1. Introduction
This manual provides comprehensive instructions for the installation, operation, and maintenance of your IRALAN Lighting Transformer Kit. This kit is designed to power and control LED light strips, typically used in lotus fan lights or petal-style lighting fixtures, offering power dimming and remote control capabilities. Please read this manual thoroughly before installation and use to ensure safe and optimal performance.
2. Safety Information
- Always disconnect power at the circuit breaker before installing, servicing, or cleaning the unit.
- Ensure all electrical connections comply with local codes and ordinances.
- Do not install in wet locations or areas with high humidity.
- This product is designed for indoor use only.
- Do not attempt to modify the product. Any modifications may void the warranty and pose a safety risk.
- Keep the remote control and controller away from water and extreme temperatures.
- If you are unsure about any part of the installation, consult a qualified electrician.
3. Package Contents
Your IRALAN Lighting Transformer Kit typically includes the following components:
- Fan Light Controller (Driver) - (e.g., 340mA or 550mA version)
- Remote Control
- LED Light Strips (quantity may vary based on specific model, e.g., 2 or 5 strips)
- Lotus Fan Light / Petal Light Fixture (main unit, if purchased as a complete set)
4. Specifications
| Attribute | Value |
|---|---|
| Model Number | FX4-1 |
| Item Type | Lighting Transformers |
| Nominal Voltage (Product) | 120V-240V |
| Controller Input Voltage | AC85-265V 50/60Hz |
| Controller LED Output | 72-90V (340mA or 550mA, depending on model) |
| Controller Motor Output | DC 24V Max: 30W |
| Certification | CCC, CE |
| Weight (Transformer) | 0.2kg |
| Origin | Mainland China |
| Features | Lighting, Power Dimming, Remote Control |
5. Setup
Before proceeding with installation, ensure power is disconnected at the main circuit breaker.
5.1. Controller Wiring
The fan light controller (driver) connects to your main power supply, the LED light strips, and the fan motor (if applicable). Refer to the diagrams below for proper wiring connections.
- Connect the Live (L) and Neutral (N) wires from your household electrical supply to the corresponding 'L' and 'N' terminals on the controller.
- Connect the LED light strips to the 'LED' output terminals on the controller. Ensure correct polarity if indicated.
- If your fixture includes a fan, connect the fan motor wires to the 'Motor Output' terminals.
- Secure all connections properly.
5.2. LED Light Strip Installation
Carefully attach the LED light strips to the designated areas within your lotus fan light or petal light fixture. Ensure they are securely fastened and that all connectors are properly seated.
5.3. Remote Control Pairing
Note: Pairing between the remote control and the controller has typically been completed at the factory. No additional pairing operation is usually required for initial use.
If re-pairing is necessary (e.g., after replacing a controller or remote):
- Turn off the light fixture at the main power switch.
- Turn the light fixture back on. Within 5 seconds of turning it on, press the 'pairing button' on the remote control (often indicated by a Wi-Fi-like symbol or a specific pairing icon).
- A successful pairing will be indicated by the light source flashing or a