Introduction
This manual provides comprehensive instructions for the installation, operation, maintenance, and troubleshooting of your ESSGOO 7-inch Universal Car Radio. Please read this manual thoroughly before using the product to ensure proper operation and to prevent damage.

Figure 1: ESSGOO 7-inch Universal Car Radio with Android 14 interface and key features.
1. Setup and Installation
1.1 Important Tips and Warnings
- This machine is suitable for vehicle 12V power supply systems (grounding wire is required). Do not install this machine in 24V vehicles, as it will cause damage.
- Do not repair the power fuse without professional guidance. Improper use of the fuse can cause damage or fire.
- To avoid violating traffic rules, drivers must not watch videos or operate the machine while driving.
- For safety, invite professionals to install, disassemble, or repair the machine.
- Avoid placing this product in humid environments or near water to prevent electric shock or fire.
- Note: To prevent burning out the machine, do not energize until you have connected the power cord correctly!
- The product contains small parts. Keep out of reach of children to prevent swallowing!
1.2 Pre-Installation Test
Before full installation, perform a quick test to confirm the device is working correctly:
- Combine the red and yellow wires of the car stereo and connect them to the positive pole of a 12V battery.
- Connect the black wire to the negative pole of the battery.
- After 2 seconds, check if the car stereo screen lights up. If it does, the car stereo is functioning properly.
1.3 Installation Methods
There are three common ways to install the unit. Choose the method that best suits your vehicle's dashboard configuration. You may also re-install the new radio using the method of your original car radio.

Figure 2: Installation methods for the car radio.
- Screw-fixed installation
- Card position fixed installation
- Special frame fixed installation
1.4 Wiring Diagram
Proper wiring is crucial for the functionality of your car radio. Refer to the diagrams below for connecting the main harness and rear interfaces.
1.4.1 Main Harness Connections
Refer to the