Introduction
This manual provides detailed instructions for the installation, operation, and maintenance of your Zemismart Matter Over WiFi Roller Shade Blinds Motor. Please read this manual thoroughly before installation and use to ensure proper function and safety.

Safety Information
- Ensure the power supply is disconnected before installation or maintenance.
- This motor is designed for indoor use only.
- Do not allow children to play with the motor or controls.
- Ensure all wiring is done by a qualified professional if you are unsure.
- Do not expose the motor to water or excessive humidity.
Package Contents
Please check that all items are present:
- Zemismart Roller Shade Motor (ZM25C)
- Mounting Brackets (2x)
- Tube Adapter
- Instruction Manual (this document)
Note: Mounting screws for brackets are not included and must be provided by the user.
Specifications
| Feature | Detail |
|---|---|
| Model Number | ZM25C (also referred to as ZM2SC in some documentation) |
| Input Voltage | 100-240V AC |
| Rated Power | 30W |
| Max Current | 0.13A |
| Torque | 2Nm |
| Rated RPM | 25 RPM |
| Max Load | 10 KG |
| Connectivity | WiFi, Matter |
| Noise Level | Approx. 27 dB |
| Battery Included | No |
| Origin | Mainland China |


Setup and Installation
The following instructions are derived from the official product instruction sheet.

Installation Steps
- Measure and Mark: Measure the distance between the holes according to your curtain system.
- Drill and Secure: Drill holes in the marked locations and secure the mounting fittings.
- Hang Curtains: Hang the curtains over the secured fittings.
- Complete Installation: Ensure the motor setting button faces outwards and the antenna is exposed for optimal signal reception.
Wiring
Connect the motor to your main power supply as follows:
- Live (L)
- Neutral (N)
- Ground (GND)
The wire for connecting to main power is approximately 90cm long.
Motor Pairing to App (Matter)
A Matter-certified ecosystem smart home app is required (e.g., Apple Home App, Google Home, Alexa).
- Reset Motor: Press the motor set key 5 times quickly. The motor will enter the network configuration state.
- Scan QR Code: Open your selected smart home app and scan the Matter QR code located on the motor.
- Follow App Instructions: Follow the on-screen prompts in your app to add the accessory. This typically involves selecting the accessory, connecting, adding, naming it, and assigning it to a location.
Important: You must use the remote control to set the motor limits before you can control it in the app.
Motor Pairing to Remote Control
- Ensure WiFi is turned on your phone (this step is mentioned in the manual, though its direct relevance to remote pairing is unclear, it's good practice).
- Press the motor setting button 3 times quickly (motor will shake once).
- Press the remote's