1. Warnings & Safety Information
⚠️ Keep this product out of reach of children under 14 years of age.
⚠️ Hot surfaces - Do not touch immediately after operation or shutdown. Risk of burns.
⚠️ Moving parts - Keep fingers and other body parts away. Risk of injury.
1.1 Safe Operation
- Power must be disconnected during installation/maintenance. Never touch components while energized to prevent electric shock/short circuits.
- Do not touch the fan blades while the fan is running. If you hear unusual noises or experience stuttering, immediately disconnect the power and inspect the unit.
- Avoid use in damp, high-temperature, or flammable/explosive environments to prevent short circuits.
1.2 Environmental Protection and Compliance
- Complies with EU RoHS (2011/65/EU) and its amendments, free from restricted substances. Compliance reports are available upon request.
- Complies with the LVD (2014/35/EU) and EMC (2014/30/EU) Directives. Do not modify the circuitry in a manner that compromises compliance.
2. Product Overview
The METALFISH DH510 is a low-profile CPU cooler designed for compact systems, featuring 6 heat pipes and a 9cm silent fan to provide efficient cooling up to 160W TDP.



2.1 Package Contents

Your package should contain:
- METALFISH DH510 CPU Cooler (with pre-attached fan)
- Intel Mounting Bracket
- AMD Mounting Bracket
- Mounting Screws and Standoffs
- Thermal Grease (12.8W/m.K)
3. Setup and Installation
- Prepare CPU and Motherboard: Ensure your CPU is properly seated in its socket. Clean the CPU surface with isopropyl alcohol to remove any old thermal paste or residue.
- Select Correct Bracket: Identify and attach the appropriate mounting bracket (Intel or AMD) to the cooler base using the provided screws.
- Apply Thermal Grease: Apply a small, pea-sized amount of the included thermal grease to the center of your CPU's integrated heat spreader (IHS).
- Prepare Cooler: Before placing the cooler, ensure you remove the protective film/sticker from the fan.
- Mount Cooler: Carefully align the cooler with the mounting holes on your motherboard. Place the cooler onto the CPU, ensuring even contact. Secure it by tightening the mounting screws in a diagonal pattern until snug. Do not overtighten.
- Connect Fan Cable: Locate the 4-pin PWM CPU_FAN header on your motherboard and connect the cooler's fan cable to it.
- Verify Installation: Double-check that the cooler is securely mounted and the fan cable is properly connected.



4. Operating Instructions
Once installed, the METALFISH DH510 CPU cooler operates automatically:
- The 4-pin PWM fan connector allows your motherboard to control the fan speed dynamically based on CPU temperature, ensuring optimal cooling and noise levels.
- Ensure your PC case has adequate airflow to help dissipate heat effectively.
5. Maintenance
- Dust Cleaning: Periodically (every 3-6 months, or as needed), use compressed air or a soft brush to clean dust from the heatsink fins and fan blades. Ensure the fan is not spinning while cleaning with compressed air.
- Fan Inspection: Check that the fan is free from obstructions and spins freely.
- Thermal Paste: While not frequently required, if you notice a significant increase in CPU temperatures over time, consider reapplying fresh thermal paste. This typically involves removing the cooler, cleaning old paste from the CPU and cooler base, and applying new paste.
6. Troubleshooting
6.1 High CPU Temperatures
- Thermal Paste: Ensure thermal paste was applied correctly and evenly.
- Cooler Seating: Verify the cooler is seated firmly and making full, even contact with the CPU's IHS.
- Fan Operation: Check if the fan is spinning. If not, refer to