CYCLAMI RT01

Contents

CYCLAMI RT01 Bicycle Intelligent Radar Tail Light

Model: RT01 | Brand: CYCLAMI

1. Introduction

Congratulations on your purchase of the CYCLAMI RT01 Intelligent Radar Tail Light. This device is designed to enhance your cycling safety with advanced radar detection and bright LED illumination. Please read this manual thoroughly to understand its features and ensure proper use.

CYCLAMI RT01 Key Features

Figure 1: CYCLAMI RT01 Key Features (MM Radar Wave, Precision Sensors, Large-angle radar, 500 Meter Visible, Dual Bracket Mount, 1500MAH Battery, 60g Ultralight, TYPE-C Fast Charge)

2. What's in the Box

Please check the package contents:

  • RT01 Radar Taillight
  • User Manual
  • Wrench
  • Saddle Mounting Bracket (angle adjustable)
  • Seatpost Mounting Bracket (V-Bar Compatible)
  • TYPE-C USB Charging Cable
Package Contents

Figure 2: Contents of the RT01 Package

3. Setup and Installation

The RT01 offers dual bracket mounting options for versatile installation.

3.1 Mounting on the Seatpost

  1. Insert the end of the silicone strap into the flat hole of the base.
  2. Place the base against the seatpost and wrap the silicone strap around it.
  3. Insert the holes on the silicone strap into the base card slot and bend the remaining silicone strap backward.
  4. Secure the other hole on the silicone strap into the base card slot.
  5. Ensure the light is firmly attached.

3.2 Mounting Under the Saddle

  1. Buckle the left and right fasteners of the saddle bracket onto the saddle rails and insert the left and right screws.
  2. Adjust the position of the lamp holder as desired, then tighten the left and right screws.
  3. Align the protrusion of the bottom buckle of the taillight with the notch on the saddle bracket, press it into the bottom, and rotate it 45 degrees to lock.

3.3 Disassembly

  1. Rotate the lamp head 45 degrees counter-clockwise.
  2. Gently pull the lamp head to remove it from the bracket.
Dual Bracket Mount

Figure 3: Seatpost and Saddle Mounting Options

4. Operating Instructions

The RT01 features independent buttons for regular lighting and radar mode.

Independent Switch

Figure 4: Independent Light and Radar Buttons

4.1 Power On/Off

  • To Turn On: Short press either the Regular Light Button or the Radar Mode Button.
  • To Turn Off: Long press either button for 5 seconds. The light will slowly dim.

4.2 Regular Light Modes

The Regular Light Button controls 7 different light modes:

  • To Cycle Modes: Short press the Regular Light Button within 5 seconds of the last press.
  • Modes Sequence: Bright (4H) → Breathing (4.5H) → Strobe (5.5H) → Slow Strobe (13H) → Warning Strobe (11H) → Climbing Snake (36H) → Double Snake (36H).
  • To Select Mode: If no button press occurs for 5 seconds, the current mode is selected.
Various Light Modes

Figure 5: Available Regular Light Modes

4.3 Radar Mode Operation

The Radar Mode Button controls the radar functionality and its associated light patterns.

  • To Turn On Radar: Short press the Radar Mode Button. The indicator light will flash red twice and turn blue.
  • To Cycle Radar Modes: Short press the Radar Mode Button within 5 seconds of the last press.
  • Radar Modes Sequence: Bright → Strobe → Fast Breathing.
  • To Select Radar Mode: If no button press occurs for 5 seconds, the current radar mode is selected.
  • Important: When a radar light mode is selected, it will occupy the corresponding regular light mode to prevent conflict.
Lighting Customization Radar Modes

Figure 6: Radar Optional Light Modes

4.4 Radar Detection and Warnings

The RT01 uses a millimeter-wave radar to detect approaching vehicles.

  • Detection Range: Up to 30 meters behind you, with a 54° horizontal and 27° vertical angle.
  • Warning Trigger: The taillight will trigger a radar warning (flash or change intensity) when a vehicle approaches from behind at a speed greater than yours by more than 10 KM/hour.
  • Filtering: The intelligent chip filters out low-speed moving objects and objects moving at the same speed or far away to avoid false alarms. Pedestrians and waving hands will not trigger the radar.
  • Responsiveness: Senses vehicles in just 0.2 seconds and can detect up to 8 moving objects simultaneously.
Radar Detection Range

Figure 7: Radar Monitoring Scope and Visual Distance

Vehicle Grade Radar

Figure 8: Vehicle Grade Radar in Action

Radar Sensor Responsiveness

Figure 9: Radar Sensor Responsiveness

4.5 Charging

The RT01 is equipped with a high-capacity 1500mAh battery and supports Type-C fast charging.

  • To Charge: Open the waterproof charging plug at the bottom of the product. Insert the Type-C plug of the provided charging cable into the charging port. Connect the USB-A end of the cable to any standard 5V USB charger (not included).
  • Charging Indicator:
    • Red breathing flash: Battery capacity < 99%.
    • Green solid light: Battery capacity > 99% (fully charged).
  • Battery Life: Up to 36 hours of continuous use on a single charge (longer if only radar mode is turned on).
High Capacity Battery

Figure 10: High Capacity Battery and Type-C Charging

4.6 Power Indicator

During operation, the indicator light provides battery status:

  • Blue light: Radar sensing is active.
  • Green light: Battery capacity is ≥ 10%.
  • Red flashing light: Battery capacity is < 10%.

Video 1: CYCLAMI RT01 Product Demonstration

5. Maintenance

  • Cleaning: Wipe the taillight with a soft, damp cloth. Do not use abrasive cleaners or solvents.
  • Waterproof: The RT01 has an IPX6 waterproof rating, protecting it from heavy rain. Do not immerse it in water.
  • Storage: If not using the product for an extended period, fully charge it and store it in a cool, dry place. Recharge the device every three months to maintain battery health.
  • Avoid Disassembly: Do not attempt to disassemble or repair the product yourself. This will void the warranty.
IPX6 Waterproof

Figure 11: IPX6 Waterproof Rating

6. Troubleshooting

  • Light Not Turning On: Ensure the battery is charged. Connect to a charger and check the charging indicator.
  • Radar Not Triggering:
    • Ensure radar mode is active (blue indicator light).
    • The radar only triggers for vehicles approaching from behind at a speed significantly higher than yours. Pedestrians, stationary objects, or objects moving at the same speed will not trigger it.
    • Ensure the radar sensor is not obstructed.
  • Short Battery Life: Ensure the device is fully charged before use. Battery life varies depending on the selected light mode.

7. Specifications

Parameter Comparison Table

Figure 12: Parameter Comparison Table

ParameterValue
ModelRT01
LED20x2835 Ultra bright red light LED
Lumen45 Lumens
Battery1500mAh Polymer Lithium Battery
Run Time4-35H (up to 2100H in radar-only mode)
Charge PortType-C
Net Weight~60g
Appearance Size59 × 39 × 28mm
Sensing MethodRadar capture (Millimeter Wave)
Sensing Distance30m
Firing Range (Visibility)≥500m
Waterproof LevelIPX6
Body MaterialABS Engineering Plastic
CertificationsCE, FCC, RoHS

8. User Tips

  • For maximum battery life, consider using the radar-only mode, which activates the light only when a vehicle approaches.
  • The radar provides visual warnings; it does not emit an audible sound.
  • The light is very bright and visible from a distance, enhancing your safety significantly.
  • Ensure the radar sensor has a clear line of sight for optimal performance.

9. Frequently Asked Questions (FAQ)

Q: Does the RT01 connect to bicycle computers like Garmin, Ryder, or iGPSPORT?
A: No, the CYCLAMI RT01 does not support linking with bicycle computers (ANT+ or Bluetooth). It operates independently.
No Bicycle Computer Linkage

Figure 13: RT01 Does Not Support Bicycle Computer Linkage

Q: Is this product waterproof?
A: Yes, the RT01 has an IPX6 waterproof rating, making it resistant to heavy rain and splashes.
Q: How does the radar signal an approaching car?
A: When the radar detects an approaching vehicle, the taillight will automatically flash or increase its brightness to warn the cyclist and the driver behind.
Q: Does the radar function without a bicycle computer, and does it emit a sound?
A: Yes, the radar functions independently without needing a connection to a bicycle computer. It provides visual warnings through light changes; it does not emit an audible sound.

10. Warranty and Support

CYCLAMI provides a limited warranty for this product. Please refer to the warranty card included in your package for specific terms and conditions. Generally, a 1-year warranty is provided for manufacturing defects, and a 6-month warranty for the battery.

For technical support or warranty claims, please contact your retailer or CYCLAMI customer service.

© 2024 CYCLAMI. All rights reserved.


Documents and downloads

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.