1. Introduction and Important Safety Warnings
Thank you for choosing the Kidilo G100 3-in-1 Baby Stroller and DB02 Infant Carrier. This manual provides essential information for the safe and correct installation, operation, and maintenance of your product. Please read these instructions carefully before use and keep them for future reference. Failure to follow these instructions may compromise the safety of your child.
General Safety Warnings
- Never leave your child unattended.
- Ensure that all locking devices are engaged before use.
- To avoid injury, ensure your child is kept away when unfolding and folding this product.
- Do not let your child play with this product. Always use the restraint system.
- Check that the pram body, seat unit, or car seat attachment devices are correctly engaged before use.
- This product is not suitable for running or skating.
- This stroller is intended for children from 0 months to 3 years old and up to 15 KG.
- This stroller shall be used only for 1 child.
- The parking device shall be engaged when placing and removing children.
- Use the brake when the stroller is stopped.
- Any goods put in the basket must not exceed 2 KG.
- Any load attached to the handle, backrest, or sides of the vehicle will affect the stability of the vehicle.
- Only replacement parts and accessories supplied or recommended by the manufacturer/distributor shall be used.
- Use a harness as soon as your child can sit unaided.
- The stroller should be assembled by an adult. It is not allowed to be folded, assembled, or removed by children.
- Expand or fold the stroller frame carefully to avoid finger injuries.
- Fasten the seatbelt when the child is in use.
- Buckle rings could cause choking. Do not let children play with them.
- Whenever you park the stroller, please use the brake to stop it.
- Stop using the basket when the child can sit unaided.
Infant Carrier Specific Warnings
- Applicable Condition: Rear-facing installation, weight 0-13KG, head should not extend beyond the top of the seat back. Reference age: New-born infant - 15 months.
- It must not be used in a seat that is protected by a front airbag.
- It can only be used in a car with a three-point safety belt. The safety belt must comply with ECE R44 standard or equivalent.
- Please do not leave your child alone in the car.
- This product can only be used in a car. Do not use in other places.
- Infants not meeting the above conditions are not allowed to use this product.
- Do not transform the infant carrier in any way, as this may affect safety.
- Suffocation Hazard: Infant carrier can roll over on soft surfaces and suffocate the child. NEVER place the carrier on beds, sofas, or other soft surfaces.
- Children have STRANGLED in loose or partially buckled harness straps. Fully restrain the child even when the carrier is used outside the vehicle.
- Do not use the infant carrier if it is damaged or broken.
- The manufacturer's recommended maximum weight for the infant carrier is 13kgs, suitable for 0-15 months.
2. Parts Identification
Stroller Components

- Canopy
- Push Handle
- Armrest
- Safety Belts
- Shopping Basket
- Rear Wheel Brake Pedal
- Rear Wheels
- Front Wheels
- Folding Button
Infant Carrier Components

- Sheath of Shoulder Strap
- Safety Buckle
- Sleeping Pad
- Crotch Pad
- Adjustment Belt for Shoulder Strap
- Adjustment Button for Handle
- Belly Belt Cross Point
- Handle
- Canopy
- Slot for Car Safety Belt
- Shoulder Belt Cross Point
Package Contents
Before installation, please check that all parts are included in the package. For any missing or defective parts, please contact customer service immediately.






3. Assembly and Setup
3.1 Stroller Assembly
- Unfold the Stroller:
Adjust the push handle to the desired position. Switch off the folding lock. Grab the handle and pull it upward to spread the frame out. The stroller is fully unfolded when you hear a "click" sound.
Unfolding the Stroller Frame - Install the Front Wheels:
Lift the front frame up and fully insert each front wheel into the mounting hole beneath the frame. Repeat for the other front wheel. Before usage, pull the front wheels downward to check if they are properly installed.
Front Wheel Installation - Install the Rear Wheels:
Lift the rear frame up and fully insert each rear wheel into the mounting hole at the side of the frame. Repeat for the other rear wheel. Before usage, pull the rear wheels outward to check if they are properly installed.
Rear Wheel Installation - Install the Brake System:
Insert the plastic holes at both ends of the brake into the frame metal rod. The installation is complete when a "click" is heard.
Brake System Installation - Install the Armrest:
Insert both ends of the armrest into the sleeping basket until a "click" sound is heard.
Armrest Installation
3.2 Infant Carrier Installation (Car Safety Belt)
This product is a standard infant carrier that meets general car seat standards. It is not intended for cars with peculiar belt types or dimensions. The infant carrier will not function correctly if not installed properly, as the seat may shift and become unstable, leading to danger.
Important: For the safety of your child, confirm the belt type of your car before installation and select the proper installation method.
- 3-point safety belt plus ELR (Emergency Locking Retractor function): Pull out the necessary length for fitting the child safety car seat. Put the shoulder strap on the fixing part of the body to fix the child car seat.
- 3-point safety belt plus ALR/ELR (device of child safety car seat): Switch to ALR function after fixing the child safety car seat and pulling out the safety belt. ALR function is forbidden in child mode.
Installation Steps:
- Ensure the buckle tongue is pushed into the buckle slot.
- The safety belt must be tight and without twist.
- The backrest must be stable and without displacement when shaken.
- Push any extra safety belt into the belt bin after binding the infant carrier with the safety belt.
- Make sure the car safety belt binds the infant carrier tightly. A loose car safety belt will affect the safety property of the infant carrier.
- The dotted line part in diagrams indicates the hidden part of the car safety belt.
4. Operating Instructions
4.1 Stroller Operation
- How to Use the Canopy:
Spread or gather the canopy as required.
Canopy Usage - How to Use the Brake:
Step down the back wheel brake pedal to stop the stroller. Lift the pedal up to release the brake. - How to Adjust the Backrest:
Pinch the head position adjustment buckle, tighten the strap, then raise the position. To lower, press the buckle, put down the strap, and move the head position backward until it is flat. - How to Adjust the Footrest:
Open the adjustment belt of the footrest, loosen the belt, then the footrest will be flat, converting it into a basket. To lift the footrest, lock the adjustment belt to the desired height. - How to Adjust the Seat:
Press down the two buttons on both sides of the seat to adjust its position. The seat can be adjusted to three different angles. - How to Fold the Stroller Frame:
Use the one-hand folding button: press it first, then rotate it. The lock for the frame will frame down, and the frame will fold to its smallest size. Use the lock device on the side of the frame to fasten the folded status.Video: Stroller Folding and Component Attachment Demonstration - How to Use the Safety Belt:
Use the buckle to adjust the belt length to suit the baby. The red center button releases the safety belt. To fasten the belt, put its parts into the center button.
Safety Belt Usage
4.2 Infant Carrier Operation
- How to Adjust the Height of the Shoulder Strap:
For the safety of your child, check the height of the shoulder strap frequently. The child's shoulder should always be under the hole of the shoulder strap.
Shoulder Strap Height Adjustment Guide - Child safety belt can be released by the button fixed in front of the seat. Press down on the label marked "Press" as you grip the two shoulder straps with your other hand. Pull the shoulder straps forward to adjust the tightness of the restrict system.
- Insert the buckle tongue into the slot after the child is seated in the car seat, then adjust the belt length at the crotch position. Pull the adjustment belt out and make the shoulder strap bind the child firmly.
- The shoulder strap should be adjusted to a proper tightness. A too tight shoulder strap will cause discomfort, and a too loose shoulder strap will be dangerous.
- How to Adjust the Handle:
Press the red adjustment button at both sides near the handle at the same time, and rotate the handle to the desired position. You will hear a "click" sound if the handle is adjusted to the right place. This product has 3 positions of adjustment.
5. Maintenance
To guarantee the service life of the stroller, please use it correctly under these instructions and perform thorough inspections regularly.
- Check and maintain the stroller periodically to avoid risk to your baby.
- Ensure all parts are integrated before using.
- Clean the woven fabric with a brush; do not wash it.
- Do not store this buggy in areas that are humid or exposed to high or low temperatures.
- Do not overload the stroller.
Infant Carrier Maintenance
- Take off the fabric cover and wash with neutral detergent under 30 degrees Celsius.
- To avoid aging of plastic, please keep it in a cool place if you do not use it for a long time.
- Avoid direct sunlight exposure.
- The infant carrier must be replaced if it has been subject to violent stresses in an accident.
- TOP TIP: The infant carrier must be used with its fabric cover, as the fabric cover is an indispensable part of the protection procedure.
6. Troubleshooting
- Stroller not folding/unfolding smoothly: Check and operate it as per the instructions to avoid unwanted damage. Ensure no parts are obstructed.
- Stroller components not locking into place: Press with proper force down to ensure it is fully locked. Pull with proper force out to confirm it is fully locked before using the stroller.
- Infant carrier shoulder strap discomfort/looseness: The shoulder strap should be adjusted to a proper tightness degree. A too tight shoulder strap will cause discomfort, and a too loose shoulder strap will be dangerous. Adjust according to the child's size and ensure it is snug but comfortable.
7. Specifications
| Feature | Stroller (Model G100 3in1 / V9) | Infant Carrier (Model DB02) |
|---|---|---|
| Suitable Age | 0-36 months | 0-15 months |
| Maximum Loading Weight | 15 KG | 13 KG |
| Material | COTTON, Aluminum tube | COTTON, Aluminum tube |
| Is Foldable | Yes | N/A |
| Certification | 3C (Certificate No: 2021182201027425) | 3C (ECE R44 equivalent) |
| Product Category | Four-wheel cart | Infant Carrier (Group 0+) |
| Function | High Landscape, Bidirectional | Car Safety Seat |
| Max Basket Load | 2 KG | N/A |
| Package Dimensions (L x W x H) | 110 cm x 52 cm x 60 cm | Included in stroller package |
| Package Weight | 30.0 KG | Included in stroller package |
8. User Tips
- The stroller is noted for being quite tall and large, which can be beneficial for a high landscape view but consider this for storage and transport.
- Users praise the excellent color and quality, good shock absorption, and large, easy-to-maneuver wheels, making it suitable for city walks and uneven surfaces.
- Some packages have included additional accessories like winter gloves, a mosquito net, and a rain cover, even if not explicitly listed. It's worth checking your package contents upon arrival.
- The frame material is aluminum, contributing to its sturdy yet manageable design.
- The 3-in-1 system includes the stroller, pram body, and infant car seat, offering versatility from newborn to toddler stages.
9. Warranty and Support
For any missing or defective parts, please contact the customer service of your retailer immediately.
Manufacturer Information:
- Company: HUBEI DOLLBABY CHILDREN PRODUCTS CO.,LTD
- Address: NO.150HUOCHENG ROAD, ECONOMIC DEVELOPMENT ZONE OF HANCHUAN CITY, HUBEI, CHINA
To ensure the longevity and safety of your product, always adhere to the instructions provided in this manual.