1. Introduction
The Diymore KWS-303 is an advanced 8-in-1 energy meter designed for comprehensive monitoring of electrical parameters. Featuring a clear 0.96-inch TFT color screen and mobile remote control capabilities, it provides real-time data on voltage, current, power, frequency, power factor, active energy, timing, and temperature. Its standard rail slot mounting design ensures easy installation in various settings.
Video 1: KWS-303 Product Demonstration. This video showcases the meter's features, installation, and app connectivity.
2. Safety Information
- This product is suitable for indoor use only.
- This product is suitable for communication purposes.
- The measured voltage and current shall not exceed the calibration range of the device.
- Always ensure to connect the cables correctly according to the wiring diagram to prevent damage or electrical hazards.
- Installation should be performed by qualified personnel if you are unsure about electrical wiring.
3. Package Contents
- KWS-303 Power Meter: 1 unit
4. Product Overview
4.1 Key Features
- 0.96-inch TFT Color Screen: Wide viewing angle, clear readability even in dim environments.
- 8 Electric Parameters: Displays voltage, current, power, frequency, power factor, active energy, timing, and temperature simultaneously.
- Standard Rail Slot Mounting: Easy, screw-less installation with snap fastening.
- Mobile Phone Remote Control: Control and monitor the device from anywhere with a signal.
- Wide Application Range: Suitable for power distribution cabinets, factories, warehouses, offices, shopping malls, and homes.
- WIFI Version Timed Switch: Set multiple timed schedules for power on/off via mobile app.
4.2 Meter Components

Image 1: KWS-303 Function Introduction. Labels include: On-off state, Electric energy, Keep time, Power factor, Status display, WIFI ICON, Voltage, Electric current, Active power, Sensor temperature, Temperature sensing interface. Note: The RS485 interface area does not carry 485 communication.
5. Setup
5.1 Wiring Instructions
Follow these steps carefully to wire your KWS-303 energy meter:
- Ensure all power is turned off at the main circuit breaker before beginning any wiring.
- Connect the incoming Live (L) and Neutral (N) wires to the top terminals marked 'N' and 'L' respectively.
- Connect the load's Live (L) and Neutral (N) wires to the bottom terminals marked 'N' and 'L' respectively.
- Verify all connections are secure and correctly matched (Live to Live, Neutral to Neutral).

Image 2: KWS-303 Wiring Diagram. Shows input and exportation connections for both KWS-303WF and KWS-303 models. Ensure correct cable connection.
5.2 Mobile App Installation and Connection
To utilize the remote control and monitoring features, install the companion mobile app:
- Download App: Search for