Introduction
Thank you for purchasing the WMARK NG-8636 KIT Professional Barber Combo. This manual provides important safety information, operating instructions, maintenance tips, and specifications to ensure safe and efficient use of your hair clipper and trimmer. Please read this manual thoroughly before first use and keep it for future reference.
Important Safety Information
Read all instructions before use. Failure to follow these instructions may result in damage to the product or personal injury.
- Warning: Keep the device and its cord out of reach of children under 3 years old.
- Keep away from children unless supervised by an adult.
- Do not use this product for purposes other than its intended use.
- Inspect the product before each use; do not use if damaged.
- Follow installation and operation guidelines to avoid injury.
- Do not expose to water or moisture.
- Handle with care to avoid cuts or injuries.
Package Contents
Ensure all items are present in the package:
- 1 * Hair Clipper
- 1 * Hair Trimmer
- 6 * Guide Combs for Clipper (1.5mm, 3mm, 4.5mm, 6mm, 9mm, 12mm)
- 3 * Guide Combs for Trimmer (1mm, 2mm, 3mm)
- 2 * USB Charging Cables
- 2 * Charging Bases
- 1 * Cleaning Brush
- 1 * Instruction Manual (this document)
- 1 * Hair Comb
- 2 * Haircut Stickers
Setup and Charging
Before First Use
- Remove all protective films from the device.
- Inspect the blades and ensure they are clean and free from debris.
Charging the Device
- Connect the provided USB cable to a certified 5V power adapter (not included).
- Plug the other end of the USB cable into the charging port on the trimmer/clipper or place the device onto its respective charging base.
- The integrated LED display will indicate the charging status and battery level.
- A full charge typically takes 2.5 to 4 hours.
- Ensure the device is fully charged before its first use for optimal battery life.
Operating Instructions
Turning On/Off and Mode Selection
- To Turn On: Press and hold the power button for 3 seconds.
- To Change Modes/Speeds: Short press the power button to cycle through available speed settings. The LED display will show the current speed.
- To Turn Off: Press and hold the power button for 3 seconds.
Using the Hair Clipper
- The hair clipper features a powerful 9000 RPM motor for efficient cutting, especially for thick hair.
- It has a 5-position adjustable blade for precise length control. Use the lever on the side of the clipper to adjust the blade length from 0.5mm to 1mm.
- Attach the desired guide comb (1.5mm, 3mm, 4.5mm, 6mm, 9mm, 12mm) for longer cutting lengths. Ensure the comb is securely attached before use.
- Adjust speed settings as needed for your hair type and desired style.
Using the Hair Trimmer
- The hair trimmer is designed for professional-quality detailing, fades, and beard styling.
- Use the trimmer for precise lines and edges.
- Attach the desired guide comb (1mm, 2mm, 3mm) for specific trimming lengths.
- The integrated LED display provides real-time information on battery life and current settings.
Maintenance and Care
Cleaning After Use
- Turn off the device and disconnect it from the power source.
- Use the provided cleaning brush to remove loose hairs from the blades and housing.
- The blades can be washed under water for thorough cleaning. Ensure the device is completely dry before storage or next use.
- Regularly oil the blades with a few drops of clipper oil (not included due to airline regulations) to maintain cutting performance and prolong blade life.
Storage
- Store the device in a dry place, away from direct sunlight and moisture.
- Keep away from children.
Troubleshooting
If you encounter any issues with your WMARK NG-8636 KIT, please refer to the following common solutions:
| Problem | Possible Cause | Solution |
|---|---|---|
| Device does not turn on | Low battery; Device not charged; Power button not pressed long enough. | Charge the device fully. Press and hold the power button for 3 seconds. |
| Poor cutting performance | Blades are dull or dirty; Insufficient oil; Hair buildup. | Clean the blades thoroughly with the brush and water. Apply clipper oil. Ensure no hair is stuck in the blades. |
| Device stops during use | Battery is low. | Recharge the device. |
| Excessive noise or vibration | Blades are not aligned or are loose; Lack of lubrication. | Check blade alignment. Apply clipper oil. If the problem persists, contact customer support. |
Specifications
| Feature | Specification |
|---|---|
| Model | NG-8636 KIT |
| Power Supply | USB (Mains and battery operation) |
| Voltage | Global Universal (100-240V), <20V |
| Motor Type | ROTARY, 9000 RPM (Clipper) |
| Battery Type | Lithium-ion Battery (2500 / 2000 mAh) |
| Battery Life | Over 90 minutes (Working Time: 180 - 240 Minutes) |
| Battery Charging Time | 2.5 - 4 Hours (More than 2 hours) |
| Is Batteries Included | Yes |
| Blade Material | Stainless steel |
| Minimum Cutting Length | 0.5 - 1 mm |
| Maximum Cutting Length | 11 - 20 mm |
| Length Adjustment Method | Change of nozzles (Guide Combs) |
| Number of Nozzles | 5 or more (6 for clipper, 3 for trimmer) |
| Function | Wet haircut, Dry haircut, Washing knives under water, Fast Charging, Charging indication |
| Purpose | For body, For the head |
| Material | Zinc Alloy |
| Certification | 3C, CE, UL, GS, CCC |
| Origin | Mainland China |
User Tips
- For best results, always start with a fully charged device.
- When cutting hair, move the clipper/trimmer against the direction of hair growth for a cleaner cut.
- Use the smaller guide combs for fading and detailing around the ears and neckline.
- Regularly clean and oil the blades to prevent pulling and ensure smooth operation.
- Experiment with different speed settings to find what works best for your hair type and desired style.
Warranty and Support
Warranty Information
All WMARK products come with a 12-month warranty from the date of purchase. This warranty covers manufacturing defects and malfunctions under normal use.
After-Sale Service
If you experience any issues with your product, particularly if it is damaged during shipping, please contact our customer service immediately. Ensure the item remains in its original condition. We will review your situation and provide an appropriate solution.
For further assistance or inquiries, please refer to the contact information provided with your purchase or on the official WMARK website.