Introduction
The XFOX Glass Vibrator is designed for personal wellness, featuring a constant temperature heating function and 10 distinct vibration modes for varied stimulation. Crafted from high-quality glass and silicone, this device offers a unique experience with its ergonomic design and advanced features.
Image: The XFOX Glass Vibrator, highlighting its elegant and functional design.
Important Safety Warnings
- This product is prohibited for use by minors under the age of 18.
- Do not use the device while it is charging. The device is designed to automatically shut down if the charger is inserted during operation.
- Always clean and dry the equipment thoroughly before and after each use, especially before charging.
- Use only the attached magnetic charging cable and a charger with matching parameters to avoid affecting battery life or causing product damage.
- Store the product in a cool, ventilated, and dry place, away from high temperatures, heavy pressure, and humid environments.
Package Contents
Your XFOX Glass Vibrator package should contain:
- 1 x XFOX Glass Vibrator (Model B002)
- 1 x Magnetic Charging Cable
- 1 x User Manual (this document)
Technical Specifications
| Parameter | Detail |
|---|---|
| Product Material | Silicone + ABS + Glass |
| Product Function | 3 levels and 7 frequencies (10 Modes total) |
| Work Noise | ≤ 55dB |
| Charging Voltage | DC5V |
| Waterproof Rating | IPX6 |
| Charging Method | Magnetic Attraction |
| Charging Time | 1-2 hours |
| Usage Time | 50-60 minutes |
Image: Product dimensions. Note: Handmade products may have slight variations (approximately ±5mm).
Initial Setup
- Unpack the XFOX Glass Vibrator and all accessories.
- Before first use, thoroughly clean the device as described in the "Maintenance and Upkeep" section.
- Fully charge the product before its initial operation. Refer to the "Charging Instructions" section for details.
Operating Instructions
The device features a single control button for power and mode selection.
Image: Visual representation of the 10 vibration modes.
- Power On: Press and hold the control button for 1.5 seconds. The button indicator light will turn on, and the device will enter the first vibration frequency.
- Change Modes: Click the button again to cycle through the vibration frequencies. The device offers 3 speeds and 7 frequencies, totaling 10 distinct modes.
- Power Off: Press and hold the control button for 1.5 seconds to turn off the product.
Image: The vibrator in use, highlighting its heating function (40°C).
Charging Instructions
- Before each charging session, ensure the equipment is thoroughly cleaned and dry.
- Connect the attached magnetic charging cable to the product's magnetic interface.
- When the device is charging, the LED light will flash. Once fully charged, the LED light will remain on continuously.
- During operation, the LED light flashes with the frequency of the motor, and the light source is red.
- Always use a charger with matching parameters for charging. Using an incompatible charger may affect battery life or cause product damage.
Attention: Do not use the device while charging. If the charger is inserted, the device will immediately stop working (i.e., shut down) as a safety measure.
Image: Magnetic charging connection.
Maintenance and Upkeep
Cleaning:
- Before and after each use, ensure the product is powered off and completely turned off.
- Clean the body with alcohol or antibacterial soap to remove any residue.
- Rinse with clean water.
- Wipe dry with a soft towel.
- Do not use cleaning agents containing alcohol, petroleum solvents, or acetone, as these can damage the material.
Image: The device is IPX7 waterproof, allowing for easy cleaning under running water and inhibiting bacteria.
Storage:
- Store the product in a cool, ventilated, and dry place.
- Avoid storing in areas with high temperatures, heavy pressure, or humid environments.
Troubleshooting
- Device automatically shuts down:
- This may indicate a low battery. Please charge the device in a timely manner to reactivate it.
- Device does not turn on:
- Ensure the device is fully charged. If it still doesn't turn on, try charging it for 1-2 hours. If the issue persists, contact customer support.
User Tips
- Upon receiving your product, carefully inspect it for any manufacturing defects or damage.
- Experiment with the 10 different vibration modes to find the settings that best suit your preferences.
- Always ensure the device is fully charged for optimal performance and consistent vibration strength.
Warranty and Support
For any questions, technical support, or warranty claims, please contact the seller or manufacturer directly. Keep your purchase receipt as proof of purchase.
For additional information, you may refer to the official user manual PDF: View User Manual (PDF)