MEKEDE Car Intelligent System User Manual

1. Introduction

Thank you for trusting and purchasing our MEKEDE car multimedia system. To ensure effective and safe use of your device, please read these instructions carefully before use.

Note: Due to the continuous improvement of our products, some descriptions in this manual may differ from the actual equipment. Specifications are subject to change without notice.

Product Overview

The MEKEDE Car Intelligent System is a multimedia player designed for Fiat 500 Abarth models from 2007 to 2015. It features a high-resolution display, powerful 8-core processor, and extensive connectivity options including Wireless CarPlay, Android Auto, GPS, 4G LTE, and 5G WiFi. It also includes a cooling fan for optimal performance and a DSP for enhanced audio.

2. Safety Measures

1. It is forbidden to watch videos or other visual accessories while driving! Active use of the system during driving is not recommended because it can reduce attention and may result in violation of traffic laws and road accidents.
2. The unit is designed for use in cars with a 12V power supply and a minus ground. Do not install the system in a bus or truck with an on-board voltage of 24V. This may cause damage to the device.
3. Use a special cleaning device to take care of the screen.
4. To avoid overheating of the device, do not allow direct exposure to sunlight and do not install near the heating system. Operating temperature is between 0°C and 35°C. If the temperature inside the vehicle is too high, it is necessary to cool the interior before switching on the system. It is also not recommended to operate the unit at very low temperatures. It is necessary to wait until the temperature of the interior and the vehicle returns to normal. When the temperature is low, the image on the screen may change with a delay. This is not a malfunction. Wait until the multimedia system reaches the operating temperature.
5. Only use the fasteners provided (screws, mounting frames, etc.) for installation. The use of other fasteners may result in damage to the system, and this is not covered by the warranty.
6. Installation and connection of the device shall be performed by a qualified specialist, or specially trained staff of the service center.
7. Do not reset to factory settings on your own unless in extreme cases, as this will cause loss of your settings, which may result in incorrect operation of the system.
8. Violation of the above items and improper use may cause the system to malfunction. In this case the warranty service will not be performed.

3. Package Contents

The package includes the main multimedia unit and the following accessories:

• RCA Cable
• Audio Out Cable
• Reversing Camera
• GPS Antenna
• 4G Antenna
• Microphone (MIC)
• USB Plugs (2 for M200S/M400S models, 3 for M300S/M500S/M600S/M700S/M800S models)

4. Technical Specifications

5. Device Overview

Front Panel Control

The front panel of the multimedia system includes the following controls:

1. Microphone
2. Emergency reassembly of equipment (Reset button)
3. Input/output switch / Live switch / Sound switch
4. Return to main menu
5. Switching back to the previous menu
6. Increase volume
7. Lower the volume

Turning On/Off the Device

• Switching on: After switching off the ignition and starting the engine, the multimedia system is automatically switched on. The display shows the initial screen.
• Exception: The unit activates automatically after the engine is switched off.

Touch Screen Operation

This unit is equipped with an interactive touchscreen display. Before using it for the first time, the sealed plastic membrane must be removed. Otherwise the touch screen may not function properly.

• Touch: Click the necessary item with your finger to start the plugin (signal source) or select the menu item (option).
• Double Tap: A quick double touch allows you to resize when viewing images.
• Touch & Hold: Click and hold the item for 2 seconds to trigger an additional action available for that item.
• Dragging: Touch and hold the selected item, then drag it onto the screen.
• Moving: Rotate the screen with your finger and keep your finger touched, move your finger in the right direction throughout the screen.
• Scroll through: Move your finger on the screen in the direction you need to and let go. Rotation can be stopped by touching the screen, or wait until the motion stops itself.

Attention! Do not use metal or sharply sealed objects to control sensory interactive display. Also don't apply excessive force when touching the screen.

6. Operating Features

Main Interface Customization

You can customize the position of icons on the main interface, and all applications can be freely edited according to the position of the quick menu bar to facilitate the driving experience.

You can also set a picture or a photo as a background for the main screen. Choose from installed Live Spreadsheets (Live wallpaper) and Spreadsheets (wallpaper) or from images/photos stored on a USB memory device or SD memory card.

FM/AM Radio

To access the Radio, click the appropriate icon (Radio) on the main menu. You can quickly select the desired frequency by tapping on the scale bar.

• Main menu: Access radio functions.
• FM switching group: Switch between FM bands.
• LOC mode or DX mode: "LOC" receives strong signals only; "DX" receives all stations.
• MONO mode: For single channel audio.
• Automatic scanning: Scan for available stations.
• Save station: Save current station to presets.
• Additional adjustments: Fine-tune radio settings.
• List of saved stations: View and select saved stations.

DSP Processor/Equalizer

The system is equipped with a DSP chip for advanced sound settings. To access the equalizer (EQ) options, press the (Radio) or (Equalizer) icon on the menu.

• Equalizer mode: Adjust sound using 32 bands, with presets like Rock, Soft, Jazz, Pop, Classical, Hall.
• Automatic volume mode: Choose recommended settings for listener position (Driver Mode, Passenger Mode, Rear, Center) or adjust manually.
• Balance mode: Adjust volume ratio of speakers by moving a point on the car interior diagram. Supports parametric bass tuning.
• Bass Enhancement: Reverse high and low frequency tones, change boost factor.
• Bass filter: Set desired frequency for each speaker (Front Dynamics / Rear Dynamics).

Music / Video Playback

Connect a USB storage device or insert an SD memory card and press (music) for music playback or (video) for video playback.

Supported video formats include RMVB, MKV, MOV, WMV, AVI, MPG, TS, H.264 codec and others.

Attention! Given the security of the video, you cannot view it while the car is in motion. To view the video, stop in a safe place and apply the handbrake.

Bluetooth (BT)

In the main menu, click the "BT" icon to enter the BT hands-free interface. Open your phone's BT "search for new devices" function. When the system and phone connect, you will be prompted to confirm the connection and enter the password (0000). The system screen will show "connected" upon successful connection.

• Call log
• Dialing interface
• Telephone book
• BT music
• Check connection
• BT settings

Car Link (CarPlay/Android Auto)

Car Link is an add-on that allows you to use your iPhone and Android in the car without being distracted from the road. By connecting your iPhone / Android to Car Link you can use the satellite navigation system, make calls, send and receive messages, listen to music and do many other things.

Connection steps:

1. Connect the mobile phone and car DVD player with a USB cable.
2. Tap on "Car Link"; the phone will ask for authorization to connect. Authorize the connection and wait for completion.

Split Screen

On the screen of the main device, you can display two additional devices simultaneously, such as the navigation program and music. To exit split screen mode, pull the icon between the two screens to the right.

MAP Navigation

The system features a built-in global positioning system, omnidirectional map display, synchronous real-time traffic display, and fast and accurate positioning. Supported navigation APPs include Navitel, IGO, Yandex, and Google.

Cooling Fan

The cooling fan helps to deal with and solve abnormal operation caused by high temperature in summer and long-term use of the machine, such as restart, abnormal touch, abnormal function, etc. This feature is available on M200S-M800S models.

Setup steps:

1. Go to Settings > Device > Sound.
2. The cooling fan starts working.

4G LTE

Connected to 4G, you can watch live video, listen to music online, play games, and watch movies, making your car seamlessly connected to the Internet at any time.

To install the SIM card:

1. Push the iron plate down and open it.
2. Insert the SIM card.
3. Pull up the iron plate to fix the SIM card in place.

Language Settings

To change the main menu language, go to Settings > Language & Input. Select the desired language and press and hold the button to move it to the first position.

Lantern Settings (RGB)

The device has a multicolor illumination and can be set to different modes of light. Select the light you want or set it to automatic color change.

7. Additional Features

Note: Additional accessories must be purchased to use the following features.

• DAB+ Radio: Universal for all Android radios, providing better sound quality and stronger signal.
• OBD II: Monitor real-time data and fault codes from the on-board computer.
• TPMS (Tire Pressure Monitoring System): Sensors automatically monitor tire pressure and temperature, transmitting real-time statistics to the receiver.
• AV Output: Output displayed content, allowing rear passengers to watch HD video and audio through the video cable from the navigation console on the headrest display screen.
• 360° Camera: If you want to add a 360 camera, it must be ordered along with your car radio, as a built-in 360 Camera Chip is needed on the motherboard.
• ADAS DVR (Advanced Driver-Assistance Systems Digital Video Recorder): Driving recorder with collision warning, predicting distance to the vehicle in front, warning of collision, and lane departure warning. Activation is done in the settings menu.
• AHD HD Reversing: Automatic activation of video input for sharper image quality than conventional cameras.

8. Installation

Rear Camera Connection Method

Without CANBus Box:

1. Connect the Rear Camera Control to G5.
2. Connect the 12V Reverse Light Power Supply.
3. Connect GND to Car Ground.

With CANBus Box:

Note: Connection of the yellow line will not be needed if you already have a CANBus box and the reverse control line (G3 area) has been connected to the CANBus box.

1. Connect ACC to G3 ACC.
2. Connect the two red wires (camera power supply) together; do not connect with other wires.
3. Connect GND to Car Ground.

CANBus Box

Please note! If the original functions of your car cannot be used (steering wheel control AC...), this CANBus type needs to be set. Before setting up CANBus, please check your CANBus photo. Then select the corresponding CANBus type!

Setup steps:

1. Connect as shown in the picture.
2. Go to Settings > Car Settings > Factory (Password: 8888).
3. Select the appropriate CAN Box type (e.g., Hiworld, OD/oudi, RZC/Raise, LZ(HZ)/Luzheng, XP/XINPU/Simple Soft, BNR/binarui, daojun/Dogen-Electronics, XBS/xinbasi).

Note: The cable must be plugged in for the WIFI to work properly.

Device Connector Pinout Diagram

Make sure the wires are properly connected. Incorrect connections may cause device faults.

Interface Area AB, Pin Details (RCA Audio and Video Input and Output / 360° Panoramic Device):

Interface Area CDEF, Pin Details (Digital TV, CAN / One USB Interface / Double USB Interface / Reverse Video Cable):

Power Cable Interface Details:

9. Troubleshooting

If you encounter a problem, try disconnecting and then reconnecting your device. Use the special key to press the Reset button. If this does not solve the problem, please refer to the table below. These instructions will help you to solve the problem if the device does not work properly. Otherwise, check that the device is properly connected or consult your authorized dealer.

10. User Tips

• Ventilation: Ensure that the air vents around the screen are not covered to prevent overheating, especially during prolonged use or in hot weather. The built-in cooling fan (on M200S-M800S models) helps manage temperature, but proper airflow is still crucial.
• Package Contents: Upon receiving your unit, verify that all necessary cables, including CANBus (if applicable to your car model), and camera are included as expected.
• CarPlay/Android Auto: For seamless integration, ensure your phone's Bluetooth is connected and you grant all necessary permissions when prompted by the 'Car Link' application.

11. Warranty and Support

The MEKEDE Car Intelligent System comes with a 1-year warranty. For any issues not covered in the troubleshooting section, please consult a qualified specialist or the service center. Improper installation or use may void the warranty.

For further assistance, please refer to the official MEKEDE support channels.