Introduction
This manual provides detailed instructions for the installation, operation, and maintenance of your ICANING 150Mbps USB WiFi Adapter. Please read this guide thoroughly before using the device to ensure proper setup and optimal performance.
Figure 1: ICANING 150Mbps USB WiFi Adapter in a typical network setup.
Setup
1. Hardware Installation
There are two primary methods for installing your USB WiFi adapter:
- Direct Plug-in: Insert the network card directly into an available USB port on your computer (laptop or desktop).
- Using a USB Extension Cable Base: Connect the USB WiFi adapter to your computer via a USB extension cable base. This base needs to be purchased separately.
Note for Desktop Users:
When using a desktop computer, it is highly recommended to use a USB extension cable base. Connect the extension cable to a USB port on the rear of your computer case. This is because many front USB ports on desktop computers may have insufficient power supply or may not function optimally. Extending the connection to your desktop provides better accessibility and performance.
Figure 2: Hardware Installation Diagram. The diagram shows two methods: 1) The USB WiFi adapter plugged directly into a laptop or desktop USB port. 2) The USB WiFi adapter connected to a USB extension hub, which is then connected to a laptop or desktop.
2. Driver Installation
The software installation process is similar for Windows 10 and Windows 11 operating systems. The following steps use Windows 10 as an example:
- Insert the USB WiFi adapter into a USB 3.0 port on your computer.
- Open 'This PC' or 'My Computer'. A new drive labeled