WLtoys K969

Contents

WLtoys K969 1:28 4WD 2.4G Mini RC Racing Car Instruction Manual

Model: K969 | Brand: WLtoys

Introduction

Thank you for choosing the WLtoys K969 1:28 4WD 2.4G Mini RC Racing Car. This high-speed, off-road remote control vehicle is designed for thrilling drift action and provides an engaging experience for users aged 14 and above. This manual provides essential information for safe operation, proper setup, maintenance, and troubleshooting to ensure optimal performance and longevity of your RC car.

WLtoys K969 RC car with remote, chassis view, and key features
The WLtoys K969 RC car, remote control, and a view of its metal chassis and features.

Safety and Cautions

General Safety Guidelines

  • Never run the model on public roads or streets, as it could endanger traffic.
  • Never run the model in crowded areas, near or toward people or animals, to prevent property damage and/or personal injury.
  • Never run the model near rivers, ponds or lakes as to prevent R/C car from dropping into the water.
  • Make sure that no one else is using the same frequency as yours in your running area. Using the same frequency at the same time, whether it is driving, flying or sailing, can cause loss of control with R/C model, resulting in serious accidents.
  • To avoid a runaway R/C model or loss of control, always follow the procedure below:
    1. Fully extend transmitter antenna.
    2. Switch on transmitter.
    3. Switch on R/C model.
    4. Follow reverse procedure to shut down.
  • Never touch or hinder rotating tire.
  • Never run R/C model in the rain or let run over puddles, as water may cause trouble with R/C model.
  • Motor and battery get very hot after running. Take care when handling them.
  • Retract transmitter antenna when not in use.
  • Remove the batteries from model and transmitter when they are not in use.

Cautions when Handling Batteries

  • Do not dismantle the battery or charger and do not cut any battery cables. This may cause short-circuit and/or damage to the product.
  • Change battery with compatible charger following proper procedure that is called out in the instructions. Do not modify charger or charge battery in improper way.
  • Do not recharge battery that is still warm from use as it may damage the battery. Allow the battery to cool off prior to recharging.
  • Make sure to disconnect charger cables from R/C model and electric outlet when not in use.
  • Remove transmitter battery when not using it for a long time as it may leak and damage transmitter when left for a long period.
  • Never incinerate used batteries, as they can explode causing serious accidents.

Safety Precautions

Do not operate the model on public roads, in crowded places or near infants, it may cause accidents or injury.

!

As the product includes small and sharp parts, assemble and store this product only in places out of the reach of children.

!

As the front end of the antenna may be dangerous, do not aim it toward faces.

!

During the car running and after, the motor will be hot. Please do not touch it until it has had time to cool down.

!

Package Contents

The WLtoys K969 RC Racing Car package typically includes the following items:

  • Original Box
  • WLtoys K969 RC Car
  • Batteries (7.4V 400mAh Lithium Battery)
  • Operating Instructions (this manual)
  • Charger (USB 5V)
  • Remote Controller (2.4G, 4 channels)
  • USB Cable
WLtoys K969 RC car, remote, charger, and battery in packaging
Contents of the WLtoys K969 package, including the car, remote, charger, and battery.
WLtoys K969 RC car, remote, charger, battery, and foam box packaging
The WLtoys K969 RC car and accessories neatly packed in a foam box.

Specifications

FeatureSpecification
Brand NameWLtoys
Model NumberWL K969
Type NumberK969
Scale1:28
Dimensions16.5*8*5.5 cm
MaterialMetal, Plastic, Rubber, ABS
Drive Motor130 Carbon brush motor
Maximum Speed30km/h
Remote ControlYes
Remote Distance100 Meters +
Control Channels4 channels
State of AssemblyReady-to-Go
Power7.4V 400mAh Lithium Battery
Charging VoltageUSB 5V
Play Time18 Minutes
Recommend Age14+y
WarningAway fire
CertificationCE
Batteries IncludedYes
OriginMainland China
DesignCars
TypeCar
FeaturesREMOTE CONTROL

Setup

Tools Needed for Assembly/Maintenance

While the car comes Ready-to-Go, some maintenance or adjustments may require the following tools:

  • 2.0mm Turret spanner
  • Hobby knife
  • Philips type screwdriver (Small)
  • Side cutter
  • Philips type screwdriver (Large)
  • Scissors
  • Needle nose pliers
  • Crossed spanner
  • Instant mucilage glue

Initial Power-On Sequence

  1. Fully extend the transmitter antenna.
  2. Switch on the transmitter. Ensure the power indicator is a steady light.
  3. Switch on the R/C model.
  4. If the wheels are running self-motion, adjust the trim on the transmitter until the wheels are still.
WLtoys K969 RC car chassis with battery installed
The K969 chassis with the battery properly installed.

Operating Instructions

Transmitter Controls (Proportional R/C)

The remote control features proportional steering and throttle for precise control:

  • Steering: Turn the steering wheel on the transmitter left or right. The turning angle of the car's wheels is proportional to how much you twist the wheel.
  • Forward/Reverse: Pull the throttle trigger backward to move the car forward. The forward speed is proportional to the angle of the trigger. To stop, quickly push the throttle trigger forward.
  • Braking: Loosen the throttle trigger to allow it to return to the neutral position, which engages the brake.
  • Backward: Push the throttle trigger forward from the neutral position to move the car backward. The backward speed is proportional to the angle of the trigger.
WLtoys K969 RC car and remote control
The WLtoys K969 RC car and its 2.4G remote control.

Operating Program

  1. Turn on the switch (1) of the transmitter and make sure the power indicator (2) is a steady light, then turn on the car.
  2. Put the car on the frame or stand. If the wheel is running self-motion, adjust the trim (5) of the transmitter until the wheel is still.
  3. Slip the trigger (3) of the transmitter slowly. Observe if the car moves forward or backward.
  4. Turn the steering adjusting wheel (4) of the transmitter to left or right, and make sure the steering of the front wheels follows the instruction.
  5. Put the car on the ground and stand behind the back of the car. Squeeze the throttle trigger (3) of the transmitter gently. If the car does not move in a straight line, you can adjust the trim (6) of the transmitter until the car moves in a straight line.
  6. Once these steps are complete, the car is ready to run.
Hand holding the remote control with the RC car in the background
A user holding the remote control for the K969 RC car.

Driving Practice

Practice driving your R/C car in a wide and safe location. You can use corner pylons (separately available) or empty cans to create a circuit. A basic speed control technique involves running fast on straight sections and slowing down on curved sections.

Video demonstrating the WLtoys K969 RC car drifting and performing various maneuvers.
RC car drifting on a paved surface
The WLtoys K969 RC car performing a drift on a paved surface.

Maintenance

  • Battery Removal: When the car is not in use, always remove the battery from the car and the transmitter.
  • Cleaning: Completely remove any sand, mud, dirt, etc., from the car after use to prevent damage to moving parts.
  • Rust Prevention: Apply rust prevention oil to metal parts as needed to maintain their condition.
  • Storage: Store the car and batteries separately when not in use, in a cool, dry place away from direct sunlight.
  • Inspection: Regularly examine for damage to the charger, wire, plug, bodyshell, or other parts. In the event of any damage, the product must not be used until the damage has been repaired.
WLtoys K969 RC car with chassis removed, showing internal components
Internal view of the K969 RC car with the body removed, showing components for cleaning and maintenance.

Troubleshooting

DescriptionCauseSolution
The car does not operate at all.Transmitter or receiver is off.Turn on both transmitter and receiver.
Batteries are not placed properly in the transmitter.Place batteries in the transmitter properly.
The drive battery is not charged enough.Charge the drive battery.
The car does not follow your operation and control distance is not long enough.Someone else is using the same radio frequency as you are using.Change your radio frequency to one no one else is using, wait until the driver using the same radio frequency finishes driving, or drive your car at a different place.
There is not enough power in the transmitter or receiver batteries.Replace the transmitter batteries with new ones and charge the drive battery.
Antenna on the transmitter is not tightened/not fully extended.Make sure to insert the antenna into the transmitter and fully extend it.

User Tips

  • The remote control for the K969 is proportional, allowing for precise steering and throttle control.
  • The K969 is known for its high-quality build and excellent drifting capabilities, making it a fun choice for indoor and outdoor use.
  • This model has a good selection of upgrade parts available on the market, allowing for customization and performance enhancements.
  • It's an excellent choice for beginners looking to get into the RC hobby due to its ready-to-go state and robust design.
  • Remember to apply rust prevention oil to metal parts during maintenance to prolong their lifespan.

Warranty and Support

The WLtoys K969 comes with a 1-month warranty.

For additional guidance and detailed diagrams, you may refer to the official user manual PDF: View User Manual (PDF)

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.