1. Introduction
Thank you for choosing the SUMWEE 86X Intelligent Background Music Controller Host. This device has undergone strict quality testing to ensure optimal performance. It is designed for use in high-end residences, villas, senior clubs, hotels, and other music venues, providing a smart and high-fidelity audio experience. Please read this manual carefully before installation and commissioning to ensure proper setup and operation.

The SUMWEE 86X Wall Amplifier supports various audio sources including Bluetooth, TF card, USB disk, and AUX input, offering versatile playback options. It features a sleek tempered glass panel with touch controls and a volume knob for intuitive interaction.
2. Installation Instructions
Before proceeding with installation, ensure all power is disconnected. If you are unsure about any steps, please consult a qualified professional or the supplier.
2.1 Mounting the Host
- Consult the supplier for any specific installation requirements.
- Do not attempt to repair the machine without authorization. Always consult the supplier or a professional for repairs.
- Screw the mounting bracket onto the 86 cassette using the provided bracket screws.
- Connect the wiring for the corresponding functions (power, audio input/output, speakers, doorbell) to the host's terminal posts. Ensure all connections are secure.
- Carefully load the host into the hardware bracket and push it down until it is securely in place.
Figure 2: Diagram of 86mm back cover and mounting bracket (as described in manual OCR, no direct image provided).
2.2 Wiring Connections
Use multi-strand copper wire, coaxial line, and audio line as appropriate for connections.
Power Supply Wiring:
- Power Terminal (10): Connect the AC220V power supply.
Audio Input/Output Wiring:
- Audio Input Cable (13): Use a three-core shielded audio cable (commonly known as microphone cable), RVVP2X0.5 or RVVP2X0.75, connected to AUX L+, AUX R+, and GND.
- Audio Output Cable (12): Use a three-core shielded audio cable (commonly known as microphone cable), RVVP2X0.5 or RVVP2X0.75, connected to OUT L+, OUT R+, and GND.
Speaker Connections:
- Left Speaker (14): Connect horn wire (200 core), RVH2X100, or RVH2X200 to SPK L- and SPK L+.
- Right Speaker (15): Connect horn wire (200 cores), RVH2X100, or RVH2X200 to SPK R- and SPK R+.
Doorbell Connection:
- Doorbell (11): Connect GND and DB to trigger the doorbell.
Note: A detailed wiring diagram image with numbered terminals was not provided. Please refer to the textual descriptions above for connections.
2.3 Initial Power-On
After all installation and wiring are complete, turn on the power switch to start using the device.
3. Operating Instructions
3.1 Front Panel Controls

- Knob (1): Rotate clockwise to increase volume, counter-clockwise to decrease volume. The main interface displays the current playback mode, volume level, and song name.
- Touch Light Source (Play/Pause, Previous/Next, Mode):
- Power Switch (3): Slide left to turn off, right to turn on.
- Mode Switch Key (4): Press to cycle through playback modes: TF card, U disk, AUX, Bluetooth.
- Previous (6): Press to play the previous song.
- Next (7): Press to play the next song.
- Play/Pause (8): Press to play or pause music.
3.2 Media Playback
- Bluetooth Function: Supports pairing with mobile phones and other external Bluetooth devices for audio playback. Effective connection distance is approximately 10 meters.

Figure 4: Bluetooth 5.3 Wireless Transmission - TF Card Interface (9): Insert a TF card (up to 32GB) into the card holder for music playback.
- USB Interface (2): Connect a standard 1.1 or 2.0 U disk (up to 32GB) for music playback.
- AUX Input (4): Connect external audio devices via the AUX input to amplify their sound.
- Multi-channel Audio Source: Seamlessly switch between Bluetooth, TF card, U disk, and AUX playback.

Figure 5: Multi-channel Audio Source Playback - Supported Audio Formats: MP3, WAV, WMA, FLAC, APE, DTS, AAC, AC3, OGG.
- Boot Welcome: Supports playing a designated welcome message or music upon power-on. Music files should be placed in a folder named "SYSTEM" with a subfolder "WELCOME" on the TF card/USB stick.
- Power-off Memory: The device remembers the last played state before shutdown.
- Power-on Playback: Automatically plays songs when powered on.
3.3 Remote Control Operation
The device includes an infrared remote control for convenient operation with various shortcut keys.

- On/Off Key (1): Press to power on, press again to power off.
- 3D Key (2): Press to switch 3D sound effects.
- Mute Key (3): Press to mute the sound, press again to unmute.
- Volume Control Keys (4): Press to increase or decrease volume. Long press for quick adjustment.
- Play/Pause Key (5): Press to play or pause music.
- Up and Down Song Control Keys (6, 9): Press to control previous/next song playback.
- Sound Key (7): Press to change the sound mode.
- AUX Play Key (8): Press to switch to AUX play mode.
- TF Card Playback Key (10): Press to switch to TF card playback mode.
- Bluetooth Playback Key (11): Press to switch to Bluetooth playback mode.
3.4 Visual Demonstration
4. Maintenance
To ensure the longevity and optimal performance of your SUMWEE 86X Wall Amplifier, follow these general maintenance guidelines:
- Keep the device clean and free from dust. Use a soft, dry cloth for cleaning.
- Avoid exposing the device to excessive moisture or extreme temperatures.
- Ensure proper ventilation around the unit to prevent overheating.
- Do not use harsh chemicals or abrasive cleaners on the tempered glass panel.
5. Troubleshooting
The following checklist will help you resolve common problems. Please verify connections and operation steps before troubleshooting.
| Breakdown | Reasons and Solutions |
|---|---|
| Do not boot |
|
| No sound |
|
| Keystroke failure |
|
| Unable to connect to Bluetooth |
|
| Connected Bluetooth playback no sound |
|
| The TF card or USB flash drive cannot be read |
|
| Remote control is not sensitive |
|
If the above methods do not resolve the problem, please contact your supplier for assistance. Do not attempt to disassemble or repair the machine yourself.
6. Specifications
| Parameter | Value |
|---|---|
| Brand Name | SUMWEE |
| Model Number | 86X |
| Power Source | AC220V (50HZ) 110V-250V |
| Output Power | 2*25W / 4*25W |
| Load Impedance | 4-8 Ohms |
| Audio Signal-to-Noise Ratio | ≥98dB |
| Infrared Remote Control Distance | ≥10M |
| Bluetooth Effective Connection Distance | ≥10M |
| Product Size | 86*86*10mm |
| Package | Yes |
| Channels | 1 |
| Origin | Mainland China |
| Certification | CE, RoHS |
| Package Dimensions (L x W x H) | 18 x 14 x 11 cm |
| Package Weight | 0.556 kg |
7. User Tips
- For optimal sound quality, ensure your audio files are in a lossless format (e.g., FLAC, APE) when playing from USB or TF card.
- When using Bluetooth, keep your paired device within the 10-meter effective range for a stable connection.
- Experiment with the "Sound Key" on the remote control to find your preferred audio profile (e.g., ordinary, rock, classical, jazz, pop).
- Utilize the power-off memory function to seamlessly resume your music from where you left off.
- If experiencing issues with the touch panel, ensure it is clean and dry.
8. Frequently Asked Questions (FAQ)
- Q: Can I connect multiple speakers to this amplifier?
- A: Yes, the amplifier supports connections for both left and right speakers, with output power of 2*25W or 4*25W depending on the configuration.
- Q: What is the maximum capacity for USB and TF cards?
- A: The device supports USB disks and TF cards up to a maximum capacity of 32GB.
- Q: How do I switch between different audio sources?
- A: You can switch modes using the "Mode" button on the front panel or the dedicated mode keys (AUX Play, TF Card Playback, Bluetooth Playback) on the remote control.
- Q: What should I do if the remote control is not working?
- A: First, check if the remote control battery is dead and replace it if necessary. Also, ensure there are no obstacles between the remote control and the amplifier's infrared receiver, and try shortening the distance.
9. Warranty and Support
The company continuously strives to improve product performance, appearance, and design specifications. Any changes will be reflected in the actual product without prior notice.
For detailed warranty information, please refer to the specific warranty card included with your product or contact the supplier directly.
If you encounter any issues that cannot be resolved using the troubleshooting guide, please contact your supplier for assistance. Do not attempt to disassemble or repair the machine yourself, as this may void your warranty and cause further damage.
User Manual (PDF): For a downloadable version of the user manual, please refer to the following link: SUMWEE 86X Wall Amplifier User Manual PDF