MEKEDE WIFI+4G Carplay Android Auto Multimedia Player

1. Introduction

Thank you for choosing the MEKEDE WIFI+4G Carplay Android Auto Multimedia Player. This manual provides detailed instructions for the safe and effective use of your device. Please read it carefully before installation and operation. Note that due to continuous product improvements, some descriptions may differ slightly from the actual equipment. Specifications are subject to change without notice.

This multimedia player is designed to enhance your driving experience with features like GPS navigation, multimedia playback, Bluetooth connectivity, and smartphone integration (CarPlay/Android Auto).

2. Safety Measures

• It is forbidden to watch videos or use other visual accessories while driving. Active use of the system during driving is not recommended as it can reduce attention and may result in traffic violations or accidents.
• The unit is designed for use in cars with a 12V power supply and a negative ground. Do not install the system in a bus or truck with an on-board voltage of 24V, as this may cause damage to the device.
• Use a special cleaning device to take care of the screen.
• To avoid overheating, do not allow direct exposure to sunlight and do not install near the heating system. Operating temperature is between 0°C and 35°C. If the vehicle interior temperature is too high, cool the interior before switching on the system. Do not operate the unit at very low temperatures. Wait until the interior and vehicle temperatures return to normal. When the temperature is low, the image on the screen may change with a delay, which is not a malfunction.
• Only use the fasteners provided (screws, mounting frames, etc.) for installation. Using other fasteners may result in damage to the system, which is not covered by the warranty.
• Installation and connection of the device shall be performed by a qualified specialist or specially trained staff of a service center.
• Do not reset to factory settings on your own unless in extreme cases, as this may cause loss of your settings and incorrect operation of the system.
• Violation of the above items and improper use may cause the system to malfunction. In such cases, warranty service will not be performed.

3. Package Contents

The package includes the following components:

Diagram showing the main unit, power cable, RCA cables, reversing camera, USB cables, and antennas.

• Main Unit (Machine)
• Power Cable
• RCA Cable
• Reversing Camera (Optional, depending on model)
• USB Cable (2 or 3, depending on model)
• GPS Antenna
• 4G Antenna (for models with 4G LTE)
• MIC (Microphone)

4. Technical Specifications

5. Setup & Installation

5.1. Connection Diagram

Refer to the diagram below for proper wiring and connections.

Visual representation of the multimedia player installed in a KIA Carens dashboard, showing before and after installation.

The diagram illustrates the various connections including RCA cables, audio out, reversing camera, GPS antenna, 4G antenna, and microphone. Specific USB plug configurations are shown for M200S/M400S (2 USB plugs) and M300S/M500S/M600S/M700S (3 USB plugs).

5.2. Rear Camera Connection Method

Without CANBUS Box

1. Connect the reversing control line to A5.
2. Connect the reversing light 12V to the 12V Reverse Light Power Supply.
3. Connect GND to Car Ground.

With CANBUS Box

If you have a CANBUS box and the reverse control line (A3 area) has been connected to the CANBUS box, the yellow line connection is not needed. Just connect the two red wires (camera power supply) together; do not connect with other wires.

5.3. CANBus Box Configuration

Important Note: If original car functions (like steering wheel control) are not working, the CANBus type needs to be set. Before setting up CANBus, check your CANBus photo and select the corresponding type.

Setup steps for TS7, T3L, TS18, TS10, M100, M150, Y1, Y2, TS100, TS150, TS200 models:

1. Connect as shown in the picture (refer to the connection diagram on page 9 of the PDF manual).
2. Go to Settings > Car Settings > Factory (Password: 8888).
3. Select the appropriate Car Model under the CANBus settings.

6. Operating Instructions

6.1. Front Panel Control

The front panel features various controls:

1. Microphone
2. Emergency reassembly of equipment
3. Input/output switch / live switch / sound switch
4. Return to main menu
5. Switching back to the previous menu
6. Increase volume
7. Lower the volume

6.2. Turning On/Off the Device

Switching on: The multimedia system automatically switches on after the ignition is switched off and the engine starts. The display will show the initial screen. The unit activates automatically after the engine is switched off.

6.3. Touch Screen Operation

This unit is equipped with an interactive touchscreen display. Before first use, remove the sealed plastic membrane. Otherwise, the touch screen may not function properly.

• Touch: Click the necessary item with your finger to start the plugin (signal source) or select the menu item (option).
• Double Tap: A quick double touch allows you to resize when viewing images.
• Touch & Hold: Click and hold the item for 2 seconds to trigger an additional action available for that item.
• Dragging: Touch and hold the selected item, then drag it onto the screen.
• Moving: Rotate the screen with your finger and keep your finger touched, move your finger in the right direction throughout the screen.
• Scroll through: Move your finger on the screen in the direction you need to and let go. Rotation can be stopped by touching the screen, or wait until the motion stops itself.

Attention! Do not use metal or sharply sealed objects to control the sensory interactive display. Also, do not apply excessive force when touching the screen.

6.4. Main Menu Interface & Wallpaper

You can customize the position of icons in the main interface, and all applications can be freely edited according to the position of the quick menu bar for easy operation.

Image showing the customizable main interface, split screen, AHD reversing, and Bluetooth function.

Change wallpaper of main menu interface: You can set a picture or a photo as a background for the main screen. Choose from pre-installed Live Spreadsheets (Live wallpaper) and Spreadsheets (wallpaper), or from images/photos stored on a USB memory device or SD memory card.

6.5. FM/AM Radio

To access the Radio, click the appropriate icon (Radio) on the main menu.

• Main menu: Access radio settings.
• FM switching group: Switch between FM bands.
• LOC mode or DX mode: 'LOC' receives strong signals only; 'DX' receives all stations in the current range.
• MONO mode: Select mono audio.
• Automatic scanning: Scan for available stations.
• Save the station: Store favorite stations.
• Additional adjustments: Fine-tune settings.
• List of saved stations: View and select stored stations.

By tapping on the scale bar, you can quickly select the desired frequency.

6.6. DSP Processor / Equalizer

To access the equalizer (EQ) option, press the (Radio) or (Equalizer) icon on the menu. The device is equipped with a DSP chip for advanced sound settings.

• Equalizer mode: Adjust sound using different frequency settings (32 bands). Presets like Rock, Soft, Jazz, Pop, Classical, Hall are available.
• Automatic volume mode: Choose recommended settings for listener position (Driver Mode, Passenger Mode, Rear, Center) or adjust independently.
• Balance mode: Adjust the volume ratio of speakers for comfortable sound, including parametric bass tuning.
• Bass Enhancement: Reverse high and low frequency tones, change boost factor.
• Bass filter: Set desired frequency for each speaker.

6.7. Music / Video Playback

Connect a USB storage device or insert an SD memory card. Press the (music) icon for music playback or (video) icon for video playback.

Supported video formats include: MP4, AVI, MMV, MOV, MKV, MPEG, RMVB, etc.

Attention! For safety, video playback is disabled while the car is in motion. To view videos, stop in a safe place and apply the handbrake.

6.8. Bluetooth (BT) Function

In the main menu, click the "BT" icon to enter the BT hands-free interface. Simultaneously, enable the phone's BT "search for new devices" function. When the system and phone connect, the phone will prompt for authorization. Select "yes" and enter the password (0000) to confirm. The system and phone will link, and the system screen will show "connected", indicating a successful connection.

• Call log
• Dialing interface
• Telephone book (synchronize contacts)
• BT music
• Check connection
• BT settings

6.9. Car Link (CarPlay / Android Auto)

Car Link is an add-on that allows you to use your iPhone and Android in the car without being distracted. By connecting your smartphone to Car Link, you can use the satellite navigation system, make calls, send and receive messages, listen to music, and more.

Connection steps:

1. Connect your mobile phone and car DVD player with a USB cable.
2. Tap on "Car Link". The phone will ask for authorization to connect. Authorize the connection and wait for it to complete.

6.10. Split Screen

On the screen of the main device, you can display two applications simultaneously, for example, the navigation program and music. To exit split screen mode, pull the icon between the two screens to the right.

6.11. MAP Navigation

The unit features a built-in global positioning system with omnidirectional map display, synchronous real-time traffic display, and fast and accurate positioning.

Supported navigation APPs include: Navitel, IGO, Yandex, Google.

6.12. Cooling Fan

The cooling fan helps dissipate heat and prevent overheating. The cooling fan starts working automatically when needed.

6.13. 4G LTE Connectivity

With 4G LTE connectivity, you can watch live video, listen to music online, play games, watch movies, and keep your car seamlessly connected to the Internet.

SIM Card Installation:

1. Push the iron plate down and open it.
2. Insert the SIM card.
3. Pull up the iron plate to fix the SIM card in place.

6.14. Language Settings

To change the system language, go to Settings > Language & Input. Select your preferred language and move it to the first position.

6.15. Launcher App Setting

The device has a multicolor illumination and can be set to different modes of light. You can select the light color or set it to automatic color change via the settings menu.

7. Additional Features

Note: Additional accessories must be purchased separately to use the following features.

Image illustrating FM/RDS Radio, OBD II, DSP Processor, and Button Light features.

Image illustrating 5GHz WIFI, Built-in 4G LTE and WIFI, Resolution, and Cooling Fan features.

• DAB+ Radio: Universal for Android radios, providing better sound quality and stronger signal. (For EU countries only)
• OBD II: Monitor real-time data and fault codes from the on-board computer.
• TPMS (Tire Pressure Monitoring System): Automatically monitors tire pressure and temperature, transmitting real-time statistics to the receiver.
• AV Output: Output displayed content to rear headrest displays for HD video and audio.
• 360° Camera: Requires a built-in 360 Camera Chip on the motherboard.
• ADAS DVR (Advanced Driver-Assistance Systems Digital Video Recorder): Provides collision warning, distance prediction, and lane departure warning. Activated in the settings menu.
• AHD HD Reversing Camera: Provides sharper image quality for rear view video. Automatically activates video input when reversing.

8. Troubleshooting

If you encounter problems, try disconnecting and then reconnecting your device. Use the special key to press the Reset button. If this does not solve the problem, refer to the table below. These instructions will help you solve the problem if the device does not work properly. Otherwise, check that the device is properly connected or consult your authorized dealer.

9. User Tips

• For KIA Carens 2013 models, ensure you have the correct frame for installation, as some car radios may require it.
• The unit supports steering wheel controls and rear camera integration, even with original screen radios.

10. Warranty & Support

This product comes with a 365-day warranty from the date of purchase. Please retain your proof of purchase for warranty claims.

For technical support or further assistance, please visit the MEKEDE & NAVIFLY website: www.mekede.com.

You can also refer to the official user manual PDF for more detailed information: User manual (PDF)

11. Product Demonstration Video

Watch this video for a visual guide on the product's features and user interface, including music playback, video playback, Bluetooth connectivity, Wi-Fi setup, file management, and system settings.

Video demonstrating the MEKEDE M90S multimedia player's user interface and core functionalities.