1. Introduction
Thank you for choosing the TIESFONG A7WB Multi-Channel Dash Cam. This device is designed to provide comprehensive video recording for your vehicle, offering front, cabin, and rear views with advanced features like 24H parking mode, GPS, WiFi, and IR night vision. This manual will guide you through the setup, operation, and maintenance of your dash cam to ensure optimal performance.
Figure 1.1: TIESFONG A7WB Dash Cam highlighting 3-channel recording, built-in radar, IR+WDR, GPS, radar sensor, 2K+1080P resolution, 170° wide angle, and built-in parking monitor.
2. Setup
2.1 What's in the Box?
Please check the package contents upon unboxing:
- TIESFONG A7-WB Dash Cam (Host)
- Rear Camera with cable (18 ft)
- TIESFONG P7 Hardwire Kit (8.53 ft)
- OBD Connecting Cable (1.64 ft)
- Fuse Connecting Cable (0.98 ft)
- Fuse Wire (0.49 ft)
- Type-C USB Backup Cable (1.97 ft)
- TIESFONG Micro SD Card (Capacity may vary based on package)
- Adhesive Sticker
- Electrostatic Sticker
- User Manual
Figure 2.1: Example kit contents including the A7WB-Host, CPL Filter (optional), OBD/P7 Power Cable, 64GB SD Card, and User Manual.
2.2 Camera Overview
Familiarize yourself with the dash cam's components:
| No. | Name | Description |
|---|---|---|
| 1 | POWER | Type-C USB port for power on |
| 2 | Δ | Memory Card Slot (For inserting Micro SD Card) |
| 3 | ED | 2.5mm Round hole interface for connect with Rear Cam |
| 4 | M | Menu/Mode Button |
| 5 | Δ | Up/Previous Button |
| 6 | ن | OK/Confirm Button |
| 7 | ▽ | Down/Next Button |
| 8 | OK | OK/Confirm Button |
| 9 | LED Indicator | Blue light always bright: powered on (not recording). Blue light blinking: recording in progress. |
| 10 | Brackets | Used to fix recorder |
| 11 | 210 | Radar Switch |
| 12 | ON OFF | Radar Working Light |
| 13 | ӨӨ | IR LED Light (4 IR LED lights enhance night vision in car) |
| 14 | Cabin Cam | Camera for in-car video recording (Tear off protective film before use) |
| 15 | ((0000)) | Radar Sensor Surface |
| 16 | Front cam | Front Facing Camera for video recording road events (Tear off protective film before use) |
| 17 | O | Radar Sensor Light |
2.3 Installation Guide
2.3.1 Install Memory Card
- Insert a new TF card into the card slot and then power on the recorder.
- After the dash cam is turned on, press the M Key to enter the Menu Interface.
- In the Menu Interface, press ▽ Key to switch to 'Format Card', and press OK Key to enter.
- Select 'YES' and press OK to confirm formatting.
- A yellow frame