Dfiolk FLXDL1200

Contents

Dfiolk IP65 Waterproof LED Lawn Light User Manual

Model: FLXDL1200

Introduction

Thank you for purchasing the Dfiolk IP65 Waterproof LED Lawn Light. This manual provides essential information for the safe and efficient installation, operation, and maintenance of your new lawn light. Please read this manual thoroughly before installation and retain it for future reference.

Two Dfiolk LED lawn lights illuminating a garden path at night.

Figure 1: Dfiolk LED Lawn Lights in a garden setting.

Safety Instructions

  • Always disconnect power before installation, maintenance, or cleaning.
  • Ensure the voltage supply matches the product specifications (85-265V AC). Do not connect to 380V.
  • This product is designed for outdoor use with an IP65 rating, ensuring protection against dust and water jets.
  • Do not use corrosive liquids to clean the lamp.
  • Please test the light before installation to ensure it is working properly. Install only if safety is guaranteed.
  • Installation should be performed by a qualified electrician if you are unsure about electrical wiring.

Setup and Installation

The Dfiolk LED Lawn Light is a self-contained unit designed for easy outdoor installation.

  1. Unpack: Carefully remove the lawn light from its packaging and inspect for any damage.
  2. Test Functionality: Before permanent installation, connect the light to a suitable power source (85-265V AC) to ensure it functions correctly.
  3. Choose Location: Select a desired location for your lawn light. Ensure the ground is stable and level to provide a secure base for the fixture.
  4. Prepare Wiring: Ensure the power supply cable is safely routed to the installation point. All electrical connections must comply with local electrical codes.
  5. Mount the Fixture: Secure the base of the lawn light to the ground using appropriate fasteners (not always included, depending on the model's base design). Ensure the fixture is stable and upright.
  6. Connect Power: Connect the light's power wires to your main power supply. Ensure all connections are secure and properly insulated to prevent water ingress, especially for outdoor use.
  7. Final Check: Once installed and wired, turn on the power to verify the light operates as expected.

Important: Connect the lamp to 110V/220V voltage. Do not use 380V voltage.

Operating Instructions

The Dfiolk LED Lawn Light operates by connecting to an external power switch. It is not dimmable.

  • Power On: Flip the external switch connected to the light's power supply to the "ON" position.
  • Power Off: Flip the external switch to the "OFF" position to turn off the light.

Maintenance

Regular maintenance will ensure the longevity and optimal performance of your lawn light.

  • Cleaning: Periodically clean the exterior of the lamp with a soft, damp cloth. Ensure the power is off before cleaning. Do not use abrasive cleaners or corrosive liquids, as these can damage the finish or internal components.
  • Stability Check: Occasionally check that the lamp remains stable and securely mounted. Re-tighten any fasteners if necessary.
  • Electrical Connections: Periodically inspect visible electrical connections for any signs of wear or damage. Ensure they remain sealed and protected from moisture.

Troubleshooting

If your Dfiolk LED Lawn Light is not functioning as expected, please refer to the following common issues and solutions:

ProblemPossible CauseSolution
Light does not turn on.No power supply.
Loose electrical connection.
Faulty external switch.
Check if the power supply is active.
Verify all electrical connections are secure (power off first).
Test the external switch or replace it if necessary.
Light flickers.Unstable power supply.
Loose connection.
Ensure a stable power source.
Check and secure all electrical connections (power off first).

If the problem persists after trying these solutions, please contact customer support.

Specifications

Product specifications diagram showing dimensions for 75cm and 125cm models of the lawn light.

Figure 2: Product Dimensions and Specifications.

FeatureDescription
Product NameLED Lawn Light
Model NumberFLXDL1200
BrandDfiolk
Light SourceLED Bulbs (Included)
Voltage85-265V AC
Power SourceAC
Protection LevelIP65 (Waterproof)
Body MaterialStainless Steel
Luminous Flux249-2000 Lumens
DimmableNo
Installation MethodSelf-contained
StyleContemporary
CertificationsCE, CCC, CQC, EMC, FCC, GS, LVD, pse, RoHS, SAA, UL, VDE
OriginMainland China
Warranty2 Years

Available Variants:

VariantHeightPowerTop DiameterBase DiameterColor Temperature
Standard75 cm20 W8 cm12 cmWarm White / Cold White
Tall125 cm40 W8 cm12 cmWarm White / Cold White

User Tips

  • For optimal illumination, consider the height of the light relative to the area you wish to illuminate. Taller lights (125cm) are suitable for larger areas or to provide more widespread light, while standard lights (75cm) are ideal for pathways and accent lighting.
  • Choose between Warm White for a cozy, inviting ambiance or Cold White for a brighter, more modern look, depending on your landscape design.
  • Ensure the light is installed in a location where it won't be easily damaged by garden equipment or foot traffic.

Warranty and Support

Your Dfiolk LED Lawn Light comes with a 2-year warranty from the date of purchase, covering manufacturing defects.

Manufacturer Information:

Manufacturer: Shenzhen Qiheng Power Supply Co., Ltd
Address: uangdongsheng shenzhenshi baoan xiqujieweiyuanhuixinandiergongye12haolou
Telephone: +86 15018027687

EU Authorized Representative:

Responsible Person: Sophie Dupont
Address: bis rue Abel 75012 Paris, France
Telephone: +34910602659
Email: SophieDupont@proconseilfr.cc

For detailed warranty terms or further assistance, please refer to the complete user manual available at: User Manual (PDF) or contact the manufacturer/representative directly.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.