1. Introduction
This manual provides comprehensive instructions for the installation, operation, maintenance, and troubleshooting of your GANGLE 433MHz Tire Pressure Monitoring System (TPMS) sensors. These sensors are designed as replacement or maintenance parts for motor vehicles equipped with a factory-installed TPMS. Proper installation and adherence to these instructions are crucial for the correct functioning of your vehicle's TPMS.

Figure 1: GANGLE 433MHz TPMS Sensors
2. Safety Information and Warnings
WARNING: Professional Installation Only.
Read all instructions and warnings thoroughly before installation. These TPMS sensor assemblies are replacement parts for vehicles that already have a factory-installed TPMS. Failure to follow installation instructions may lead to improper operation of the TPMS sensor.
CAUTION:
- Each TPMS sensor is designed to operate with specific motor vehicle makes, models, and years using the correct frequencies (433MHz) to communicate with the vehicle's TPM System. Only install sensors designated for your specific vehicle.
- Improper installation or the use of unauthorized sensors can cause the TPM System to fail.
- Do not install TPMS sensors in damaged wheels.
- After installation, test the TPM System using the original manufacturer's service guide to confirm proper installation. If the system fails, consult technical support or an authorized vehicle dealership.
- These sensors are designed for Original Equipment wheels and tires only. Using non-OE wheels/tires may affect TPM system function.
WARNING: Failure to follow installation instructions or the use of improper TPMS sensors may result in the motor vehicle TPM system failure, causing property damage, personal injury, or death.
3. Setup
3.1. Sensor Installation
This section details the removal of old sensors and installation of new ones. Refer to your vehicle's service manual for specific torque values and procedures.

Figure 2: Single GANGLE TPMS Sensor
Removal Procedure:
- Remove Valve Core: Deflate the tire by removing the valve core. Discard the old valve core.
- Remove Clamp-in Sensor: Remove the mounting nut from the stem, allowing the sensor to fall into the wheel/tire assembly. Discard the old nut.
- Break Tire Bead: Bounce the wheel/tire to ensure the sensor is free. Break the bead from the rim on the shallow side first, then the deep side.
- Sensor Inspection: Remove the sensor and inspect it. If reinstalling, clean it thoroughly.
Installation Procedure (Clamp-in Sensor):
- New Components: Always use a new grommet, mounting nut, special nickel-plated valve core, and sealing cap. Never reuse old components.
- Insert Sensor: Insert the sensor through the rim hole with the flat side facing the wheel.
- Tighten Nut: Tighten the mounting nut to the specified torque (refer to your vehicle's service guide).
- Tire Installation: Position the rim so the sensor is 90° or a quarter turn to the right of the mount/demount head. Liberally lubricate the tire beads. While the machine rotates, maintain pressure on the tire between the sensor's starting point and the mount/demount head to keep the bead in the wheel's drop center. This prevents damage to the sensor.
Valve Core Caution:
Do not reuse the removed valve core. Always replace with a new electroless nickel-plated valve core (aluminum stem). Using non-electroless nickel-plated cores with aluminum valve stems can cause galvanic corrosion and tire pressure loss. Tighten the core with an approved valve core tool to 0.23Nm - 0.56Nm (2 in-lbs. - 5 in-lbs.). Do not overtighten!
3.2. Vehicle Relearn Instruction
After sensor installation, the vehicle's TPMS needs to relearn the new sensors. Verify application fitment before starting.
Vehicle-Based Relearn Instructions:
- Activate the parking brake. Adjust tire pressures to the vehicle placard specifications.
- On the end of the wiper stalk, hold the RESET button until