BAOFENG BF-T1

Contents

Baofeng Mini Walkie Talkie BF-T1 User Manual

Model: BF-T1

Baofeng BF-T1 Mini Walkie Talkie User Manual Cover

User Manual Cover for Baofeng BF-T1 Mini Walkie Talkie

1. Introduction

Thank you for your purchase of our Mini Vehicle Two-Way Transceiver. This transceiver is developed by BAOFENG for the interest of car clubs and HAM radio enthusiasts. A complete set must include the base and the extension. It will deliver secure, instant, and reliable communication.

Please read this manual carefully before use.

Safety Precautions

  • Qualified technicians shall service this equipment only. Do not modify the radio for any reason.
  • Use only BAOFENG supplied or approved accessories.
  • Turn off your radio prior to entering any area with explosive and flammable materials. Do NOT USE your transceiver at a gas/fuel station.
  • Do not expose the radio to direct sunlight over a long time, nor place it close to a heating source.
  • To avoid electromagnetic interference or compatibility conflicts, turn off your radio in any area where posted notices instruct you to do so.
  • Do not transmit for long periods of time, as it may overheat the transceiver.
  • Keep the unit away from dusty, damp, and wet environments.

2. Unpacking and Inspecting

Please check the packaging of your radio for any signs of damage. Carefully open the box and confirm you have received all the items listed below. If any items are damaged or missing, immediately contact your dealer.

Contents of the Baofeng BF-T1 Mini Walkie Talkie box

Image showing the contents of the product packaging.

What's in the Box:

  • Mini handheld radio
  • Battery
  • Adapter
  • Earpiece
  • Belt clip
  • Hand strap
  • USB charging cable
  • User manual

3. Assembly

Battery Installation

Open the battery cover with a screwdriver. Connect the electric lead into the battery socket. You will hear a voice 'welcome' and the channel number will be reported. Align the electric lead into the slot and place the battery smoothly, then screw the cover back on. To remove the battery, reverse these steps.

Belt Clip Attachment

At the back of the radio, there are two parallel screws. Remove these screws, align the belt clip holes with the screw holes, and thread the screws through the belt clip, screwing them back into the radio body.

Diagram showing how to attach the belt clip and earpiece to the walkie talkie

Diagram illustrating the attachment of the belt clip and earpiece.

Earpiece Connection

Open the cover of the earpiece jack, align the connector, and push it fully in.

4. Charging and Battery Maintenance

Charging

The battery should be fully charged before initial use. Optimum battery efficiency will be achieved after three full charge and discharge cycles.

When the battery level indicator shows low battery, the radio will start beeping periodically, indicating it needs charging.

  1. Connect the charging USB cable with the AC adapter and the radio's socket.
  2. Plug the AC connector of the power adapter into a main AC wall outlet.
  3. When the battery level indicator shows charging, the charge is starting.
  4. When the battery level indicator shows full, the charge finishes. Pull out the USB charging cable.

Note: The radio should be turned off during the charge cycle.

Diagram showing the walkie talkie connected to a charger, indicating fast charging and long standby time

Diagram illustrating the charging process of the walkie talkie.

Battery Maintenance

  • Use only batteries approved by the original manufacturer.
  • Never attempt to disassemble the battery pack.
  • Do not expose the battery to fire or intense heat.
  • Dispose of batteries in accordance with local recycling regulations.
  • The battery is not fully charged from the factory; charge it for at least three to five hours before first use.

5. Getting to Know Your Radio

Hand holding Baofeng BF-T1 walkie talkie, showing display with icons for Alarms, Power Saving, Announce, and Flashlight

Image of the Baofeng BF-T1 in hand, highlighting key features like Alarms, Power Saving, Announce, and Flashlight.

Radio Components and Controls:

The transceiver is fitted with a seven-character segment code alphanumeric LCD, with auxiliary icons for various features.

Diagram of Baofeng BF-T1 walkie talkie showing ON/OFF button, LED Flashlight, Battery, Antenna, Lanyard loop, PTT button, Speaker and Microphone, SOS button, Accessory jack, Belt clip, Status LED, Keypad
Diagram of the Baofeng BF-T1 with labeled components.

Main Display Icons:

Icon Description
FMenu 9. Repeater function setting
Time countdown setting
Memory channel
WWideband enabled
CTCTCSS enabled
Keypad locked enabled
DCSDCS enabled
Battery level indicator
FMBroadcast FM
The extension synchronizes the base
SOSEmergency call, pressing SOS button
Volume indicator

Status LED

The status LED has a simple and traditional design. When you receive a signal, it turns green; when you transmit, it turns red; and it's off in standby.

SOS Button

20 group channels can only be entered via software. You can also have an extra one for group call or emergency call. When you press this button, all others will receive your call.

Keypad Zone

The MENU key is used to enter the menu and confirm menu options. It also locks the keypad. Press and hold MENU to lock out all keys except for the ON/OFF, SOS, and PTT buttons.

6. Basic Operation

Power and Volume

  • Turning the unit on: Simply press the On/Off button until you hear a "click". If your radio powers on correctly, there should be an audible beep after about a second, and the display will show a message or flash the LCD depending on settings. Then it will display a channel. If voice prompt is enabled, it will announce "welcome to use".
  • Turning the unit off: Press and hold the ON/OFF button to turn the unit off.
  • Adjusting the volume: Press the MONI/VOL button momentarily; the volume indicator will appear. Press the UP arrow key to increase the volume or the DOWN arrow key to decrease it. Press MONI/VOL again to confirm the volume level.

Making a Call

Press and hold the PTT (Push-To-Talk) button on the side of the radio body to transmit. While transmitting, speak approximately 3-5cm from the microphone. When you release the PTT, your radio will return to receive mode.

Function Keys

  • Up and Down Keys: Used to navigate through the menu, select channels, and adjust volume up and down.
  • FM (Broadcast FM and Alarm): Press FM momentarily to start the broadcast FM receiver. Another momentary press turns it off. If a signal is received on the active channel while listening to FM, the receiver will open squelch to that frequency and remain there until the signal is gone, then switch back to FM. Press and hold FM to activate the alarm function; a short press again turns it off.
  • MONI/VOL: Press momentarily to display the volume indicator, then use arrow keys to adjust. Press and hold MONI/VOL to monitor the signal, opening the squelch to listen to unfiltered signals.
  • Lamp/Scan: Press momentarily to turn on the LED flashlight. Another momentary press will flash the LED. A third press turns the flashlight off. Press and hold it to enable the scanner; another momentary press exits scanning.

Combination Key Functions

  • High and Low Output Power Switching: Press and hold the ON/OFF + LAMP buttons for about two seconds to switch on the radio. You can select high or low output power. If voice prompt is enabled, it will announce "one" (low) or "five" (high).
  • Resets the Radio to Factory Defaults: Press and hold the ON/OFF + MONI/VOL buttons to switch on the radio. All settings will be reset to factory defaults (e.g., 400.025MHz, no CTCSS/DCS, low output power, battery save, volume level 5, width band, SQL 5, key tone ON, other settings off).

8. Programming

Memory channels are an easy way to store commonly used frequencies so they can be easily retrieved later. The BF-T1 features 20 memory channels that can each hold: Receive and transmit frequencies, transmit power, group signaling information, and bandwidth.

Computer Programming

The radio kit does not include a programming cable. To obtain a data cable and software, please contact your dealer.

9. Specifications

General Specifications

Feature Specification
Frequency Range400.00-440.00 MHz, 440.00-470.00MHz
Storage Channel20
Step Frequency12.5/25KHz
Rated voltageDC 3.7V
Frequency Stability±2.5ppm
Work Temperature-20°C to +60°C
Battery CapacityH-1500mAh (Li-ion Battery)
Battery LifeAbout 12 Hours
Antenna Impedance50Ω
Dimension108x55x21 mm (Including Antenna)
Weight120g (Including battery)

Transmitter Specifications

Feature Specification
Output Power0.5W/1W
Modulation Mode (W/N Band)16KΦF3E/11KΦF3E
Maximum Frequency Deviation (W/N Band)<5KHz/≤2.5KHz
Spurious Power<7.5 μW
Adjacent channel power<-65dB/<-60dB
Audio Distortion<5%
SNR≥-45dB/≥-40dB
CTSCC/DCS Frequency Deviation (W/N Band)0.7±0.1KHz (W), 0.4±0.1KHz (N)
Modulation Sensitivity8-12mV
Transmitting Current<1000mA

Receiver Specifications

Feature Specification
Sensitivity<0.25 μV (12dB SINAD)
Audio Power1W
Inter modulation Interference Resistance≥65dB (W), ≥60dB (N)
Adjacent channel Selectivity (W/N Band)≥65dB (W), ≥55dB (N)
Audio Distortion5%
Receiving Current<380mA

CTCSS Table (50 Tones)

No Tone (Hz) No Tone (Hz) No Tone (Hz) No Tone (Hz) No Tone (Hz)
167.01194.821131.831171.341203.5
269.31297.422136.532173.842206.5
371.913100.023141.333177.343210.7
474.414103.524146.234179.944218.1
577.015107.225151.435183.545225.7
679.716110.926156.736186.246229.1
782.517114.827159.837189.947233.6
885.418118.828162.238192.848241.8
988.519123.029165.539196.649250.3
1091.520127.330167.940199.550254.1

DCS Table (210 Codes)

D023N D025N D026N D031N D032N D036N D043N D047N D051N D053N D054N D065N D071N D072N D073N D074N D114N D115N D116N D122N D125N D131N D132N D134N D143N D145N D152N D155N D156N D162N D165N D172N D174N D205N D212N D223N D225N D226N D243N D244N D245N D246N D251N D252N D255N D261N D263N D265N D266N D271N D274N D306N D311N D315N D325N D331N D332N D343N D346N D351N D356N D364N D365N D371N D411N D412N D413N D423N D431N D432N D445N D446N D452N D454N D455N D462N D464N D465N D466N D503N D506N D516N D523N D526N D532N D546N D565N D606N D612N D624N D627N D631N D632N D645N D654N D662N D664N D703N D712N D723N D731N D732N D734N D743N D754N

10. Troubleshooting

Symptom Possible Cause Solution
The radio doesn't start.The battery is too low.
The battery isn't correctly installed.
Change or recharge the battery.
Remove the battery and reinstall it.
The battery dies quickly.The battery is dead.
The battery isn't fully charged.
Purchase a new battery.
Recharge the battery.
The LED indicates reception, but the speaker is silent.Volume is too low.
CTCSS or DCS enabled.
Turn up the volume.
Change the CTCSS or DCS to match those you are trying to communicate.
Turn off your CTCSS or DCS.
Others can't hear your transmission.Their CTCSS or DCS settings don't match yours.
You are too far apart.
Change your CTCSS or DCS settings to match your peers.
Move in closer.

11. User Tips

  • For use with children, you can set a specific channel and lock the radio, leaving only the PTT button available for simple communication.
  • The default volume might be loud for indoor use; it is generally more suitable for outdoor environments.
  • To customize frequencies and unlock the full potential of the radio, a programming cable is required. Ensure you obtain the correct cable for the BF-T1 model.

12. Warranty and Support

For detailed warranty information and technical support, please refer to the official Baofeng website or contact your authorized dealer. Additional guides and documents, including the full user manual in PDF format, may be available from your seller or the manufacturer's support channels. You can find the PDF manual here.


Documents and downloads

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.