Powallon Electric Bicycle Brake Cut-Off Sensor (Universal Type)

Contents

Powallon Electric Bicycle Brake Cut-Off Sensor

User Manual

Product Overview

The Powallon Electric Bicycle Brake Cut-Off Sensor is a safety control device designed for electric bicycles. Its primary function is to immediately and reliably cut off the motor power output when the rider pulls the brake lever. This ensures brake priority, preventing conflicts between motor power and braking force, thereby significantly enhancing riding safety. This sensor is suitable for retrofitting and upgrading both mechanical brake levers (V-brake, disc brake) and hydraulic brake levers.

Product Name: Electric Bicycle Brake Cut-Off Sensor (Universal Type)

Compatible Systems: Suitable for most brushless motor controllers using a low-level brake signal.

Safety Certifications: CE, RoHS

Powallon Electric Bicycle Brake Cut-Off Sensor

Figure 1: Powallon Electric Bicycle Brake Cut-Off Sensor (Universal Type)

Working Principle & Components

1. Working Principle

The sensor contains an internal mechanical micro-switch. When the brake is applied, the displacement of a magnet triggers the switch action. This pulls the output signal from a high level (e.g., 5V/12V) down to a low level (close to 0V). Upon receiving this low-level signal, the controller immediately interrupts power supply to the motor.

2. Component Diagram

Component Diagram of Brake Cut-Off Sensor

Figure 2: Sensor Components and Interfaces

  1. Sensor Body: Houses the core switch component.
  2. Trigger Magnet: Makes contact with the moving part of the brake lever.
  3. Mounting Adhesive: For securely mounting the trigger magnet in the designated position on the brake lever.
  4. Output Cable:
    • Standard 2-wire system: Red wire (Signal positive (+)), Black wire (Signal ground (GND)).
    • 3-wire system: Adds a +5V power wire.

Technical Specifications

Item Specification
Operating Voltage 5V - 48V DC (Wide-voltage design, compatible with most controllers)
Output Signal Normally Open (N.O.): High level at rest, low level when triggered
Response Time < 10ms
Protection Rating IP54 (Dust and splash water resistant)
Operating Temperature -20°C ~ +85°C
Service Life > 100,000 operations

Setup: Installation & Wiring Guide

Step 1: Install the Sensor

  1. Power Off: Turn OFF the electric bicycle power and disconnect the battery before starting installation.
  2. Positioning: Secure the sensor body onto the brake lever mount. Fix the trigger magnet onto the moving part of the brake lever.
  3. Pre-Test (Important): Before finalizing the mounting, connect and power the sensor to test its function. Adjust the distance between the sensor and magnet to ensure the motor power is cut off immediately and reliably when the brake lever is pulled, and restores when released.
  4. Secure: Use the provided mounting adhesive and cable ties to firmly secure both the sensor body and the trigger magnet in their optimal positions.
Brake Sensor Installation Example

Figure 3: Example of Sensor Installation on a Brake Lever

Step 2: Wiring (Core Steps)

  1. Locate Controller Interface: Find and connect to the brake terminals on your e-bike controller. Common types are 2PIN or 3PIN connectors.
  2. Connect Cables:

    2-Wire Connection (Most Common):

    • Sensor Red Wire: Connect to the controller's
Documents and downloads

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.