WLtoys 104020

Contents

WLtoys 104020 1/10 Electric Four-Wheel Drive Off-Road Rock Crawler

Model: 104020

Brand: WLtoys

1. Introduction

This manual provides essential information for the safe operation, maintenance, and troubleshooting of your WLtoys 104020 1/10 Electric Four-Wheel Drive Off-Road Rock Crawler. Please read this manual thoroughly before using the product to ensure proper function and longevity. This model is designed for users over 14 years old.

2. Safety and Cautions

General Safety Rules

  • Never run the model on public roads or streets, as it could endanger traffic.
  • To prevent property loss or personal injury, do not play in crowded places or near people/animals.
  • Do not operate the car near creeks, ponds, or lakes to prevent it from falling into water.
  • Always follow the correct power-on and power-off procedures to avoid losing control.
  • Never touch or hinder rotating tires.
  • Avoid running the R/C model in the rain or through puddles, as water can cause malfunctions.
  • The motor and battery can become very hot after use; handle them with care.
  • Remove batteries from the model and transmitter when not in use for extended periods.
Safety illustration of RC car driving near traffic and water

Illustration: Avoid operating the RC car near traffic or water bodies.

Cautions When Handling Batteries

  • Do not dismantle the battery or charger, and do not cut any battery cables. This may cause short-circuits or damage.
  • Use only the matching charger to charge the battery according to instructions.
  • Do not recharge a battery that is still warm from use; allow it to cool down first.
  • Remove the remote control battery when not in use for a long time to prevent leakage and damage.
  • Do not place the battery in a hot environment, as it may explode.
Safety illustration for battery handling

Illustration: Proper battery handling and charging.

Additional Safety Precautions

  • The product contains small and sharp parts. Assemble and store out of reach of children.
Safety illustration for small parts and children

Illustration: Warning about small parts and keeping them away from children.

3. Specifications

FeatureSpecification
Scale1:10
Dimensions (L*W*H)568 * 250 * 272mm (22.36 * 9.84 * 10.7 inches)
Wheelbase313mm
Minimum Distance Between Front and Rear Wheels195mm
Motor550 Carbon Brush Motor
SpeedHigh speed: 11 KM/H, Low speed: 3 KM/H (Double speed)
Transmission Ratio1:25.85 / 1:64.6 (Double speed)
Control Channels4 channels
Remote Control2.4G Remote Control (MODE2)
Remote DistanceGreater than or equal to 100 meters
Drive Battery7.4V 3000mAh Lithium Battery
Remote Control Battery4 AAA batteries (not included)
ChargerUSB charging cable
Charging TimeApproximately 5 hours
Working TimeApproximately 45 minutes
Servo25Kg 3-line Ho Server / 9g 3-line server
GearAlloy Gear
MaterialMetal, Plastic
Dimensions and package contents of WLtoys 104020 RC Car

Illustration: Product dimensions and included accessories.

Detailed view of 3-wire metal gear servo and 550 carbon brush motor

Illustration: Internal components including the 3-wire metal gear servo and 550 carbon brush motor.

Undercarriage view showing geometric design and simulated metal oil pressure shock absorbers

Illustration: Geometric design of the chassis and simulated metal oil pressure shock absorbers.

4. Package Contents

The WLtoys 104020 package typically includes:

  • Original Box
  • RC Car (104020 model)
  • Batteries (7.4V 3000mAh Lithium Battery)
  • Operating Instructions (this manual)
  • Charger (USB charging cable)
  • Remote Controller (2.4G)
  • USB Cable
Remote control with labeled parts and ESC radiator + cooling fan

Illustration: Remote control unit with labeled functions.

5. Setup

Tools Needed for Assembly and Maintenance

The following tools are commonly used for assembly and maintenance:

  • 1.5mm Hex Wrench (Turret spanner)
  • Utility Knife
  • Small Screwdriver
  • Side Cutter
  • Crossed Spanner
  • Instant Mucilage Glue
  • Large Screwdriver
  • Scissors
  • Needle Nose Pliers
Tools needed for assembly

Illustration: Common tools for assembly and maintenance.

Battery Charging

  1. Firstly, check and confirm that the input voltage of the charger is consistent with your local voltage, and the output voltage of the charger is consistent with the battery voltage.
  2. Remove the battery from the model car before charging.
  3. Ensure an adult supervises during charging.
Battery charging illustration

Illustration: Battery charging process.

How to Code (Pairing the Remote Control)

  1. Turn on the remote control power switch. The power indicator on the remote control will flash red.
  2. Hold down the counter button on the receiver and then turn on the power switch of the RC car.
  3. At this moment, the indicator on the receiver will flash red. Turn the steering wheel of the remote control or gently pull the trigger.
  4. The power indicator on the remote control will become normally bright, and the indicator on the receiver will also become normally bright, indicating successful pairing.
Pairing process illustration

Illustration: Remote control and receiver pairing steps.

6. Operation Guide

Remote Control Functions

  • Steering Control (Left/Right): Turn the steering control wheel left or right to control the car's turning angle.
  • Throttle Control (Forward/Backward): Pull the throttle trigger backward to move the car forward. Adjusting the angle controls speed. Push the trigger forward to stop the car.
  • Braking/Reverse: Loosen the trigger to return it to neutral for braking. Pushing the throttle trigger forward from neutral will engage reverse.
  • Shift Switch: Push up for high speed (H), push down for low speed (L).
  • Winch Switch Button: Cycle trigger function for winch (set-off-off-off-off-off).
  • SET Function Key (Lights):
    • Press twice to switch between far and near light modes.
    • Press three times to enter light demonstration mode.
    • Long press to switch the light mode on/off.
  • Constant Speed Cruise and Throttle Proportional Speed Adjustment Knob: Adjust speed in cruise control mode.
  • Automatic Sleep Function: The remote control will automatically enter hibernation after 5 minutes of no operation. Re-turn off and on to resume normal operation.
Remote control operation illustrations (steering, throttle)

Illustration: Steering and throttle control on the remote.

Driving Practice and Maintenance

To master control, place empty tank barricades (road markers) in a spacious and safe area. Practice accelerating on straightaways and decelerating on curves. Keeping your eye's point of view slightly ahead of the vehicle helps in passing obstacles. Once you can navigate obstacles freely, you can try driving on a track. Interacting with friends on the track will enhance your RC experience.

Driving practice illustration

Illustration: Recommended driving practice setup.

7. Maintenance

  • When the car is not in use, remove the battery from the car.
  • Completely remove sand, mud, dirt, and other debris from the car after use.
  • Apply rust prevention oil to exposed metal parts.
  • Store the car and batteries separately when not in use for extended periods.
Maintenance illustrations (battery removal, cleaning, oiling, storage)

Illustration: Steps for proper maintenance and storage.

8. Troubleshooting

DescriptionCauseSolution
The car does not operate at all.Transmitter or receiver is off.Turn on both transmitter and receiver.
Battery is not properly placed in the remote control.Place batteries correctly in the transmitter.
Drive battery is not charged enough.Charge the drive battery.
The car does not follow your operation or control distance is not long enough.Someone else is using the same radio frequency.Wait until the other driver finishes or drive your car in a different place.
Remote control battery is low.Replace the remote control battery.

9. Assembly Exploded Views

The following diagrams provide exploded views of various components, useful for assembly, disassembly, and part identification.

Front/Rear Pull Rods and Steering Gear

Exploded view of front/rear pull rods and steering gear

Diagram: Exploded view of the pull rod and steering gear assemblies.

Differential Assembly

Exploded view of differential assembly

Diagram: Exploded view of the differential components.

Gearbox and Tire Assembly

Exploded view of gearbox and tire assembly

Diagram: Exploded view of the gearbox and tire assembly.

Central Drive Shaft and Shock Absorbers

Exploded view of central drive shaft and shock absorbers

Diagram: Exploded view of the central drive shaft and shock absorber components.

Motor, Steering Gear, and Central Gearbox

Exploded view of motor, steering gear, and central gearbox

Diagram: Exploded view of the motor, steering gear, and central gearbox.

10. Sale Parts View

The following images provide a comprehensive view of all individual parts available for the WLtoys 104020, useful for identification and replacement.

Sale parts view 1

Diagram: Sale parts view, page 1 (components like baffle group, fender group, crash parts, etc.).

Sale parts view 2

Diagram: Sale parts view, page 2 (components like tires, central drive shaft, steering gear, etc.).

Sale parts view 3

Diagram: Sale parts view, page 3 (components like differential, gearbox, shock absorbers, etc.).

Sale parts view 4

Diagram: Sale parts view, page 4 (components like bearings, motor, battery, etc.).

11. User Tips

  • Greasing Axles and Transmission: It is highly recommended to disassemble the axles and transmission to properly grease them, as they may come with very little stock grease.
  • Suspension Adjustment: The stock suspension can be quite hard. To improve smoothness, consider disassembling the shocks, removing an O-ring, draining the oil, and adding a few drops of 100cs oil.
  • Splash-Proofing (NOT Waterproofing): For enhanced protection against splashes, you can apply nail polish to the circuits and electronic parts. Note that this does not make the vehicle fully waterproof.

12. Frequently Asked Questions (FAQ)

Q: Is the WLtoys 104020 waterproof?
A: The product is not fully waterproof. While it can handle splashes, it is not designed for submersion or heavy rain. For better splash resistance, some users apply nail polish to electronic components.
Q: Does this version have a winch?
A: The remote control includes a winch switch button with a cycle trigger function (set-off-off-off-off-off), indicating winch functionality. Please refer to the remote control diagram for its location.

13. Warranty and Support

Warranty

This product comes with a one-month warranty from the date of purchase. Please retain your proof of purchase for warranty claims.Additional Resources

For a detailed user manual in PDF format, you can view or download it from the following link: WLtoys 104020 User Manual (PDF)

© 2024 WLtoys. All rights reserved.


Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.