SUPERFIRE HL77-C

Contents

SUPERFIRE HL77-C Zoomable LED Headlamp

User Instruction Manual

Introduction

Dear valued customer, thank you for purchasing the SUPERFIRE HL77-C Zoomable LED Headlamp. This manual provides important information regarding the setup, operation, maintenance, and troubleshooting of your new headlamp. Please read and understand this manual thoroughly before using the product to ensure safe and efficient operation.

A detailed user manual is also available in PDF format: View User Manual (PDF)

What's in the Box

The SUPERFIRE HL77-C package typically includes:

  • 1x Package Box
  • 1x HL77-C Headlamp
  • 1x Type-C Charging Cable
  • 2x 18650 Batteries
SUPERFIRE HL77-C Headlamp and its packaging contents
Image: Contents of the SUPERFIRE HL77-C package.

Setup Instructions

1. Battery Installation

  1. The HL77-C headlamp uses 18650 lithium batteries.
  2. Install the batteries in the correct direction: ensure the '+' (positive) end aligns with the positive terminal and the '-' (negative) end aligns with the negative terminal inside the battery compartment.

2. Charging the Headlamp

  1. Upon receiving the headlamp, it is recommended to fully charge it before first use.
  2. Connect the provided Type-C charging cable to the headlamp's charging port and to a 5V/1A charger. Using a charger with different specifications may prevent normal charging.
  3. During charging, the indicator light will be red.
  4. Once fully charged, the indicator light will turn blue.
  5. Charging typically takes about 3 hours.
Type-C charging port and battery indicator lights
Image: Type-C charging port and indicator lights (Red for charging, Blue for fully charged) with 18650 batteries.

Operating Instructions

1. Power On/Off and Lighting Modes

  1. Press the main power switch button to turn on the headlamp in the strong light mode.
  2. Continue pressing the switch button to cycle through the 5 lighting modes: Strong Light > Medium Light > Weak Light > Strobe > SOS > Off.
Diagram of 5 lighting modes: Low, Medium, High, Strobe, SOS
Image: Visual representation of the 5 available lighting modes.

2. Motion Sensor Switch

  1. To activate the motion sensor mode, press and hold the sensor switch (located near the main switch) for approximately 2 seconds. The induction indicator light will illuminate.
  2. Once activated, you can switch the light ON/OFF by waving your hand within 15cm of the sensor probe.
  3. To exit motion sensor mode, press and hold the sensor switch again for 2 seconds.
Hand waving to activate motion sensor switch
Image: Demonstrating the motion sensor switch functionality by waving a hand.

3. Zoomable Function

The headlamp features a zoomable function, allowing you to adjust the focus from a wide floodlight to a concentrated spotlight as desired. This is typically achieved by stretching or rotating the head of the flashlight.

Zoom In and Zoom Out functionality of the headlamp
Image: Examples of the headlamp's zoomable function, showing floodlight and spotlight.

4. Adjustable Angle

The headlamp's irradiation angle can be adjusted between 0 and 90 degrees. This allows you to direct the light precisely where needed for various activities.

Diagram showing 90 degree adjustable angle of the headlamp
Image: Illustration of the headlamp's 90-degree adjustable angle.

Maintenance

  • Battery Care: If the headlamp is not used for an extended period, recharge and discharge the battery every 3 months to maintain its condition. Recharge the battery promptly when the indicator light shows low power (flashing red).
  • Cleaning: To prevent damage to the headlamp's surface, avoid constant exposure to direct sunlight, water, chemicals, corrosive gases, or any other oxidizing environments.
  • Storage: Keep the battery away from water, moisture, and drops.

Troubleshooting

  • Overheating: It is normal for the headlamp to become slightly warm during prolonged use.
  • Eye Safety: Never shine the powerful LED light directly into eyes, as it can cause immediate eye damage.
  • Charging Issues: If the headlamp does not charge normally, ensure you are using a 5V/1A charger. If issues persist, contact customer service.
  • Power On Issues: If the flashlight cannot be turned on, ensure the batteries are correctly installed and charged. If problems continue, please contact customer service for assistance.

Specifications

Feature Specification
ModelHL77-C
Power3W
Lumen220LM
Color Temperature9400K
Lighting Modes5 Modes (Strong, Medium, Weak, Strobe, SOS)
Charging Interface TypeType-C
Max Lighting DistanceAbout 400M
RuntimeAbout 3.5H
Charging TimeAbout 3H
Charger Input5V/1A
Battery Type18650/1600mAh Lithium Ion
Waterproof RatingIP43
MaterialAluminum Alloy + ABS
Weight105g
Product Size80*90*86mm (3.15*3.54*3.39 in)
Induction FunctionYes
Nominal Voltage3.7 V
Beam Angle60°
Light SourceLED bulbs
CertificationCE

User Tips

  • For optimal performance, always use the recommended 5V/1A charger for charging.
  • Utilize the motion sensor feature for hands-free operation, especially when your hands are occupied or dirty.
  • Adjust the zoom function to switch between a wide floodlight for general illumination and a focused spotlight for long-distance viewing.
  • Take advantage of the 90° adjustable angle to direct light precisely for various tasks like camping, hiking, or working in dark spaces.

Frequently Asked Questions (FAQ)

Q: How do I activate the motion sensor?
A: Press and hold the dedicated sensor switch for about 2 seconds. The induction indicator light will turn on. Wave your hand within 15cm of the sensor to toggle the light.
Q: What type of battery does the HL77-C use?
A: It uses 18650 lithium-ion batteries (1600mAh capacity).
Q: Is the headlamp waterproof?
A: Yes, the HL77-C has an IP43 waterproof rating, making it resistant to splashes and light rain.
Q: How long does it take to fully charge?
A: Approximately 3 hours with a 5V/1A charger.

Warranty and Support

This product comes with a 1-year manufacturer's warranty. We also offer free technical support and spare parts. If you encounter any issues with your product, please contact customer service within 3 days of receipt, providing clear photos or videos of the problem.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.