NOCCLILI Electric Pedicure Grinder

Contents

NOCCLILI Electric Pedicure Grinder User Manual

USB Portable Pedicure Grinder with 2 Removable Roller Heads - Electric Callus and Dead Skin Remover Foot File

1. Product Overview

The NOCCLILI Electric Pedicure Grinder is a portable, rechargeable device designed for exfoliating and caring for your feet by effectively removing calluses and dead skin. It features a powerful grinding wheel, an integrated flashlight for enhanced visibility, and comes with two types of roller heads for varied exfoliation needs.

Electric Foot Grinder with towels and brush
Figure 1: NOCCLILI Electric Foot Grinder

Components

Diagram of the foot grinder showing its components: Grinding wheel, Flashlight, Switch, Charging port.
Figure 2: Product Components Diagram
  • Grinding Wheel: The primary abrasive surface for exfoliation.
  • Flashlight: Provides illumination for precise use.
  • Switch: Controls power on/off and possibly speed settings.
  • Charging Port: USB port for recharging the device.

2. Safety Information

  • WARNING: Do not insert fingers or metal objects into the grinding wheel section, as this may cause damage to the motor or personal injury.
  • WARNING: Do not place this product within reach of children or use it as a toy, as it may cause injury to children.
  • WARNING: Do not leave the unit unattended while charging, as insulation deterioration may cause electric leakage or fire.
  • CAUTION: Do not store the unit in places where the ambient temperature is below 5℃ or above 35℃, in direct sunlight, near heat sources such as heating appliances or incandescent bulbs. This may shorten charging time, cause fire, electric shock, or product deformation.
  • CAUTION: The unit cannot be used while charging. It will operate normally only after charging is completed.

3. Setup

3.1 Initial Charge

  1. Before first use, fully charge the device using the provided USB cable.
  2. Connect the USB cable to the charging port on the device and to a suitable USB power source.
  3. The device will indicate charging status (e.g., an indicator light).
  4. Ensure the device is fully charged before use for optimal performance.

3.2 Attaching/Replacing Roller Heads

The device comes with two types of roller heads: a coarse head for tougher calluses and a fine head for smoothing. Refer to Figure 3 for visual instructions.

Pedicure tool with USB charging, illustrating the two roller heads (Coarse head, Fine head).
Figure 3: Two Roller Heads (Coarse and Fine)
  1. Ensure the device is turned off.
  2. To remove a roller head: Press the release button (usually near the top of the grinding wheel section) and pull out the grinding wheel.
  3. To attach a roller head: First, align the bottom of the roller head with the slot, then press the top part until it clicks securely into place.
Instructions for Grinding Wheel Replacement: Press the top and pull out the grinding wheel and Attach the bottom first, then press the head.
Figure 4: Grinding Wheel Replacement

4. Operating Instructions

  1. Select the appropriate roller head (coarse for heavy calluses, fine for gentle smoothing) and ensure it is securely attached.
  2. Turn on the device using the switch. The flashlight will also activate, providing better visibility of the treatment area.
  3. Gently glide the rotating roller head over the dry, hardened skin on your feet. Do not press too hard or stay in one area for too long, as this can cause irritation.
  4. Move the device in short, even strokes.
  5. Periodically check your skin to avoid over-exfoliation.
  6. After achieving the desired smoothness, turn off the device using the switch.
  7. Rinse your feet with water to remove any remaining dead skin particles.
  8. Apply a moisturizing cream to your feet for best results.

Note: The grinding wheel is designed for effective exfoliation. Do not press forcefully on its surface or strike it with hard objects, as this may cause damage to the roller head.

Product in use, showing different angles and a 'Before/After' comparison of feet.
Figure 5: Before and After using the Pedicure Grinder

5. Maintenance

5.1 Cleaning the Unit

  1. Ensure the device is turned off and disconnected from any charging cable.
  2. Remove the roller head.
  3. Use a cloth dampened with water and a neutral detergent, wrung dry, to wipe off dirt from the unit's body.
  4. Clean the roller head under running water or with a brush to remove dead skin particles. Allow it to air dry completely before reattaching or storing.
  5. IMPORTANT: Never use paint thinner or gasoline for cleaning, as they may cause damage to plastic parts, electric shock, or product deformation.

5.2 Storage

Store the device in a cool, dry place, away from direct sunlight and extreme temperatures (below 5℃ or above 35℃).

6. Troubleshooting

Device Not Operating Despite Battery Indication

  • If the screen displays a battery level but the unit does not operate normally, ensure the roller head is securely attached and the lid (if applicable) is tightened until it locks. A loose roller head or cover can prevent operation.
  • Ensure the device is not currently charging, as it is designed not to operate during charging.

Poor Performance

  • Check if the roller head is worn out. Replace it if necessary.
  • Ensure the device is fully charged.
  • Clean the roller head and the device thoroughly to remove any debris that might be hindering performance.

7. Specifications

Feature Detail
Brand Name NOCCLILI
Material ABS
Power Type Rechargeable
Voltage Global Universal (100-240V)
Origin Mainland China
Package Length 28 cm
Package Width 26 cm
Package Height 4 cm
Package Weight 0.16 kg

8. User Tips

  • For best results, use the pedicure grinder on dry feet.
  • Start with the coarse roller head for significant callus removal, then switch to the fine roller head for a smooth finish.
  • The built-in flashlight is useful for ensuring you don't miss any spots, especially in dimly lit areas.
  • Regularly clean the roller heads to maintain hygiene and effectiveness.
  • Always moisturize your feet after using the grinder to keep them soft and prevent new calluses from forming quickly.

9. Warranty and Support

For detailed warranty information or technical support, please refer to the official documentation or contact the seller/manufacturer directly.

A user manual in PDF format is available for download: View User Manual (PDF)

10. Frequently Asked Questions (FAQ)

Q: Can I use the device while it's charging?

A: No, the device is designed not to operate while charging. Please ensure it is fully charged before use.

Q: How do I know when to replace the roller head?

A: Replace the roller head when you notice a decrease in its exfoliating effectiveness or if it appears visibly worn.

Q: Is the device waterproof?

A: While the roller heads can be rinsed, the main unit should only be wiped with a damp cloth. Avoid submerging the device in water.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.