1. Product Overview
The LetonPower Sealion Series Diving Flashlight is designed for underwater photography and video fill light, offering powerful illumination and robust waterproof capabilities. This manual provides essential information for the safe and effective use of your diving flashlight.

Figure 1: LetonPower Sealion-L24 Diving Flashlight, highlighting its use for underwater shooting with Red, Blue, and White light options, and 22800 lumens output.
2. Package Contents
Please check the contents of your package upon unboxing. The exact items may vary slightly depending on the model purchased (Sealion-L12, L15, or L24).
Video 1: Unboxing and component overview of the LetonPower Diving Flashlight, showing the flashlight, battery holder, batteries, charging cable, wrist strap, spherical arm head, and other accessories.
Typical Contents (Sealion-L24 Example):
- 1 * Sealion-L24 Diving fill light flashlight
- 1 * Type-C charging cable
- 1 * Wrist strap
- 1 * Ball handle bracket
- 1 * Waterproof Lubricant
- 1 * L type screwdriver
- 3 * O-rings
- 1 * Hard shell rainproof storage tote bag

Figure 2: Detailed view of the Sealion-L24 package contents, including the flashlight, charging cable, wrist strap, ball handle bracket, lubricant, screwdriver, O-rings, and storage bag.
3. Setup Instructions
3.1 Battery Installation
- Unscrew the tail cap of the flashlight by turning it counter-clockwise.
- Insert the three 21700 batteries into the battery holder, ensuring correct polarity (+ and - ends match the markings).
- Place the battery holder with batteries into the flashlight body.
- Screw the tail cap back on clockwise until it is securely tightened.

Figure 3: Illustration of the 21700 large capacity lithium battery compartment and Type-C charging interface.
3.2 Initial Charging
The flashlight uses 21700 batteries with a built-in Type-C charging interface. Connect the provided Type-C USB cable to the battery holder's port and a suitable USB power source to charge the batteries.
3.3 Attaching Accessories
- Spherical Arm Head: Attach the spherical arm head to the designated mounting point on the flashlight body using the provided screw and L-type screwdriver. This allows for connection to camera mounts and other diving accessories.
- Wrist Strap: Secure the wrist strap through the loop on the flashlight for added security during use.

Figure 4: The flashlight with an attached spherical arm head, demonstrating its use with camera mounts for underwater photography.
3.4 Pre-Dive Check
Important Note: After receiving the diving flashlight, please tighten the flashlight body and tail cap securely before lighting the switch for the first time to ensure waterproof integrity.
4. Operating Instructions
The flashlight features dual on/off buttons and dual LED indicators for intuitive control.

Figure 5: Diagram showing the dual on/off buttons, LED indicators, and various light modes (High, Medium, Low, Red, Blue, Flash).
4.1 Power On/Off
- To turn on the flashlight, press either the left or right button.
- To turn off the flashlight from any mode, press and hold either switch for two seconds.
4.2 White Light Control (Left Button)
Press the left button to cycle through the white light modes:
- Mode 1: White light high brightness
- Mode 2: White light with moderate brightness
- Mode 3: White light low brightness
Land Use Recommendation: If using the flashlight on land, low brightness is recommended. High brightness generates significant heat, which can cause the flashlight to get hot. The flashlight will automatically reduce brightness if it overheats to protect components.
4.3 Red/Blue Light Control (Right Button)
Press the right button to cycle through the red and blue light modes:
- Mode 1: Red light (wavelength 620nM)
- Mode 2: Red light flashing
- Mode 3: Blue light (wavelength 455nM)
- Mode 4: Double-click the right switch (from any mode) to activate red and blue flashing.
4.4 Dimming Operation (Fine-tuning for shooting)
This feature allows for fine-tuning the light output during underwater shooting:
- White light + Red light
- White light + Blue light
4.5 Switch Indicator Light (Battery Level)
The LED indicator provides real-time battery status:
- When the battery level is greater than 30%, the indicator light will turn blue.
- When the battery level reaches 5%-30%, the indicator light turns red.
- When the battery is low (below 5%), the indicator light will flash for 10 seconds and then turn off.
5. Maintenance
Proper maintenance ensures the longevity and optimal performance of your diving flashlight.
- Post-Use Cleaning: After each use, especially in saltwater, thoroughly clean the diving lamp and all equipment with fresh water.
- O-Ring Care: Regularly clean, lubricate, and inspect the O-rings. This is crucial for maintaining the waterproof seal and extending the flashlight's lifespan. Replace O-rings if any damage is observed.
- Battery and Electrical Contacts: Keep the battery terminals and electrical contacts clean to ensure good conductivity.
- Long-Term Storage: If the diving flashlight will not be used for an extended period, remove the batteries to prevent leakage and corrosion. Store batteries separately in a cool, dry place.
- Charging Practices: Begin charging the batteries when the light output starts to dim. This prevents over-discharge and helps prolong battery life.
- Storage Conditions: Store the diving light in a cool, dry place, away from direct sunlight and extreme temperatures.
6. Troubleshooting
- Flashlight not turning on: Ensure batteries are correctly installed with proper polarity and are sufficiently charged. Check that the tail cap is fully tightened.
- Light output is dim or inconsistent: Charge the batteries fully. Clean battery contacts. Ensure the flashlight body and tail cap are securely tightened.
- Flashlight gets hot and dims automatically on land: This is normal behavior for high-power lights. The flashlight's protection mechanism reduces brightness to prevent overheating. Use lower brightness settings when operating on land.
- Water leakage: Immediately turn off the flashlight and remove batteries. Inspect all O-rings for damage, dirt, or improper seating. Ensure all caps and seals are clean and securely tightened before next use. If leakage persists, contact support.
7. Specifications
7.1 Model-Specific Specifications
| Model | Lumen | CCT | Runtime (Strong/Middle/Weak) | Battery | Waterproof | Beam Angle | Weight (In Water/On Land) |
|---|---|---|---|---|---|---|---|
| Sealion-L12 | 8000 Lumen | 6000K CRI:90+ | 90min/300min/600min | 21700 (13500mAh) | 100M IPX68 | 120° | 220g/584g (With battery) |
| Sealion-L15 | 10000 Lumen | 6500K CRI:90+ | 80min/270min/540min | 21700 (13500mAh) | 100M IPX68 | 120° | 230g/591g (With battery) |
| Sealion-L24 | 12000 Lumen | 6500K CRI:90+ | 70min/240min/480min | 21700 (13500mAh) | 100M IPX68 | 120° | 225g/588g (With battery) |
7.2 General Specifications
- Wattage: 65W
- Body Material: Aluminum
- Lighting Distance: > 500 meters
- Certification: CCC, CE, CQC
- Is Batteries Included: No (typically sold separately or as an option)
- Waterproof: Yes (IPX68 rated for 100m depth)
8. User Tips
- Always ensure the flashlight body and tail cap are securely tightened before any use, especially underwater, to maintain waterproof integrity.
- For optimal performance and safety, remove batteries if the flashlight will not be used for an extended period.
- When using the flashlight on land, opt for lower brightness settings to prevent overheating and automatic dimming.
- The flashlight provides a wide-angle, diffused light, making it excellent for underwater video recording without a harsh spotlight effect.
- Keep spare O-rings and lubricant handy for regular maintenance to ensure long-term reliability.
9. Warranty and Support
For any product inquiries, technical support, or warranty claims, please contact the manufacturer directly:
Shenzhen Debo Information Technology Co., Ltd
Email: letonpower@Foxmail.com
Address: C302, building C, Antonio, No. 17, Wan'an Road Shajing street, Bao'an District Shenzhen, GuangDong China
Please refer to your purchase documentation for specific warranty terms and conditions.