1. Introduction
This shark fin antenna is designed as a replacement or upgrade for your vehicle's original antenna. It serves to enhance FM/AM signal reception, reduce wind resistance, and provide a stylish decorative element to your car. The antenna is universal, waterproof, durable, and designed for easy installation without the need for drilling.
2. Safety Information
- Do not install while driving: Ensure the vehicle is stationary and safely parked before attempting installation.
- Avoid drilling or modification: Do not drill, modify, or force the antenna, as this may damage the car body or the vehicle's electrical system.
- Adhesive integrity: If the adhesive is damaged, do not use the product. Stop using immediately if the antenna becomes loose or falls off to prevent potential hazards.
- Environmental precautions: Keep the antenna away from high temperatures, fire, and corrosive liquids.
3. Package Contents
The package includes the following items:
- 1 x Car Shark Fin Antenna (with integrated receiver chip)
- 1 x Screw Bolt
- 1 x Screw Nut
4. Specifications
| Attribute | Value |
|---|---|
| Item Type | Aerials |
| Material | ABS Baking Varnish |
| Item Length | 17.1 cm (6.73") |
| Item Width | 7.5 cm (2.95") |
| Item Height | 6 cm (2.4") |
| Is Wireless | No |
| High-concerned chemical | None |
| Origin | Mainland China |
Available colors include Gold, Silver, Red, White, Blue, Black, and Gray.
5. Installation Instructions
Follow these steps for proper installation:
- Prepare the surface: Clean the installation area on the car roof thoroughly to remove any dust, oil, or wax. A clean, dry surface is crucial for proper adhesion.
- Prepare the antenna: Peel off the protective film from the double-sided adhesive tape located on the bottom of the shark fin antenna.
- Connect the signal wire: If your vehicle has an existing antenna base, connect the signal wire from the shark fin antenna to the screw bolt, then secure it with the screw nut onto the car's antenna base.
- Position and press: Carefully align the shark fin antenna to the desired position on the car roof. Once aligned, press firmly for 1 to 2 minutes to ensure strong adhesion.
- Curing time: Do not wash the car or expose the vehicle to heavy rain within 24 hours after installation. This allows the adhesive to fully cure and bond securely.
6. Usage and Maintenance
- Cleaning: Keep the antenna surface clean by wiping it with a soft cloth. Avoid using sharp or abrasive tools that could scratch the finish.
- Regular Checks: Regularly check if the antenna is firmly attached to the car roof to prevent it from falling off, especially after car washes or extreme weather conditions.
- Signal Enhancement: For optimal signal reception, ensure the antenna is installed on a flat, clean roof surface.
7. Troubleshooting
- Poor radio signal:
- Check if the antenna is installed correctly and securely. Ensure the signal wire is properly connected. Verify if the antenna is compatible with your vehicle's original antenna system.
- Antenna falls off:
- The installation surface may not have been clean enough, or the adhesive may have been compromised. Clean the surface thoroughly and reattach the antenna using new, strong adhesive tape.
- Surface scratches:
- For minor marks or scratches on the antenna's surface, use a mild coating restorer to polish and restore its appearance.
8. Compliance and Additional Information
This product bears the CE marking, indicating its compliance with the essential requirements of relevant EU directives, including safety, hygiene, and environmental protection standards for products entering the European market.
A detailed user manual in PDF format is available for download. Please refer to the seller's product page for the direct link to the PDF document.