KEVANLY Solar Powered Car Anti-Theft Simulator

1. Product Overview

The KEVANLY Solar Powered Car Anti-Theft Simulator is designed to mimic the operational status of a vehicle's anti-theft system. It features red and blue alternating or steady flashing lights to deter potential theft and robbery, enhancing vehicle security.

2. Safety & Warnings

Important Safety Information: Read all instructions before use. Failure to follow these instructions may result in damage to the product or personal injury.

• Warning: Keep the device and its cord out of reach of children under 3 years old.
• Keep away from children unless supervised by an adult.
• Do not use this product for purposes other than its intended use.
• Inspect the product before each use; do not use if damaged.
• Follow installation and operation guidelines to avoid injury.
• Do not expose to water or moisture.
• Handle with care to avoid cuts or injuries (though this product is not sharp, general care is advised).
• Do not forcibly disassemble or crush the product to prevent internal circuit damage. Disassembly voids warranty.

3. Setup and Installation

Follow these steps to properly install your anti-theft simulator:

1. Select Location: Choose a prominent, unobstructed location on your vehicle's dashboard or instrument panel. Ensure it receives adequate sunlight for solar charging.
2. Clean Surface: Thoroughly clean the mounting surface to remove any grease, dust, or debris. A clean surface ensures optimal adhesion.
3. Apply Adhesive: Peel off the protective film from the 3M adhesive backing on the product.
4. Secure Device: Firmly press the product onto the cleaned surface for at least 10 seconds. This ensures secure adhesion and helps prevent detachment due to vehicle vibrations.
5. Test Operation: Lightly press the side button on the device to test the flashing modes. Confirm that the red and blue lights illuminate normally. No additional wiring is required for operation.

4. Operating Instructions

Mode Switching

Short press the side button to cycle through the following light modes:

• Steady Red Light
• Slow Red Flashing
• Slow Blue Flashing
• Alternating Red/Blue Flashing
• Power Off

Select the desired mode as needed.

Daily Use

• When Parked: Activate a flashing mode to deter potential thieves.
• When Driving: Turn off the device or switch to a steady light mode to avoid distracting the driver's vision.

5. Maintenance

Charging

The device features solar automatic charging. For prolonged cloudy periods or insufficient sunlight exposure, it can also be charged using USB assisted charging.

Battery Replacement

The device is powered by a long-lasting built-in button battery. When the lights dim significantly or stop flashing, it's time to replace the battery:

1. Carefully pry open the casing of the device.
2. Remove the old button battery.
3. Insert a new button battery of the same specification.
4. Close the casing securely.

Precautions

• Avoid exposure to high temperatures, open flames, or standing water to prevent battery short circuits or casing deformation.
• When mounting, avoid critical areas like airbags and vents to prevent interference with original vehicle functions.

6. Troubleshooting

• Lights are dim or not flashing: The battery may be low. Ensure the device is exposed to sufficient sunlight for solar charging, or use USB assisted charging. If the issue persists, replace the button battery as described in the Maintenance section.
• Device not turning on: Check if the battery is properly installed and charged. If the device has been exposed to extreme conditions (water, high heat), internal damage may have occurred.

7. Specifications

8. User Tips

• Optimal Charging: For best performance, ensure the device is placed in a location that receives direct sunlight for several hours daily to maximize solar charging efficiency.
• USB Backup: If your vehicle is often parked in shaded areas or during prolonged cloudy weather, utilize the USB assisted charging feature to keep the battery topped up.
• Battery Check: Periodically observe the brightness of the flashing lights. If they appear dim, it's an indication that the battery needs charging or replacement.
• Placement: While the device is small, consider its placement carefully to ensure it's visible to deter thieves but doesn't obstruct your view or interfere with vehicle functions.

9. Warranty & Support

Disassembly or modification of the product will void the warranty.

Compliance Information

This product complies with LVD 2014/35/EU standards and carries the CE mark, indicating conformity with health, safety, and environmental protection standards for products sold within the European Economic Area.

The WEEE symbol (crossed-out wheeled bin) indicates that this product should not be disposed of with other household waste. It should be handed over to the applicable collection point for the recycling of electrical and electronic equipment.

Contact Information

Manufacturer: Guangzhou Kejie Trading Co., Room 302, No. 10, Ou Gang North Street, Ke Mu Long West Road, Tianhe District, Guangzhou City, Guangdong Province, China.

EU Authorized Representative: SUCCESS COURIER SL, Calle de RIO TORMES 13A, oficina 1, Fuenlabrada, Madrid, 28947 Spain.

Importer: Guangzhou Kejie Trading Co., Room 302, No. 10, Ou Gang North Street, Ke Mu Long West Road, Tianhe District, Guangzhou City, Guangdong Province, China.