BEOK BOT-R6X Tuya Wifi Wireless Thermostat User Manual

1. Product Overview

The BEOK BOT-R6X is an intelligent digital thermostat designed for controlling gas boilers and floor heating systems. It features wireless RF communication between the thermostat unit and the receiver, Wi-Fi connectivity for app control (Tuya Smart/Smart Life), and weekly programmability to optimize comfort and energy saving.

Figure 1: BEOK BOT-R6X Wireless Thermostat and Receiver

Figure 2: BOT-R6X Wireless Thermostat features and included accessories (USB cable, wiring, screws)

2. Setup and Installation

2.1 Physical Installation of Thermostat Unit

The thermostat unit can be mounted on a wall or placed on a desktop.

Figure 3: Thermostat Mounting Options

2.2 Receiver Installation and Wiring

The receiver unit connects directly to your gas boiler or heating system. Ensure power is OFF before wiring.

1. Install an expansion screw sleeve with a spacing of 59mm on the wall.
2. Use a screwdriver to separate the upper cover and the lower cover.
3. Pass the wire through the back cover to the wiring duct, leaving about 20cm of wire.
4. Fix the bottom shell to the wall, then fix the wire, and cover the front shell.

Wiring Diagram for Receiver Connection to Boiler:

Figure 4: Receiver Wiring Diagram

Terminal Descriptions:

• N & L: 110-220Vac input (Power Supply)
• NO(NC) & COM: Dry contact for boiler/heater (Normally Open/Normally Closed, check boiler manual)
• N & NO1: Normally Close (NC) actuator
• N & NC1: Normally Open (NO) actuator
• N & M: Pump

Note: Installation involves strong electricity and should be performed by qualified professionals.

2.3 Code Matching Process (Thermostat to Receiver)

This process establishes the wireless RF connection between the thermostat and the receiver.

1. Power on the Receiving Panel: The power indicator will be steadily on.
2. Enter Pairing Mode on Receiver: Press and hold the code matching button on the receiver for 3 seconds. The code matching indicator will flash.
3. Install Batteries in Thermostat: Insert three AA batteries into the thermostat unit.
4. Enter Pairing Mode on Thermostat: In the POWER ON state, press and hold the ▼ button on the thermostat for 5 seconds.
5. Confirmation: When the code matching indicator light on the receiving panel turns solid, the code matching is successful.

2.4 Wi-Fi Connection and App Setup

The thermostat can be controlled via the Smart Life or Tuya Smart app.

Figure 5: App Control Interface

1. Download App: Search for