1. Introduction
This manual provides detailed instructions for the installation, setup, and operation of your CARABC Wireless CarPlay and Android Auto Module. This module is designed to integrate seamlessly with compatible Ford vehicles equipped with the Sync2 system and an original 8-inch LCD screen.
2. Compatibility
2.1 Compatible Models Classification
The CARABC module is suitable for Ford models with the Sync2 system and an original 8-inch screen, including but not limited to:
- Ford Mondeo
- Ford Kuga
- Ford Focus
- Ford Taurus
- Ford Edge
- Ford Mustang
- Ford Explorer
- Ford C-max
- Ford Fiesta
- Ford F-150
- Ford Transit Connect
Compatible vehicles typically range from 2011-2016 model years.


2.2 Incompatible Models
The module is NOT compatible with:
- Vehicles with screens smaller than 8 inches.
- Vehicles equipped with the Sync 3 system.
- Vehicles with non-OEM Sync2 systems.
3. Setup and Installation
3.1 Accessories List
The product package includes the following components:

- CarPlay/Android Auto Module
- Power Cable
- CAN Cable
- USB Cable
- AUX Cable
- External Microphone
- PCB Board
- LVDS Cable
3.2 Dial Setup (DIP Switch)
The module features a toggle switch (DIP switch) for specific configurations. Refer to the table below for settings:
| Switch No. | Function | OFF Setting | ON Setting |
|---|---|---|---|
| 1 | Original Camera | ✓ | ✓ (if car has original camera) |
| 2 | ✓ | ||
| 3 | ✓ | ||
| 4 | ✓ | ||
| 5 | ✓ | ||
| 6 | ✓ | ||
| 7 | ✓ | ||
| 8 | ✓ |
Important Note: If your car has an original reversing camera, the status of DIP switch NO.1 must be set to "ON". For manual transmission cars with an original reversing camera, a cable needs to connect the brown reversing signal detection line of the device to the power supply line of the reversing lights. The manual gear dialling code is 1/5/7/8 ON.
3.3 PCB Board Installation
The PCB board needs to be installed onto the original FPC circuit board of the car. Ensure the ribbon cable and slot are neat and snapped correctly. The letters on the FPC cable should be facing upwards.
3.4 Cables Connection Chart
Follow the diagram below for proper cable connections. Ensure all cables are securely connected and not installed upside down or tilted.

3.5 CarPlay Box & Wi-Fi Antenna Installation
The CarPlay module can be installed inside the storage box in front of the passenger seat or other suitable locations within the vehicle. The Wi-Fi antenna is integrated into the module; ensure the module is not placed close to metal objects, as this can significantly degrade the Wi-Fi signal.
3.6 Microphone Installation
Install the external microphone in a suitable location, such as near the rearview mirror, for optimal voice pickup. Route the cable neatly to the module.
4. Operation
4.1 System Switching Method
The method to switch between the original car system and the CarPlay/Android Auto system varies by car model:
- Option 1: Long-press the