1. Introduction
Thank you for choosing the diymore LED Battery Level Indicator. This device provides a clear, real-time display of your battery's voltage and remaining capacity. It is compatible with a wide range of battery types, including Ternary Lithium, Lithium Iron Phosphate, and Lead-Acid batteries, making it suitable for various applications such as electric vehicles and energy storage systems. This manual will guide you through the setup, operation, and maintenance of your new battery monitor.
2. Safety Information
- Ensure correct polarity when connecting the device to avoid damage.
- Do not exceed the specified voltage measurement range (DC 7-55V).
- Keep the device away from water, moisture, and extreme temperatures.
- Do not attempt to disassemble or modify the device, as this will void any potential support.
- Handle with care to prevent physical damage.
3. Package Contents
- 1x LED Battery Level Indicator Board (Model JX-4615N-A2)
4. Product Overview
The JX-4615N-A2 features a high-brightness LED display showing real-time voltage and a battery capacity bar. It includes a 'TEST' button for operation and settings.

Figure 1: Front and Back View of the Battery Monitor

Figure 2: Product Dimensions
5. Setup (Wiring)
The battery monitor requires a simple two-wire connection to your battery system.
- Identify the VCC+ terminal (positive input) and GND- terminal (negative input) on the back of the module.
- Connect the positive lead from your battery to the VCC+ terminal.
- Connect the negative lead from your battery to the GND- terminal.
- Ensure connections are secure and correct polarity is observed.

Figure 3: Wiring Connections
6. Operating Instructions
The device is operated using a single 'TEST' button. Upon first power-on, the device defaults to Ternary Lithium L03S voltage (L03).
6.1 Button Functions

Figure 4: Button Description
- Brief Press: On the normal display page, briefly press the button to turn the display on and off.
- Press and Hold (2 Seconds): On the normal display page, press and hold the button for 2 seconds to enter the settings page.
6.2 Battery Type Settings
To ensure accurate readings, you must configure the monitor for your specific battery type and string count/voltage.
- Enter Settings Page: Press and hold the 'TEST' button for 2 seconds from the main display page.
- Navigate Settings: Briefly press the 'TEST' button to cycle through different setting modes (e.g., Ternary Lithium, Lithium Iron Phosphate, Lead-Acid, Backlight).
6.2.1 Ternary Lithium Battery (L Measurement: L03 to L12)

Figure 5: Ternary Lithium Battery Setting
- On the Ternary Lithium battery (L03) settings page, press and hold the button for 2 seconds until the battery string number flashes (e.g.,