POKESS 8V4116C618CA

Contents

Bonnet Rubber Buffer Adjustable User Manual

Model: 8V4116C618CA

1. Product Overview

This adjustable rubber buffer is designed to provide proper spacing and cushioning for your vehicle's bonnet (hood), preventing rattling and ensuring a secure closure. It is a direct replacement part for various Ford models.

Angled view of the Bonnet Rubber Buffer Adjustable

Figure 1: Bonnet Rubber Buffer Adjustable

2. Safety & Warnings

  • Read all instructions before use. Failure to follow these instructions may result in damage to the product or personal injury.
  • Do not use this product for purposes other than its intended use.
  • Inspect the product before each use; do not use if damaged.
  • Follow installation guidelines to avoid injury.
  • Do not expose to excessive water or moisture, as this may degrade the rubber over time.
  • Handle with care during installation.

3. Setup and Installation

3.1 Pre-Installation Check

  1. Verify OE Number: Confirm that the OE number of this part is 100% identical to your original broken part. If the OE number is correct, proceed with installation. If the OE number is wrong, do not install; contact the seller immediately.
  2. Check Package Contents: Ensure the package contains the main part (rubber buffer) and any necessary accessories or hardware.
  3. Confirm Vehicle Match: Verify that the part is suitable for your specific vehicle model, year, and intended installation position.

3.2 Installation Steps

The bonnet rubber buffer typically installs into a designated hole on the vehicle's chassis or bonnet frame. Refer to your vehicle's service manual for exact location and procedure if unsure.

  1. Locate the existing or intended mounting point for the bonnet buffer.
  2. If replacing an old buffer, carefully remove it.
  3. Insert the new rubber buffer into the mounting hole. Ensure it is securely seated. The base of the buffer is designed to clip into place.
  4. Once installed, the buffer's height can be adjusted by rotating the rubber head, which threads up or down the shaft.
  5. Close the bonnet gently to check for proper contact and alignment. Adjust the buffer height as needed to achieve a firm, rattle-free closure without excessive force.
Exploded diagram of vehicle front end showing bonnet buffer location

Figure 2: Exploded view of bonnet assembly, indicating buffer location (part 16758A)

4. Operating the Adjustable Buffer

This product is a passive component. Its

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.