Introduction
This manual provides instructions for the safe and effective use of the Lead-free Soldering Paste Sn99Ag0.3Cu0.7. This high-temperature, no-clean solder paste flux is designed for Surface Mount Device (SMD) welding, component repair, and various electronic applications. It features stable performance, good moisture retention, and stable welding characteristics, making it suitable for professional and hobbyist use.

Setup
- Preparation: Before each use, stir the solder paste evenly to ensure a consistent mixture. This helps maintain its moderate consistency and sparse density for optimal application.
- Application: Attach a suitable needle to the syringe.

Operating Instructions
- Apply Solder Paste: Apply a proper amount of solder paste directly onto the solder spots or pads of the component or circuit board.
- Position Component: Carefully place the component onto the applied solder paste, ensuring correct alignment.
- Heat to Solder: Heat the solder spots with a soldering iron or hot air gun until the solder paste melts and forms a strong, stable connection. The melting point of this paste is 227 ℃.

Applications
This solder paste is suitable for a wide range of uses, including:
- Mobile Phone Repair
- Lighting
- Motherboards
- Home Appliance Repair
- BGA chip tinning
- Computer component repair
- Sensors, wires, motors, fuse connecting wires, metal shells, and other electronic components.

Maintenance and Storage
- Store the solder paste in a cool and dry place to maintain its consistency and effectiveness.
- Ensure the cap is tightly sealed after each use to prevent drying out.
- The paste is designed to be no-clean, meaning it leaves low residue that typically does not require post-soldering cleanup.

Troubleshooting
- Poor Solder Joints: Ensure the surface is clean and free of contaminants. Verify that the soldering iron or hot air gun temperature reaches the paste's melting point (227 ℃).
- Paste Drying Out: Always stir the paste thoroughly before use. If the paste appears too dry, ensure it has been stored in a cool, dry environment with the cap tightly sealed.
- Excessive Residue: While designed as 'no-clean', if excessive residue is observed, ensure proper heating and application techniques are followed.
Specifications
| Feature | Detail |
|---|---|
| Composition | Sn99Ag0.3Cu0.7 (Lead-free) |
| Melting Point | 227 ℃ |
| Type | No Clean Solder Paste Flux |
| Particle Size (Mesh) | 20µm-38µm |
| High-concerned chemical | None |
| Origin | Mainland China |
| Available Weights | 15g, 30g, 50g |
| Package Dimensions (approx.) | Length: 5 cm, Width: 5 cm, Height: 5 cm |
| Package Weight (approx.) | 0.03 kg |
User Tips
- For fine pitch components, use the smallest needle tip available to ensure precise application and prevent bridging.
- When using a hot air gun, apply heat evenly and gradually increase temperature to avoid thermal shock to components.
- The 'no-clean' feature significantly reduces post-soldering work, but for critical applications, a quick inspection for any stray residue is always recommended.
Safety Warnings
- Keep away from children under 12 years old and pets.
- Avoid contact with eyes and skin. In case of contact, rinse immediately with plenty of water.
- Use in a well-ventilated area to avoid inhaling fumes.
- Always wear appropriate personal protective equipment, such as safety glasses and gloves, when handling solder paste and performing soldering operations.
Warranty and Support
For any questions regarding the product, technical support, or warranty information, please contact the seller, QUATO Shop Store, directly through your purchase platform. Additional item guides and documents, including a user manual in PDF format, may be available for download from the product page: User manual (PDF).