1. Product Overview
The EJEAS V4 Plus is a full-duplex Bluetooth intercom system designed for motorcycle helmets, allowing up to 4 riders to communicate simultaneously. It features Bluetooth 5.1 technology for stable connections, FM radio, music playback, and is IP65 waterproof.

Figure 1: EJEAS V4 Plus Intercom System (4-pack)
1.1 Components

Figure 2: Product Details and Controls
- Antenna: For signal reception.
- A Button: Multi-function button.
- Volume + Button: Increase volume, navigate menus.
- FM Button: Activate/deactivate FM radio.
- Indicator Light: Displays device status (pairing, battery, etc.).
- Phone/Power Button: Power on/off, answer/end calls, activate voice assistant, play/pause music.
- B Button: Multi-function button.
- Volume - Button: Decrease volume, navigate menus.
- Earphone Interface: Connects to helmet speakers and microphone.
2. Setup
2.1 Installation
Follow these steps to install the intercom system on your helmet:
- Loosen the screws of the clip and install it securely on the side of your helmet.
- Install the intercom unit onto the fixed clip.
- Use the provided Velcro stickers inside your helmet to position the stick microphone or soft microphone according to your preference.
- Organize any messy cables inside your helmet foam for a comfortable and secure fit.

Figure 3: Product Installation Steps
3. Operating Instructions
3.1 Basic Operations
- Click: A short press and release of a button.
- Double Click: Two quick presses of a button.
- Long Press (5s): Press and hold a button for 5 seconds.
- Long Press Simultaneously (5s): Press and hold two specified buttons for 5 seconds.

Figure 4: Operation Diagram
Power ON/OFF
Please ensure the device is charged before first use.
- Power ON: Long press the Phone/Power button for 1 second. You will hear a prompt tone, and the blue light will flash slowly.
- Power OFF: Long press the Phone/Power button for 1 second. The lights will turn off.
Battery Level Check
To check the battery level, long press the Volume + and Volume - buttons simultaneously for 3 seconds. The device will indicate the battery level (High, Medium, Low).
Volume Control
Adjust the volume using the Volume + and Volume - buttons. The FM radio and intercom can be used simultaneously, with separate volume control for FM when both are active.
3.2 Bluetooth Intercom Pairing
The EJEAS V4 Plus supports group intercom for up to 4 riders.
Video 1: V4 PLUS 3 Machine Pairing Guide
2-Way Intercom Pairing
- Ensure both devices (Device 1 and Device 2) are powered on.
- On Device 1, long press the 'A' button. On Device 2, long press the 'B' button. Hold for 5 seconds until the LED lights on both devices flash red and blue alternately. This indicates pairing mode.
- After approximately 3 seconds, the devices will automatically pair successfully.
- Once paired, the devices are connected, and communication can begin.
3-Way Intercom Pairing
- First, pair Device 1 and Device 2 as described in the