1. Introduction
Thank you for choosing the BEISHI Full Motion TV Wall Mount Bracket. This manual provides essential information for safe installation, operation, and maintenance of your TV wall mount. Please read it thoroughly before installation and keep it for future reference.
This TV wall mount is designed to securely hold 32-70 inch televisions, offering full motion capabilities including swivel and tilt, with a maximum VESA compatibility of 600x400mm and a load capacity of 35kg.
2. Safety Precautions
WARNING: Improper assembly or installation may result in serious injury, death, or property damage. Please read all instructions and warning information carefully before assembling or installing.
- This mount is only suitable for solid load-bearing walls. Special walls such as hollow walls and foam walls must be reinforced.
- We recommend that this product be installed by a professional installer.
- If you have any questions or confusion about the installation information, please contact the seller for assistance.
- Do not assemble or install if the product or any accessories are damaged or missing. Contact your local dealer for replacement parts.
- Do not use this product for purposes other than its intended use.
- This product contains sliding parts; handle with care for safety reasons.
- May pose a danger of room rest. Keep out of reach of infants.
- For safety reasons, inspect the product regularly (recommended at least every three months).
- The manufacturer is not liable for any damage or injury caused by product modification, improper installation, or installation exceeding the product's specifications.
3. Package Contents
Please verify that all components are present and undamaged before installation.
Tools Required:
- Spirit level
- Steel tape
- Phillips screw driver
- Marking pencil
- Socket wrench
- Electric drill
- Wrench
- M10 drill bit
Mounting Accessories:
- Hook (x2)
- Bracket body (x1)
- M8X65mm screws (x4)
- M10X60mm screws (x6)
- D6 gaskets (x4)
- D5 gaskets (x4)
- M6X25mm screws (x4)
- M4X25mm screws (x4)
- M5X40mm screws (x2)
- Level (x1)
- 15mm height-enhancing pads (x4)
- M6X15mm screws (x4)
- M4X15mm screws (x4)
- Wrench (x1)
4. Specifications
| Feature | Description |
|---|---|
| Material | Metal |
| Use | TV Bracket |
| DIY Supplies | Electrical |
| Standard or Nonstandard | Standard |
| TV Size Compatibility | 32-70 inches |
| Max Load Capacity | 35kg |
| VESA Compatibility | 100x100mm to 600x400mm (e.g., 600x400mm, 600x300mm, 500x500mm, 500x400mm, 400x400mm, 400x300mm, 300x300mm, 300x200mm, 300x100mm, 200x200mm, 200x100mm) |
| Extension from Wall | Up to 17.52 inches (44.5 cm) |
| Retraction from Wall | 2.48 inches (6.3 cm) |
| Tilt Angle | -8° to +10° |
Supported VESA mounting patterns:
Supported VESA mounting patterns for various TV sizes.
Dimensions of the mount:
Detailed measurements of the TV wall mount bracket components.
5. Setup and Installation
The installation process is designed for efficiency, typically taking around 45 minutes. Key features include a one-piece design and comprehensive hardware.
Key features for easy installation, including a one-piece design and comprehensive hardware.
Installation Steps:
- Installation of the Base:
- Use a pencil to mark the desired hole locations on the wall.
- Use an electric drill to drill holes at the marked locations. The punching depth should be 70mm and the punching diameter 10mm.
- Use a hammer drill to create mounting holes at the pencil marks. Insert the expansion tube (B) into the holes.
- Insert the bracket body into the expansion tube through screw (A), and tighten the screw after adjusting it with the level (H).
- TV Bracket Installation:
- Install the TV heightening pad if needed. This can be installed between the hook and the TV, or above the hook. You may choose not to install it.
- Note: When the two mounting holes of the TV are on a raised surface and the other two are on a flat surface, follow the diagram for raising the TV. Use short screws for flat surfaces and long screws with heightening pads for stepped surfaces.
- Note: When all four mounting holes of the TV are on a raised flat surface, use short screws with spacers directly.
- TV Hook Installation:
- Note: When the four mounting holes of the TV are on the same plane, use short screws with washers as shown in the figure.
- Hang the TV on the Panel:
- Hang the TV mount on the panel, adjust the level angle, and fix it with safety screws (E).
6. Operating Instructions
Angle Adjustment:
The BEISHI TV Wall Mount offers full motion for optimal viewing.
Illustration of the TV's vertical tilt adjustment, ranging from -8° to +10°.
The TV wall mount bracket in an extended position, demonstrating its full motion capability.
The mount can extend up to 17.52 inches (44.5 cm) and retract to 2.52 inches (6.3 cm) from the wall.
- Horizontal Fine-tuning: Adjust the tightness of the four nuts on the back of the mount to directly adjust the horizontal angle using an L-wrench.
- Pitch Adjustment (Tilt): To adjust the TV's tilt angle, simply adjust the four screws on the side using an L-shaped wrench. The mount supports a tilt range of -8° to +10°.
7. Maintenance
- Regularly inspect the product (recommended at least every three months) to ensure all screws and connections are secure.
- Clean the mount with a soft, dry cloth. Avoid using abrasive cleaners or solvents.
- Ensure no cables are pinched or stressed when adjusting the TV position.
8. Troubleshooting
No specific troubleshooting information is available for this product. If you encounter any issues during installation or operation, please refer to the safety precautions and installation steps carefully. If problems persist, contact the seller for support.
9. User Tips
No specific user tips derived from customer reviews or Q&A are available at this time. Always ensure to follow the provided installation instructions for the best and safest experience.
10. Warranty and Support
For any product-related inquiries, technical support, or assistance with missing/damaged parts, please contact the seller directly through your purchase platform. Please have your order details ready when contacting support.
A PDF version of this user manual is available for download: User manual (PDF)