Introduction
Thank you for choosing the Zemismart Zigbee Push Wall Light Switch. This manual provides essential information for the safe installation, operation, and maintenance of your smart switch. Please read it thoroughly before installation and keep it for future reference.
Zemismart Zigbee Push Wall Light Switch (Example 3-Gang model)
Product overview video showcasing the design and features of the smart switch.
Setup
1. Installation and Wiring
Important Safety Notice: Before installation, ensure the power supply to the circuit is turned OFF at the circuit breaker. Installation should be performed by a qualified electrician.
- Open the Cover: Use a small screwdriver to gently pry open the front cover from the notch located on the side or bottom of the switch.
- Wiring: Connect the wires according to the circuit diagram provided below. This switch requires a Neutral Wire for proper operation. Ensure Live Wire, Neutral Wire, and Load Wires are connected correctly.
- Secure the Switch: Place the switch module into the wall cassette and secure it with screws.
- Attach Cover Plate: Reattach the front cover plate until it clicks into place.
Circuit Connection Diagram: Connect Neutral (N), Live (L), Ground, and Load wires (L1, L2, L3, L4 for multi-gang switches). Ensure power is off before wiring.
2. Pairing Mode
To connect your smart switch to your smart home system, you need to put it into pairing mode:
- Preparation: Ensure the switch is powered on and connected to electricity. Your mobile device and Zigbee gateway hub must be connected to the same 2.4GHz Wi-Fi network.
- Reset Switch: Press and hold any button on the switch for approximately 5-10 seconds until the indicator light begins to blink rapidly. This indicates the switch has entered pairing mode.
- Discovery: Use the