arms, hips, waist, pectoralis, and legs.

Man demonstrating the EMS Muscle Stimulator on his abdomen and arms, with individual pads and control units displayed.
Figure 1: SANPKON EMS Muscle Stimulator in use and components.
Diagram explaining EMS technology, showing brain signals and micro-electric signals for muscle training.
Figure 2: Explanation of EMS technology.

Safety Information

WARNING: Please read all safety instructions carefully before use to prevent injury or damage.

  • Do not use if you are undergoing medical treatment involving electronic implants such as pacemakers, artificial hearts, or electrocardiographs. This may cause malfunction of medical devices.
  • Do not attach the device to your body while the power is on to avoid electric shock.
  • Avoid touching the adhesive side of the gel pads, as this can decrease their lifespan and effectiveness.

CAUTION:

  • Improper handling or use may lead to bodily injury or property damage.

Setup and Assembly

1. Battery Installation

  1. Open the battery shell/cover on the back of the main control unit.
  2. Insert two AAA 1.5V alkaline batteries, ensuring correct polarity (+ and -).
  3. Close the battery cover securely.
  4. Turn on the switch to confirm the indication lamp lights up.

2. Attaching the Control Unit to the Pads

  1. Align the two snap buttons on the main control unit with the corresponding buttons on the gel pad.
  2. Press firmly to secure the control unit to the gel pad.

3. Preparing and Applying the Gel Pads

  1. Always wash and thoroughly dry the area of your body where you intend to use the adhesive gel pads. This ensures optimal adhesion and hygiene.
  2. Carefully pull the protective vinyl cover off the gel pad.
  3. Attach the gel pad with the assembled control unit to the desired part of your body (e.g., abdomen, arms, hips, waist, pectoralis, legs).
Step-by-step operation instructions showing battery loading, placing host on patch, pulling cover, applying toner, turning on, selecting mode, increasing/decreasing intensity, and turning off.
Figure 3: Operation Instruction steps.
Detailed instructions for battery installation, assembling the host device, and peeling off adhesive pads.
Figure 4: Detailed installation and management steps.
Diagram showing various application areas for the EMS pads on the human body, including abdomen, waist, arm, thigh, shank, and neck.
Figure 5: Recommended application areas for the EMS pads.

Operating Instructions

Control Unit Overview

The control unit features the following buttons and indicators:

  • ON/+: Power on / Increase Intensity
  • OFF/-: Power off / Decrease Intensity
  • PROGRAM: Mode Switch (A-F, 6 modes available)
  • Indicator Lamps: Red lamps indicate the selected mode and intensity level.

Usage Process

  1. Ensure the control unit is attached to the gel pad and the pad is applied to your body.
  2. Press the ON/+ button to power on the device. Start at the lowest output level. The indicator lamps will light up gradually.
  3. Press the PROGRAM button to cycle through the 6 available modes (A-F) until you find your desired program.
  4. Press the ON/+ button to increase the intensity. There are 10 intensity levels.
  5. Press the OFF/- button to decrease the intensity.
  6. The device has a default working time of 12 minutes per session.
  7. To turn off the device, long-press the OFF/- button until the indicator lamps turn off. If left unattended, the device will automatically power off after 12 minutes of inactivity.

Effective Usage Tips

  • Use the low-frequency treatment for 12 minutes per session, 2-3 times a day. Overuse or excessively high intensity may lead to muscle fatigue.
  • Avoid using the device within 30 minutes after dinner.
  • It is recommended to use the device after a shower or warm bath for better results.

Maintenance and Care

1. After Each Use

  1. Turn off the power after each use.
  2. Separate the adhesive gel pads from the main control unit.
  3. Attach the adhesive gel pads back to their original pad holder (vinyl cover) to prevent them from drying out.

2. Cleaning

  • Main Control Unit: Clean any dirt or marks on the case with a damp cloth using a neutral cleaning agent, then wipe it dry with a clean cloth.
  • Adhesive Gel Pads: If the adhesive side of the gel pad becomes dirty or loses its stickiness, gently clean it with a wet towel to regain adhesion. Be careful not to over-moisten the pad, as excessive moisture can negatively affect adhesion.

3. Storage

  • Store the device in a place inaccessible to children.
  • Do not store the unit in direct sunlight, high temperatures, high humidity, wet or dusty environments, near fire, or in places subject to strong shocks.
  • If the device will not be used for an extended period (more than 1 month), remove the batteries from the control unit and store them separately.
  • Do not touch the battery terminals with wet hands.

4. Gel Pad Replacement

The adhesive gel pads are consumable items. If they lose their stickiness permanently or become uncomfortable to use even after cleaning, they should be replaced. Always replace with gel pads of the same type and model.

Troubleshooting

Problem Possible Cause Solution
Device does not turn on. Batteries are dead or incorrectly installed. Check battery polarity and replace with new AAA batteries if necessary.
Gel pads are not sticking well. Pads are dirty or have lost adhesion. Clean the adhesive side of the pads with a wet towel. If adhesion is not restored, replace the pads. Ensure skin is clean and dry before application.
Weak or no sensation during use. Low battery, poor pad contact, or intensity too low. Increase intensity. Ensure pads are firmly attached to clean skin. Replace batteries if needed.
Uncomfortable sensation or skin irritation. Intensity too high, prolonged use, or skin sensitivity. Decrease intensity. Limit usage to recommended duration (12 minutes). Discontinue use if irritation persists. Ensure skin is clean and free of lotions/oils.

Specifications

Feature Detail
Product Name Super Big Butterfly (EMS Muscle Stimulator)
Power Supply Battery Powered (2 x AAA 1.5V Alkaline Batteries)
Voltage <50V AC
Modes 6 modes (A-F)
Frequency 1-100Hz
Working Time 12 minutes (per session, automatic shutdown)
Output Maximum 9.8mA
Application Area Body (Abdomen, Arms, Hips, Waist, Pectoralis, Legs, Neck)
Material Composite Material
Abdominal Pad Size Approx. 19.4cm x 20cm (or 18.8cm x 20.2cm)
Arm Pad Size Approx. 20cm x 6cm (or 17cm x 6.9cm)
Weight Approx. 57.4g (main unit)
Package Dimensions Length: 20cm, Width: 15cm, Height: 3cm
Package Weight 0.08 kg
Diagram showing the dimensions of the abdominal pad (19.4cm width, 20cm height) and arm pad (20cm length, 6cm width).
Figure 6: Dimensions of the EMS pads.

User Tips

  • For best results, use the stimulator consistently for 12 minutes per session, 2-3 times daily.
  • Always ensure your skin is clean and dry before applying the gel pads to maximize adhesion and effectiveness.
  • If the gel pads start to lose their stickiness, gently wipe the adhesive surface with a damp cloth to revive them. Avoid excessive moisture.
  • Store the gel pads on their protective vinyl sheets after each use to prolong their lifespan.
  • Experiment with different modes and intensity levels to find what works best for your comfort and muscle stimulation goals.

Frequently Asked Questions (FAQ)

Q: How often should I use the EMS Muscle Stimulator?
A: It is recommended to use the device for 12 minutes per session, 2-3 times a day. Avoid overuse.
Q: What should I do if the gel pads are no longer sticky?
A: Gently clean the adhesive surface of the pads with a wet towel. If this does not restore adhesion, it's time to replace them with new pads of the same type.
Q: Can I use the device on any part of my body?
A: The device is designed for use on various body parts including the abdomen, arms, hips, waist, pectoralis, and legs. Refer to the application diagrams in the manual for guidance.
Q: Why is the device not turning on?
A: Check if the batteries are correctly installed with the right polarity and if they are fresh. Replace them if necessary.

Support and Additional Resources

For further detailed instructions and diagrams, you may refer to the official user manual PDF:

View User Manual (PDF)

If you encounter any issues not covered in this manual, please contact the seller or manufacturer for assistance.

Documents and downloads

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.