Introduction
Thank you for choosing the SinoTrack ST-906L 4G GPS Tracker. This device is designed for real-time tracking of vehicles such as cars and motorcycles, offering features like remote engine cut-off, geo-fencing, and overspeed alarms. This manual provides detailed instructions to help you set up and operate your device effectively.
The SinoTrack ST-906L 4G GPS Tracker, shown alongside a smartphone demonstrating its real-time tracking capabilities on a map.
Specifications
Physical dimensions of the ST-906L GPS Tracker and a visual summary of its main functions.
| Feature | Detail |
|---|---|
| Model Name | ST-906L 4G+2G |
| Dimensions | 3.14 x 1.57 x 0.59 inches (approx. 80 x 40 x 15 mm) |
| Weight | 0.209 kg |
| Connectivity | 4G+2G (GSM) |
| GPS Module | Yes |
| Voltage | 12 V |
| Out Power | 0.02W |
| Battery Life | 1 to 4 Hours (Built-in 120mAh) |
| SIM Card Type | Micro SIM (without PIN code) |
| Special Features | Internet Connected |
| Certification | CE, RoHS |
Setup Guide
1. SIM Card Insertion
The device requires a Micro SIM card without a PIN code. Ensure the SIM card has an active data plan for online tracking functionality.
- Gently open the lid of the tracker.
- Pan to open the card slot and insert your Micro SIM card.
- Push to the right to close the slot and turn ON the switch.
Detailed steps for correctly inserting the SIM card into the tracker.
2. Initial Power On
After inserting the SIM card, connect the external power supply. Place the device outdoors for approximately 30 seconds. The LED lights will remain lit, indicating the device is working normally and acquiring a GPS signal.
3. GPS Antenna Placement
For optimal GPS signal reception, the GPS antenna side of the tracker should always face the clear sky. Avoid placing the device under metal surfaces, as this can block the GPS signal. Placement under glass or plastic is acceptable.
Guidelines for proper GPS antenna positioning to ensure optimal signal reception.
4. Wiring Installation
Connect the tracker to your vehicle's electrical system according to the diagram below. The fuel cut-off function requires connection to a relay. Ensure the safety voltage of the relay does not exceed 12V.
Detailed wiring diagram for connecting the GPS tracker to a vehicle's electrical system, including the relay for fuel cut-off.
- Red Wire: Connect to the positive pole of the battery.
- Black Wire: Connect to the negative electrode of the battery.
- Yellow Wire: Connect to the yellow wire of the relay (for fuel cut-off).
- Orange Wire: Connect to the vehicle's ACC wire.
Operation
1. Tracking Platform Access
The SinoTrack ST-906L offers a lifetime free tracking platform accessible via web and mobile applications.
Access your tracker's data anytime, anywhere through the free web platform and mobile applications.
Web Tracking (PC Version)
Visit Pro.SinoTrack.com. Use the ID number found on your tracker as the username and '123456' as the default password.
Mobile Application Tracking
Download the SinoTrack PRO app from the Apple App Store (iOS) or Google Play Store (Android). Alternatively, scan the QR code provided in the manual. Use the ID number on your tracker as the username and '123456' as the default password.
2. Basic Tracking via Phone Call
Dial the phone number of the SIM card inserted in the tracker. The device will hang up and reply with a tracking message containing a Google Maps link (Lon and Lat coordinates). You can open this link to view the tracker's location on a map.
3. Working Modes: SMS vs. GPRS
The ST-906L supports both SMS and GPRS working modes.
- SMS Mode: Ideal for mobile control and receiving Google location links via SMS.
- GPRS Mode (Default): Recommended for real-time online monitoring and storing tracking data on the platform.
To switch modes, send the following SMS commands to the tracker's SIM card number (default password is 0000):
- SMS Mode:
700+password(e.g.,7000000). Reply:SET OK - GPRS Mode:
710+password(e.g.,7100000). Reply:SET OK
4. SMS Commands for Configuration and Control
All commands should be sent to the tracker's SIM card number. The default password is 0000.
- Set APN:
8030000 APN(Replace APN with your SIM card's Access Point Name). If APN requires username/password:8030000 APN APNuser APNpassword. - Set Server IP and Port:
8040000 45.112.204.246 8090(This sets the tracker to the SinoTrack server). - Set Control Number (1 to 3):
139504434650000 1(Example: +86 13950443465, password 0000, first control number). - Delete Control Number:
D101#(Deletes the first control number). - Monitor: Send command
66to the tracker from a control number; the tracker will call back. - Change Password:
777+NewPassword+OldPassword(e.g.,77712340000). - Get Location (Google Link):
669+password(e.g.,6690000). - Change Time Zone:
896+password+E/W+HH(e.g.,8960000E00for East, 00 time zone). - Geo Fence (Open/Close):
211+password(Open),210+password(Close). To set fence radius:0050000 1000(1000 meters). - Overspeed Alarm:
122+password+Blank+XXX(XXX is speed in KM/H, 0-999.0disables alarm). - Mileage (Set/Read):
142+Password<+M+X>(Set initial mileage X in meters).143+password(Read current mileage). - Shock Alarm (Open/Close):
181+password+T(Open, T is shocking time in seconds, 0-120).180+password(Close). - Low Battery Alarm: Tracker automatically sends SMS to the first control number when battery is low (20%).
- Call Mode (On/Off):
150+password(On),151+password(Off). When on, alarms call and send SMS; when off, only SMS. - Cut Engine Remotely:
940+password. - Recover Engine:
941+password. - Set Time Interval (ACC On):
805+password+Blank+T(T in seconds, 0-180. 0 means close GPRS). Default 20 seconds. - Set Time Interval (ACC Off):
809+password+Blank+T(T in seconds, 0-180. 0 means close GPRS). Default 300 seconds. Minimum interval is 10 seconds. - Sleep Mode (On/Off):
SLEEP+password+Blank+T(T in minutes. Tracker sleeps when vehicle stopped for T minutes).SLEEP0000 0(Close sleep mode). - Restart: Send
RESTART. - Read Configuration (RCONF): Send
RCONFto receive current settings (ID, password, control numbers, mode, alarms, APN, IP/Port, GPRS upload time, time zone).
The 'History Route Playback' feature allows users to review past travel routes and data.
Key Features
- Real-time Tracking: Monitor your vehicle's location in real-time.
- History Route Playback: View and playback daily tracking history anytime, anywhere.
- Remote Cut-off: Remotely cut off oil/power to the vehicle for security.
- Geo-fence: Set up virtual boundaries and receive alerts when the vehicle enters or exits them.
- Overspeed Alarm: Get notifications if the vehicle exceeds a preset speed limit.
- Shocking Alarm: Receive alerts for unusual vibrations or impacts.
- Sleep Mode: Conserve battery by entering sleep mode when the vehicle is stationary.
- Built-in Battery: Provides backup power for continued tracking.
- Free APP: Access tracking features via the dedicated SinoTrack PRO mobile application.
- SOS Alarm: For emergency situations (requires optional SOS button).
- Multiple Devices in One Account: Manage several trackers from a single account on the web platform or app.
Maintenance
- Battery: The device has a built-in 120mAh battery, providing 1 to 4 hours of backup. The battery charges automatically when connected to the vehicle's power supply.
- General Care: Keep the device dry and away from extreme temperatures. Avoid exposing it to water or harsh chemicals.
- Firmware Updates: Periodically check the official SinoTrack website or app for any available firmware updates to ensure optimal performance.
Troubleshooting
LED Status Indicators
| LED Color | Status | Meaning |
|---|---|---|
| Blue (GPS) | Flashing | No GPS Signal or GPS starting |
| Blue (GPS) | ON | GPS OK |
| Orange (GSM) | Flashing | No SIM card or GSM starting |
| Orange (GSM) | ON | GSM OK |
| Red (GSM) | OFF | Tracker is off or in sleep mode |
| Red (GSM) | Flashing | Tracker is Working |
Common Issues and Solutions
- Device not online:
- Send
RCONFcommand to the device. - Check if the APN, IP, Port, and ID on the platform are correct in the reply.
- Verify the device's working model (SMS or GPRS mode).
- Send
- No GPS Signal: Ensure the GPS antenna side is facing the clear sky and not obstructed by metal.
- SMS Commands Not Working: Check if the SIM card is properly inserted, has credit, and a data plan. Ensure the correct password is used in commands.
- Platform shows 'V' (Invalid Location): The tracker has not yet acquired a valid GPS location. Ensure it's outdoors with a clear view of the sky.
User Tips
- SIM Card Data: A SIM card with an active data plan is essential for the tracker's full functionality, especially for online tracking and GPRS mode.
- Initial Setup: Carefully follow the instructions, especially for setting the correct APN and server IP address, to ensure proper initial connection.
- Antenna Placement: Always ensure the GPS antenna side has a clear view of the sky for accurate positioning. Avoid placing it under metal.
- Multi-Device Management: If you manage multiple SinoTrack GPS trackers, contact SinoTrack support to create a group account, allowing you to monitor all devices on a single platform.
Frequently Asked Questions (FAQ)
- Q: Do I need a data plan for the SIM card?
- A: Yes, a SIM card with a data plan is required for the tracker to send location data to the online platform and app, especially when operating in GPRS mode.
- Q: How do I get the GPS IMEI to register it in my country?
- A: The IMEI number is typically printed on the device itself or on its packaging. You can also retrieve it by sending the
RCONFSMS command to the tracker, which will return its configuration details including the ID (which is often the IMEI). - Q: Is the tracking platform free to use?
- A: Yes, SinoTrack provides a lifetime free tracking platform for its devices.
- Q: Can I use this tracker on a motorcycle?
- A: Yes, the SinoTrack ST-906L is suitable for both cars and motorcycles.
- Q: Does the GPS battery charge automatically?
- A: Yes, the built-in battery charges automatically when the device is connected to the vehicle's main power supply.
- Q: Can I remotely open/close vehicle doors with this device?
- A: No, the ST-906L GPS tracker does not have the functionality to remotely control vehicle door locks. Its primary functions are tracking, remote engine cut-off, and alarms.
Support and Warranty
For further assistance or detailed documentation, please refer to the official user manual PDF available from the seller. You can find it under 'Item guides & documents' on the product page. For any specific issues or warranty claims, please contact the seller directly through the platform where you purchased the device.
A PDF user manual is available for download: View User Manual (PDF)