MOES SGW08

Contents

MOES Smart Dual Water Timer Instruction Manual

Model: SGW08

1. Product Description

The MOES Smart Dual Water Timer is an intelligent irrigation controller designed to automate your garden watering. It features two independently controllable outlets, Bluetooth connectivity for app-based scheduling, and robust construction for outdoor use.

MOES Smart 2-Outlet Water Timer with app interface

Figure 1: MOES Smart Dual Water Timer Overview

Product Components

  • Hose Faucet Connection: Top inlet for connecting to a standard outdoor faucet.
  • LED Light: Indicates device status and pairing mode.
  • ON/OFF Button: Manual control and pairing activation.
  • Outlet Fitting 3/4": Two independent outlets for connecting garden hoses or irrigation lines.

Dimensions

Dimensions of the MOES Smart Water Timer

Figure 2: Device Dimensions (Approximate)

  • Width: 116.2mm (4.5in)
  • Height: 117mm (4.6in)
  • Depth: 55mm (2.1in)

2. Specifications

FeatureSpecification
ModelSGW08
Communications ProtocolBluetooth
Working Pressure0.05-0.8MPa (7.25-116 psi)
Working Temperature40.1°F-113°F (4.5°C-45°C)
Rain Delay Time1 day and up to 7 days
Waterproof RatingIP55
Battery2 x AA alkaline batteries
Frequency Band2.4GHz ISM band
TX Transmit Power<+10dBm

3. Setup

3.1 Initial Water Timer Setup

  1. Insert 2 x AA Batteries:
    a. Remove the battery tray on the back of the timer by sliding or pulling it out.
    b. Insert two AA (1.5V) alkaline batteries, ensuring correct polarity.
    c. Replace the tray securely.
    Note: Do not mix alkaline, standard (carbon-zinc), or rechargeable batteries.
  2. Install the Timer:
    a. Connect the timer to an outdoor hose faucet. Ensure a tight connection to prevent leaks.
    b. Your timer is now ready to be used with any product that can be attached to a standard hose faucet.
    Note: Do not place the timer in an underground valve box or anywhere your Bluetooth signal will be obstructed.
  3. Turn on Your Water:
    The water supply to the faucet must remain on for the timer to work properly. The timer will control the water flow.

3.2 App Preparation and Device Pairing

  1. Download MOES App:
    Download the MOES App from your device's App Store. While Tuya Smart/Smart Life App also works, the MOES App is recommended for enhanced compatibility and features.
  2. Registration or Log In:
    Open the MOES App. If you are a new user, tap "Register" and follow the prompts to create an account. If you already have an account, tap "Log in".
  3. Add Device:
    a. Ensure your Bluetooth gateway (if you have one for stable wireless control) is connected to the MOES App.
    b. In the MOES App, navigate to your gateway and click "Add new devices".
    c. To put the water timer into pairing mode, press and hold one of the ON/OFF buttons on the timer for more than 6 seconds until both green LED lights flash quickly at the same time.
    d. The app will discover the device. Wait for 10-120 seconds for the pairing process to complete.
    e. Once successfully added, you can edit the device name in the app for easy identification.
    f. You can now set up "smart scene linkage" according to your needs.
Adding the device to a Bluetooth Gateway for stable wireless control

Figure 3: Adding Device to Bluetooth Gateway

4. Operating Instructions

4.1 Scheduling Watering

The MOES App allows you to set up various watering schedules for each of the two zones.

Timer and Cycle Timer scheduling options in the app

Figure 4: Normal and Cyclical Schedule Options

  • Timed Watering Schedule: Set specific start times and durations for watering.
  • Cyclical Watering Schedule: Program watering to occur in cycles within a defined start and end time.

4.2 Manual Watering

You can manually activate watering without disturbing your programmed schedule. This is useful for testing, extra watering, or using the faucet without removing the timer.

  1. In the app, navigate to the desired zone.
  2. Click the manual watering icon to activate.
  3. Set the desired "Work Time" (duration) for manual watering. The remaining time will be displayed.

4.3 Stop Watering

To stop water flow at any time (during manual or programmed watering), click the manual watering icon again in the app. The icon will change to indicate no water droplets.

4.4 Rain Delay Function

The rain delay function allows you to postpone watering for 1 to 7 days, useful during rainy weather or when the ground is already wet.

Setting Rain Delay in 7 days via the app

Figure 5: Setting Rain Delay in App

  1. In the app, navigate to the rain delay setting.
  2. Select the desired delay duration (1 to 7 days).
  3. Confirm the setting to activate the rain delay.

5. Maintenance

5.1 General Care and Tips

  • Connection Range: For optimal performance, ensure the timer is within 49.2ft (15m) of your Bluetooth gateway or controlling device in an open environment.
  • Voice Control: This Bluetooth water timer does not support Alexa or Google voice control.
  • Winterization: Do not use the timer when air temperatures are below 40°F (4.5°C). Remove the timer from the hose faucet and store it indoors to prevent potential freeze damage.
  • Filter Maintenance: The timer includes a filter to trap dirt particles. Clean this filter regularly and replace it if it becomes worn or damaged to ensure proper water flow and prevent blockages.
  • Battery Replacement: Replace batteries when the low battery indicator appears in the app. When replacing batteries, ensure the water timer is dry.
  • Leak Prevention: To prevent leakage, ensure the water timer is tightly attached to the faucet and hose. Use a rubber washer and thread seal tape if necessary for a secure seal.

5.2 Water Flow Considerations

  • When both zones are turned on simultaneously, the water flow through each zone may be reduced by half.
  • Water flow in the two zones may differ if you turn on one zone first and then the other.

5.3 Waterproof Design

The MOES Smart Dual Water Timer is designed with an IP55 waterproof rating for outdoor use.

IP55 Waterproof for outdoor use, showing reinforced nylon fiber and battery compartment seal

Figure 6: IP55 Waterproof Features

  • Constructed with 30% Reinforced Nylon Fiber Material for durability.
  • Features a rubber ring seal to protect batteries from water ingress.

6. Troubleshooting

  • Water Dripping from Knob/Outlet: Check all connections to the faucet and hoses. Ensure rubber washers are properly seated and not damaged. Apply thread seal tape if necessary for a tighter seal.
  • Valve Not Turning Off Automatically: Verify that the batteries are fresh and correctly installed. Check the schedule settings in the app. If the issue persists, the valve mechanism might be obstructed or faulty.
  • High Battery Consumption: Ensure you are using high-quality alkaline batteries. Frequent communication with the gateway or very cold temperatures can increase battery drain. If consumption is unusually high, consider replacing batteries with a different brand or checking for constant device activity.
  • Device Breakdown / Moisture Ingress: While rated IP55, ensure the battery compartment is always securely closed. Avoid direct high-pressure water jets. If moisture is suspected inside, discontinue use and allow it to dry completely before attempting to use again.
  • Bluetooth Connection Issues: Ensure the timer is within range of your Bluetooth gateway or controlling device. Check for obstructions that might block the signal. Restart the app and the timer if necessary.

7. User Tips

  • Easy Setup: Many users find the device easy to set up and connect to the app. Follow the instructions carefully for a smooth installation.
  • Scheduling Limitation: Note that you can typically set only one main program for a specific day, rather than multiple distinct programs for the same day. Plan your watering schedules accordingly.
  • Gateway for Stability: For stable wireless control and remote access when you are away from home, it is recommended to connect the timer to a Bluetooth gateway (hub).
  • App Choice: While compatible with Tuya Smart/Smart Life, the MOES app is generally recommended for its enhanced features and compatibility.

8. Frequently Asked Questions (FAQ)

Q: Does the device work with the Tuya application?
A: Yes, the MOES Smart Dual Water Timer is compatible with the Tuya Smart/Smart Life app. However, the MOES app is recommended for potentially enhanced features and compatibility.
Q: Are the fittings made of brass?
A: The main faucet connection fitting appears to be brass-colored metal, providing a durable connection point.
Q: Is the European standard compatible with other regions like Brazil?
A: Compatibility depends on the specific hose and faucet thread standards in your region. Please check your local plumbing standards to ensure the 3/4" outlet fittings and inlet connection are compatible.
Q: For functioning without me being home, does it need a HUB?
A: Yes, for stable wireless control, remote access, and integration into a smart home system, it needs to be added to a Bluetooth gateway (hub).
Q: How to add a photo in the app? After closing the app, the photos disappear.
A: This might be an app-specific issue or related to app permissions. Ensure the MOES app has necessary storage permissions on your device. Try updating the app to the latest version. If the problem persists, contact MOES support.
Q: Is it compatible with HomeAssistant?
A: Official direct integration with HomeAssistant is not explicitly stated. It may require community-developed integrations or work through a compatible gateway that supports HomeAssistant.

9. Warranty and Support

9.1 Warranty Instructions

Products are covered by a 24-month warranty, effective from the date of purchase by a retail customer. To exercise warranty rights, the purchaser must present a warranty card and proof of purchase (e.g., VAT invoice, financial receipt). If product quality problems occur within 24 months, prepare the product and packaging and return it to the place of purchase for after-sales maintenance. A maintenance fee may be charged if damage is due to personal reasons.

The warranty does not cover:

  • Mechanical damage caused by user fault or product defects resulting from such damage.
  • Damage caused by improper use of the product.
  • Products with removed warranty seals or serial numbers.
  • Physical defects eliminated outside of authorized service.
  • Use of non-original parts and consumables.

9.2 Declaration of Conformity

WENZHOU NOVA NEW ENERGY CO.LTD declares that the radio equipment type SGW08 is in compliance with Directive 2014/53/EU, 2014/30/EU, and 2011/65/EU. The full text of the EU declaration of conformity is available at: https://www.moestech.com/blogs/news/bwy-yc02

9.3 Recycling Information

All products marked with the WEEE symbol (Waste Electrical and Electronic Equipment Directive 2012/19/EU) must be disposed of separately from unsorted municipal waste. This equipment must be disposed of at designated collection points for electrical and electronic equipment to protect health and the environment.

9.4 Manufacturer and After-sale Service

Manufacturer: WENZHOU NOVA NEW ENERGY CO.,LTD
Address: Power Science and Technology Innovation Center, NO.238, Wei 11 Road, Yueqing Economic Development Zone, Yueqing, Zhejiang, China
After-sale Service Email: service@moeshouse.com

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.