Instruction Manual

1. Important Safety Information & Warnings

Please read all instructions carefully before use. Failure to follow these warnings and instructions may result in product damage or minor injury.

• General Warning: Keep out of reach of small children and pets. This product is intended for decorative purposes and is not a toy.
• Intended Use: This product is designed for general household, bedroom, or classroom decoration. Any other use is considered improper and unsafe.
• Choking Hazard: This product contains small parts. Ensure it is applied securely and kept away from infants and toddlers who might attempt to peel and ingest it.
• Chemical Safety: The decal is safe under normal use. As a general precaution, wash hands after handling the decal, especially before eating.
• Physical Safety: Do not apply to surfaces that are frequently handled by small children if there is a risk of peeling and ingestion.
• Heat Warning: Do not expose the decal to excessive heat or open flames, as this may cause damage or discoloration.

2. Product Overview

These self-adhesive wall decals feature a charming mouse peeking from a hole, designed to add a whimsical touch to your home, bedroom, or classroom. They are easy to apply and remove, making them a versatile decorative element.

Figure 1: Self-Adhesive Irregular Shape Mouse Hole Decal

Figure 2: Decal applied to furniture in a room setting

3. Setup & Application

3.1 Before First Use

• Carefully remove all packaging materials.
• Inspect the decal for any damage. If damaged, do not apply and contact seller support.

3.2 Surface Preparation

For optimal adhesion and longevity, ensure the application surface is properly prepared:

• Clean: Wipe the surface with a damp cloth to remove dust, dirt, and grease. Allow it to dry completely.
• Dry: The surface must be completely dry before application.
• Smooth: Decals adhere best to smooth, non-porous surfaces such as painted walls, glass, metal, or smooth furniture. Avoid applying to textured, uneven, or freshly painted surfaces (wait at least 2-3 weeks after painting).

3.3 Application Steps

1. Position: Carefully plan where you want to place the decal. You can temporarily hold it against the surface to visualize the placement.
2. Peel: Slowly peel a small section of the backing paper from one corner of the decal. Avoid touching the adhesive side.
3. Apply: Align the exposed adhesive edge to your desired position on the surface. Gently press it down.
4. Smooth: Gradually peel off the rest of the backing paper while simultaneously smoothing the decal onto the surface with your hand or a soft cloth. Work from the center outwards to remove any air bubbles.
5. Final Press: Once fully applied, firmly press over the entire decal to ensure good adhesion, paying attention to the edges.

4. Operating Instructions

Once applied, the decal serves its decorative purpose. No further operation is required. Enjoy the enhanced aesthetic of your space.

5. Cleaning & Maintenance

To keep your decal looking its best:

• Cleaning: Gently wipe the surface of the decal with a soft, slightly damp cloth. A mild, non-abrasive detergent can be used for stubborn stains, but test on an inconspicuous area first.
• Drying: Dry thoroughly with a clean, soft cloth.
• Avoid: Do not use abrasive powders, scouring pads, steel wool, bleach, or harsh chemical cleaners, as these will damage the decal's surface and finish.

6. Troubleshooting

• Decal Not Sticking Well: Ensure the surface was clean, dry, and smooth before application. Residue or texture can prevent proper adhesion.
• Air Bubbles Under Decal: If bubbles appear, gently try to smooth them out towards the nearest edge with your finger or a soft cloth. For persistent bubbles, you can carefully prick them with a fine needle and then smooth the area.
• Decal Damaged During Application: Apply slowly and carefully. If the decal tears or creases, it may be difficult to fully repair.
• Difficulty Removing Decal: Gently peel the decal from a corner. If it resists, you can use a hairdryer on a low setting to slightly warm the decal, which may soften the adhesive for easier removal.

7. Specifications

7.1 Decal Dimensions (Approximate, per design)

Figure 3: Mouse in Doorway Design (approx. 9.14 cm H x 6.86 cm W)

Figure 4: Mouse Peeking from Roundish Hole Design (approx. 10.7 cm H x 12 cm W)

Figure 5: Mouse Peeking from Irregular Hole Design (approx. 11.5 cm H x 11.5 cm W)

8. User Tips

• Creative Placement: These decals are versatile! Consider placing them near baseboards, behind furniture, or peeking out from corners for a playful effect.
• Smooth Application: Take your time during application to ensure a smooth, bubble-free finish. A credit card wrapped in a soft cloth can help smooth out the decal.
• Temporary Fun: Since they are self-adhesive and generally removable, feel free to experiment with different placements or use them for temporary decorations for parties or events.

9. Warranty & Support

This product is a decorative item. For specific warranty information, please refer to the seller's policies at the time of purchase. If you encounter any issues or have questions not covered in this manual, please contact the seller directly through your purchase platform.

A detailed user manual in PDF format may also be available for download from the seller's product page: View User Manual (PDF)