Powallon YLS-F-Z2-606AT

Contents

Hydraulic Brake Power Cut Off Sensor Cable User Manual

Model: YLS-F-Z2-606AT

Brand: Powallon

1. Product Overview

This brake cut-off sensor is a safety control device for electric bicycles. Its core function is to immediately and reliably cut off the motor power output when the rider pulls the brake lever, ensuring brake priority, preventing conflict between motor power and braking force, and significantly improving riding safety. It is used for retrofitting and upgrading both mechanical brake levers (V-brake, disc brake) and hydraulic brake levers.

Powallon Hydraulic Brake Sensor Cable

Figure 1: Powallon Hydraulic Brake Sensor Cable with various connector views.

Modified vs Unmodified E-bike Braking

Figure 2: Comparison of e-bike braking without (Dangerous State) and with (Safe State) the brake cut-off sensor installed, highlighting enhanced safety.

2. Working Principle

The sensor contains an internal mechanical micro-switch. When the brake is applied, the displacement of a magnet triggers the switch action, pulling the output signal from a high level (e.g., 5V/12V) down to a low level (close to 0V). Upon receiving this low-level signal, the controller immediately interrupts power supply to the motor.

Brake Sensor Working Principle

Figure 3: Diagram illustrating the working principle: when the distance between the sensor and magnet is more than 5mm, the power is automatically cut off.

Millisecond Response of Brake Sensor

Figure 4: Illustration of the millisecond response, showing the sensor and magnet interaction leading to immediate power disconnection from the motor upon braking.

3. Setup (Installation & Wiring Guide)

3.1. Components & Interfaces

The product package includes the following main components:

  1. Sensor Body: Houses the core switch component.
  2. Trigger Magnet: Makes contact with the moving part of the brake lever.
  3. Mounting Adhesive: For securely mounting the trigger magnet in the designated position on the brake lever.
  4. Output Cable: Standard 2-wire system (Red wire: Signal positive (+), Black wire: Signal ground (GND)) or 3-wire system (adds a +5V power wire).

3.2. Step 1: Install the Sensor

  1. Power Off: Turn OFF the electric bicycle power and disconnect the battery before starting installation.
  2. Positioning: Secure the sensor body onto the brake lever mount. Fix the trigger magnet onto the brake lever. Important: Before finalizing, connect and power the sensor to test. Adjust the distance between the sensor and magnet to ensure the motor power is cut off immediately and reliably when the brake lever is pulled, and restores when released.
  3. Secure: Use the provided mounting adhesive and cable ties to firmly secure both the sensor body and the trigger magnet.

3.3. Step 2: Wiring (Core Steps)

  1. Locate Controller Interface: Find and connect to the brake terminals on the controller (common types are 2PIN or 3PIN).
  2. Connect Cables:
    • 2-Wire Connection (Most Common):
      • Sensor Red Wire → Controller's
Documents and downloads

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.