XMSJ AP-20

Contents

XMSJ AP-20 Vacuum Sealer Machine User Manual

Model: AP-20 | Brand: XMSJ

1. Introduction

Thank you for choosing the XMSJ AP-20 Vacuum Sealer Machine. This advanced appliance is designed to preserve your food longer by removing air from specially designed bags and containers. Featuring a powerful 2-pump system with 85KPA vacuum pressure, an 8-in-1 automatic function, built-in cutter, and bag storage, it offers convenience and efficiency for all your food preservation needs, including Sous Vide preparation.

XMSJ AP-20 Vacuum Sealer Machine with vacuum-sealed meat and fresh produce
The XMSJ AP-20 Vacuum Sealer Machine, designed for efficient food preservation.

2. Safety Information

  • Always unplug the power supply before cleaning the product to avoid electric shock.
  • Do not touch the heating wire isolation tape immediately after sealing to avoid scalding.
  • Ensure the machine is placed on a stable, flat surface during operation.
  • Keep out of reach of children.

3. What's in the Box?

Upon unpacking your XMSJ AP-20 Vacuum Sealer Machine, please ensure all the following items are included:

Contents of the XMSJ AP-20 Vacuum Sealer Machine box, including the machine, roll, bags, hose, and manual.
Contents of the product package, including the vacuum sealer and accessories.
  • XMSJ AP-20 Vacuum Sealer Machine
  • 11in x 16.4ft Roll (1)
  • 17x25cm / 6.7x9.8in Vacuum Bags (5)
  • Air Suction Hose (1)
  • User Manual (1)

4. Specifications

FeatureSpecification
Model NumberAP-20
Power145W
Voltage100-240V / 50-60Hz
Vacuum Speed10L/minute
Vacuum Value (Dry)-85Kpa
Vacuum Value (Moist)-35Kpa
Max Seal Pockets Width11.8 inch (30cm)
Seal Width0.2 inch (5mm)
Product Dimensions (L x W x H)395mm x 87mm x 95mm (16.5in x 6.5in x 4.1in)
Product Weight1.65KG
Roll Bag StorageL11.8 R2.5 inch
TypeHand Held
With Vacuum BagYes

5. Setup

5.1 Power Connection

  1. Insert the tail of the power cord into the power socket on the machine.
  2. Ensure the power cord is properly connected; only half a circle should be exposed in the groove of the tail terminal. If the groove is exposed, the power cord is not properly connected.
  3. The power cord can be rolled up and stored in the designated compartment.
Diagram showing the power cord guide slot, storage buckle, and AC plug connection on the vacuum sealer.
Proper power cord connection and storage.

5.2 Bag Preparation

The machine features a built-in bag storage and cutting knife for convenience.

  1. Place the roll bag into the bag compartment.
  2. Pull out the required length of the plastic bag.
  3. Press the edge of the plastic bag with your left hand and slide the cutting knife from left to right with your right hand to cut the bag.
  4. To create a bottom seal for a custom-sized bag, insert one end of the cut plastic bag into the machine to a depth of approximately 1 inch, then touch the 'SEAL' key.
  5. After the LED stops flashing, remove the bottom sealed plastic bag.
Diagram showing how to use the roll bag storage and cutting knife.
Using the built-in roll bag storage and cutting knife.

5.3 Drip Box Check

Before each use, pull out the drip box and confirm that there is no foreign matter between the drip box and the upper pressing plate. This ensures proper vacuum sealing and prevents damage.

6. Operating Instructions

The machine adopts luminous key design. The operation keys can be seen only after the power is plugged in.

Diagram showing the 5 operation modes: Meat, Chips, Nuts, Vegetable, with corresponding buttons: Seal, Exter VAC, Manual, Wet Vac, Dry Vac.
The 5 operation modes of the vacuum sealer.

6.1 Bag Types

Please use a plastic bag with a width of 11.8 inches (30cm) or less. The machine is suitable for:

  • Polybags with dots/diamonds reticles (can be vacuum sealed).
  • Plastic bags with folded edges (can be vacuum sealed).

Plastic bags with smooth sides cannot be vacuum tight.

6.2 Automatic Vacuum Seal (Dry/Moist)

  1. Place the food into the vacuum bag. Do not fill the bag too full; ensure there is about 1 inch (3cm) distance between the food and the machine's bag inlet.
  2. Flatten the mouth of the bag and insert it from the bag inlet until about 2 inches.
  3. Select the appropriate mode:
    • For dry foods (e.g., nuts, chips), press the 'Dry Vac' key.
    • For slightly wet foods (e.g., fresh meat), press the 'Wet Vac' key.
    • For foods with significant liquid (e.g., meat with marinade), double-click the 'Wet Vac' key within 1 second to activate strong wet vacuum sealing.
  4. The machine will automatically evacuate air and seal the bag. The button light will stop flashing when complete.
  5. After the upper pressing plate is released, take out the plastic bag.
Demonstration Video: Automatic Vacuum Sealing

This video demonstrates the process of cutting a bag from a roll, sealing a wet item (duck), and a dry item (meatballs), and highlights the liquid collection tray.

6.3 Manual Vacuum Seal

This mode is ideal for soft or fragile foods (e.g., cakes, snacks, biscuits) where precise control over vacuum pressure is needed to prevent crushing.

  1. Flatten the vacuum bag mouth and insert it into the bag mouth of the machine at about 2 inches.
  2. Press and hold the 'Manual' key to vacuum.
  3. Release the key once the desired air pressure is reached.
  4. After releasing the key, the machine will automatically seal the bag within 2 seconds.

6.4 SEAL Only Function

Use this function to seal bags without vacuuming, or to create custom-sized bags from a roll.

  1. Insert the opening of the plastic bag to be sealed from the "bag inlet" of the machine, about 1 inch deep.
  2. Touch the 'SEAL' key. The key indicator will flash, the upper cover will sink, and the machine will begin to seal.

6.5 External Vacuum System

The external vacuum system allows you to vacuum seal food in vacuum jars, wine stoppers, and other compatible containers.

Image illustrating the external vacuum system with a hose connected to a vacuum jar and wine stopper.
The external vacuum system for jars and wine stoppers.
  1. Ensure the drip box is installed in place.
  2. Insert one end of the air suction hose into the external air extraction port on the machine.
  3. Connect the other end of the hose to the vacuum tank or wine stopper (vacuum tank needs to be purchased separately).
  4. Press the 'Exter VAC' button. The button light will stop flashing when the vacuum process is complete.
  5. After the work is completed, pull out the external suction pipe.

6.6 Locking the Machine

To lock the machine and prevent accidental operation, press and hold the 'SEAL' button for 2 seconds. The machine will lock for 10 seconds. After 10 seconds, it will automatically unlock, allowing you to touch the buttons again.

7. Maintenance

7.1 Cleaning the Drip Box

The drip box collects spilled liquid during use. It is crucial to clean it regularly to prevent liquid from damaging the machine. Remove the drip box and rinse it with water.

7.2 Cleaning the Heating Wire Isolation Tape

Do not tear the heating wire isolation tape. If there is dirt, clean it carefully before use. Replace it in time if it becomes damaged.

7.3 Self-Cleaning Function

The machine has a self-cleaning function for the air pump pipeline.

  1. Long press the 'Exter VAC' button for 3 seconds to enter the self-cleaning mode.
  2. This function effectively removes liquid and residue from the air pump pipeline.
  3. Unplug the power cord after the self-cleaning process is complete.

8. Troubleshooting

If you encounter any issues with your vacuum sealer, please refer to the table below for common problems and their solutions.

Fault PhenomenonFault AnalysisMethod of Exclusion
No control button or indicator light is onPower plug not properly connectedCheck power outlet and ensure power cord is properly connected.
Sealed without vacuumingWrong vacuum bag type or bag mouth not inserted correctlyUse a special vacuum bag with pitting or mesh grid. Insert bag opening 2 inches deep. If vacuum seal is required, touch 'VAC SEAL' button.
No vacuum, no sealing, no sinking action of upper plate, no vacuum pumping soundMachine not started or vacuum pump damagedTouch the 'VAC SEAL' key. If problem persists, contact vendor.
No vacuum pumping, no sealing, no sinking action of upper plate, but there is vacuum pumping soundLower part of upper pressing plate stuck by foreign mattersPull out the drip box to remove foreign matters.
No vacuum pumping, no sealing, and upper cover has sinking actionUpper cover or base sealing ring falls off or the base is damagedTry to replace the vacuum bag. If problem persists, contact vendor.
Vacuum all the time but does not sealBag leaks or upper cover stuck by objectsReplace the vacuum bag. Reduce food in bag (at least 2 inches away from machine). Remove sharp objects from bag.
Air leakage after vacuum packaging for a period of timeAir leakage from plastic bag or too much liquid in bagReplace the plastic bag. Ensure liquid does not flow to sealing position.
Shortly after vacuum, plastic bag leaks or expandsSome foods ferment in low oxygen environmentFoods with pungent smell (garlic, onion, ginger), raw chestnut, fermented foods, fresh corn, wet rice, and cut/oxidized apples may bulge. These foods emit gases. For green leafy vegetables, soak in hot water (>80°C) for 2 minutes before sealing.

9. User Tips

  • Optimal Bag Filling: Always leave at least 1 inch (3cm) of space between the food and the top of the bag to ensure a proper seal.
  • Handling Liquids: For wet foods or foods with liquid, use the 'Moist' setting. If there's significant liquid, double-click the 'Wet Vac' button for a stronger seal. Immediately clean the drip box after sealing liquids to prevent machine damage. For very liquid-rich items, consider freezing them partially before vacuuming or using the 'Manual' mode to control the vacuum process.
  • Avoid Sharp Objects: Do not vacuum seal foods with sharp edges (e.g., bones, water chestnuts) directly, as they can puncture the bag and cause air leakage. Use extra padding or a container if necessary.
  • Fermenting Foods: Foods that naturally ferment or produce gases (e.g., fresh corn, certain cheeses, some fruits and vegetables) may still expand or appear deflated over time. For green leafy vegetables, blanching them in hot water (above 80°C) for 2 minutes before vacuum sealing can help prevent oxygen production.
  • Cool Down Between Uses: For best sealing results and to prolong machine life, allow a 10-second interval between sealing operations.

10. Certifications

The XMSJ AP-20 Vacuum Sealer Machine complies with the following certifications:

  • CE (Conformité Européenne)
  • EMC (Electromagnetic Compatibility)
  • EMF (Electromagnetic Fields)
  • RoHS Compliant (Restriction of Hazardous Substances)
Certification logos including CE, FC, RoHS, PS E, and 'Made in China'.
Product certifications.

11. Warranty and Support

For detailed warranty information, service, and support, please refer to the complete user manual PDF available for download. This manual provides comprehensive details on product guarantees and how to obtain assistance.

You can access the full user manual PDF here.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.