1. Functions & Features
The Anytone AT-778UV Mobile Radio is designed for drivers, offering robust performance, stability, and a range of advanced features. It combines innovation with practicality for an optimal user experience.
Key Features:
- Superior quality materials and technology for stable and durable operation.
- 180-degree rotatable TFT LCD display for versatile viewing.
- Full alloy body for efficient heat radiation.
- Amateur and professional modes to suit different operational needs.
- Reasonably distributed buttons for convenient operation.
- Separate bandwidth settings for each channel: Wide (25K), Middle (20K), Narrow (12.5K).
- 200 programmable memory channels with editable names.
- Separate CTCSS, DCS, DTMF, and 5Tone settings per channel to reject unwanted calls.
- Various scan functions, including CTCSS/DCS Scan.
- Smart menu control and PC programming capabilities.
- Voltage level protection.
- LCD brightness control.
- Automatic power-on function.
- Main unit and microphone key lock function.
- 5Tone signaling for data transfer, alarm, all call, ANI, remote kill, and remote wake-up.
- DTMF-ANI or 5Tone-ANI for automatic calling recognition.
- Optional Scrambler.
Product Overview:
Video: Anytone AT-778UV Unboxing and User Interface Demonstration.

Image: Anytone AT-778UV Mobile Radio displaying 'Relay Pilot Frequency' settings.
2. Setup
2.1 Mobile Installation
Choose a safe and convenient location in your vehicle that minimizes obstruction and ensures good ventilation. Avoid direct sunlight.
- Install the mounting bracket using the supplied self-tapping screws (2pcs) and flat washers (2pcs). The bracket is a flat metal strip with multiple holes for secure attachment.
- Position the transceiver and secure it with the supplied hexagon SEMS screws. Ensure all screws are tightened to prevent vibration.
2.2 DC Power Cable Connection
The transceiver requires a 12V DC power source. Do not connect to a 24V battery.
- Route the DC power cable directly to the vehicle's battery terminals, using the shortest possible path. Avoid using the cigarette lighter socket due to potential voltage drops.
- Ensure the cable is isolated from heat, moisture, and engine ignition systems.
- After installation, use heat-resistant tape to secure the cable with the fuse box.
- Connect the red wire to the positive (+) terminal and the black wire to the negative (-) terminal. Use the full length of the cable and do not remove the fuse holders.
- Reconnect any wiring removed from the negative terminal.
- Connect the DC power cable to the transceiver's power supply connector, pressing firmly until the locking tab clicks.
2.3 Replacing Fuses
If a fuse blows, identify and correct the cause before replacing it. If new fuses continue to blow, disconnect the power cable and contact an authorized AnyTone service center.
| Fuse Location | Fuse Current Rating |
|---|---|
| Transceiver | 10A |
| Supplied Accessory DC power cable | 10A |
Note: Only use fuses of the specified type and rating to prevent damage to the transceiver.
2.4 Antenna Connection
Install an efficient, well-tuned 50 Ohm impedance antenna with a low-loss coaxial feed-line. Always connect the antenna to the transceiver before transmitting to prevent damage. Fixed stations should use a lightning arrester.
2.5 External Speaker Connection
If using an external speaker, choose one with an 8 Ohm impedance. The external speaker jack accepts a 3.5mm (1/8") mono (2-conductor) plug. Ensure the speaker is not connected to ground, as this can cause faults.
2.6 Microphone Connection
Connect the microphone's 8-pin modular plug into the modular socket on the front of the main unit. Press firmly until it clicks into place.
2.7 Programming Software Installation
To program the radio via PC:
- Install the