1. Introduction
The AVATTO WT420-16A is an intelligent multi-scenario heating thermostat designed for precise temperature control in various heating systems. It is compatible with electric heating systems (heating cables, electric heating film, electric radiators) and water heating systems (electric actuators, valve drivers, circulating water pumps). This manual provides detailed instructions for installation, operation, and maintenance.

Figure 1: AVATTO WT420 Smart Thermostat and its mobile application interface. The thermostat supports integration with Amazon Alexa, Google Home, and AVATTO smart home systems.
2. Safety Information
- Installation must be carried out by a qualified electrician.
- All wiring must comply with local and national construction and electrical regulations and rules.
- Ensure power is disconnected before performing any installation or maintenance.
- Do not expose the device to water or excessive humidity.
3. Package Contents
- Intelligent temperature controller x1
- Underfloor heating temperature sensor x1 (Only equipped with electric heating models)
- Product manual x1
- Screw package x1
4. Product Overview
4.1. Physical Features and Dimensions

Figure 2: Product dimensions. The thermostat measures 86mm x 86mm (3.39in x 3.39in) with a thickness of 14mm (0.55in). The side profile shows a depth of 31mm (1.22in) and 51mm (2.01in) for the mounting box.
4.2. Display and Buttons
The thermostat features a clear digital display and intuitive controls.

Figure 3: Sliding Groove Adjustment. Press the top button to increase temperature, press the bottom button to lower temperature. Adjust temperature by sliding the groove up or down.
Button Description:
- Power Key: Short press to turn the device on/off. In Advanced Options, short press to save settings and exit. From powered-off state, press and hold to enter Advanced Options.
- Mode Key: Short press to switch modes. Press and hold for 3 seconds to activate child lock.
- Slider: Slide up and down to increment/decrement values.
Display Description:
| Icon | Description |
|---|---|
| Wi-Fi Icon | Constantly lit: successful networking. Flashing: adding network. Absent: network disconnection. |
| ECO Energy-saving Icon | Lights up to indicate activation of 'energy-saving mode' (APP sets range 10-20°C, default 16°C). |
| Manual Mode Icon | Lights up to indicate activation of 'manual mode'. |
| Programming Mode Icon | Lights up to indicate activation of 'programming mode'. |
| Heating Icon | Lights up to indicate 'heating output'. |
| Child Lock Icon | Lights up to indicate activation of 'child lock' function. |
5. Setup and Installation
5.1. Wiring Diagrams
Important: Ensure power is OFF before wiring. Consult a qualified electrician if unsure.
Electric Heating Wiring Diagram (Max 16A)

Figure 4: Wiring for Water/Gas Boiler systems. Connect L (Live) and N (Neutral) from 90-250V AC power supply. Connect L1 and N1 to the boiler control input. NTC sensor connects to the dedicated terminals.
General Wiring Notes:
- L: Live wire (Power input)
- N: Neutral wire (Power input)
- L1: Live wire (Load output)
- N1: Neutral wire (Load output)
- NTC: External temperature sensor (if applicable)
5.2. Physical Installation Steps
- Use a straight screwdriver to align with the buckle position and remove the display panel.
- Connect the wires according to the wiring diagram and fix the power supply part to the junction box with screws.
- Align the display surface shell with the power supply bottom shell and fasten it to the buckle position.
- Installation completed.
5.3. Mobile App Installation
- Scan the QR code (usually found in the quick start guide or product packaging) on your phone to download, install, and register the