1. Introduction
This manual provides essential instructions for the safe and efficient operation of your Retevis RB645/RB45 Professional Two-Way Radio. Please read it thoroughly before use and keep it for future reference.
The Retevis RB645/RB45 is a compact and versatile two-way radio designed for clear and reliable communication. It features dual PTT buttons, USB-C charging, VOX hands-free operation, and an emergency alarm function, making it ideal for various professional and recreational uses.
2. Package Contents
Upon unboxing your Retevis RB645/RB45 radio, please ensure all items are present:
Video: Unboxing the Retevis RB645/RB45 Two-Way Radio and its accessories.
- Retevis RB645/RB45 Two-Way Radio unit(s)
- User's Manual
- Li-ion Battery Pack(s)
- USB-C Charging Cable(s)
- Lanyard(s)
3. Key Features
- Dual PTT Design: Allows for flexible communication, usable with either left or right hand.
- USB-C Charging: Convenient and versatile charging options (USB adapter, power bank, PC, vehicle).
- VOX Hands-free: Communicate without pressing the PTT button.
- Emergency Alarm: Local and remote alarm functions for safety.
- Compact and Lightweight: Smaller than most phones, weighing only 103g (without antenna).
- Long Use Time: Equipped with an 1100mAh battery, providing approximately 10 hours of working time and 30 hours of standby time.
- Circle Breathing Indicator: Provides clear visual status for transmitting (red), receiving (green), and charging (blue).






4. Setup
4.1. Battery Installation
Ensure the radio is powered off before installing or removing the battery. Align the battery with the compartment on the back of the radio and push it firmly until it clicks into place. To remove, press the release latch and slide the battery out.
4.2. Charging the Radio
The RB645/RB45 uses a Type-C charging port. To charge:
- Open the earpiece jack cover.
- Insert the Type-C charging cable into the charging port on the radio.
- Connect the other end of the cable to a compatible USB power source (e.g., USB adapter, power bank, PC, vehicle charger).
- The indicator light will illuminate blue during charging.
- Once fully charged, the indicator light will turn green.

USB-C charging methods for your radio.
4.3. Power On/Off
Long press the Power Key (center button on the front panel) for 3 seconds to turn on the radio. The radio will broadcast "power on" and the current channel number. Press the key again to turn off the radio; it will prompt "OFF".
5. Operating Instructions
5.1. Key Introductions

Front view of the radio with labeled controls.
- Antenna: For transmitting and receiving signals.
- PTT (Push-to-Talk) Key: Press and hold to transmit, release to receive.
- TX/RX Indicator: Illuminates red when transmitting, green when receiving, blue when charging.
- Volume + (Side Key 1): Short press to increase volume.
- Volume - (Side Key 2): Short press to decrease volume.
- CH+ (Channel Up) / Key Lock: Short press to increase channel number. Long press for 3 seconds to lock/unlock channels.
- CH- (Channel Down): Short press to decrease channel number.
- Earpiece Jack: For connecting compatible audio accessories (2-pin K plug compatible).
- Type-C Charging Jack: For charging the radio.
- Power Key: Turns the radio on/off.
- MIC (Microphone): For voice input.
- Speaker: For audio output.
5.2. Function Operations
Side Key Functions (Programmable)
Side Key 1 and Side Key 2 have both short and long press functions. Long press functions can be customized via programming software:
- Monitor: If someone is talking on your chosen channel, or if there is no signal, the radio will make a rustling sound.
- OFF: No function assigned to long press.
- Channel Broadcast: Long press to hear the current channel number announced.
- Scan: Long press to enter scan mode. The radio will check programmed channels (1-22) for activity and stop on an active channel. Long press again to exit scan mode.
- Emergency Alarm: Long press to activate a local and remote alarm. Press PTT to exit.
- VOX: Long press to enable/disable VOX function. (VOX level must be set via programming software).
Squelch Level
The squelch level determines the threshold for receiving signals. It can be preset and adjusted in user mode from 0 (ON) to 9 (Deep). Default is 3.
Battery Save Function
When enabled, if no operations are performed for 10 seconds, the radio automatically enters battery save mode. If disabled, the radio does not save power.
VOX (Voice Operated Exchange)
The VOX function allows hands-free communication. It is enabled via programming software and works with a head-mounted earpiece.
- VOX is active only when the function is turned on.
- VOX Gain Level (1-9, default 5) determines the voice level required to activate transmission.
Time-Out Timer (TOT)
The TOT prevents a single user from occupying a channel for too long. The transmission time limit can be set from 30 to 180 seconds via programming software.
CTCSS/DCS (Continuous Tone-Coded Squelch System / Digital Coded Squelch)
CTCSS/DCS signaling can be set for each channel via programming software. When set, the squelch opens only when a signal with the same CTCSS/DCS code is received. If a different code is used on the same channel, the squelch remains closed, and the indicator flashes green.
6. Specifications
| Attribute | Value |
|---|---|
| Brand Name | RETEVIS |
| Model Number | RB45/RB645 |
| Walkie Talkie Type | MINI Walkie Talkie |
| Output Power (w) | 0.5w-3w |
| Frequency Range | 446MHz |
| Storage Channel | PMR:16 / FRS:22 |
| Battery Capacity (mAh) | 1100 |
| Battery Included | Yes |
| Maximum Range | 1.5km-3km |
| Waterproof / Water-Resistant | No |
| Is_Display | No |
| Material | ABS |
| Dimensions | 106*53*18mm (H*W*D without antenna) |
| Certification | CE, FCC |
| Origin | Mainland China |
PMR(446) Channel Frequencies
| CH NO. | Frequency(MHz) | Code(Hz) |
|---|---|---|
| 1 | 446.00625 | 114.8 |
| 2 | 446.01875 | 114.8 |
| 3 | 446.03125 | 114.8 |
| 4 | 446.04375 | 114.8 |
| 5 | 446.05625 | 114.8 |
| 6 | 446.06875 | 114.8 |
| 7 | 446.08125 | 114.8 |
| 8 | 446.09375 | 114.8 |
| 9 | 446.10625 | D026N |
| 10 | 446.11875 | D026N |
| 11 | 446.13125 | D026N |
| 12 | 446.14375 | D026N |
| 13 | 446.15625 | D026N |
| 14 | 446.16875 | D026N |
| 15 | 446.18125 | D026N |
| 16 | 446.19375 | D026N |
Note: FRS version (Model RB45) is applicable in USA, Canada, Mexico, Brazil and has 22 storage channels. PMR version (Model RB645) has 16 storage channels.
7. Maintenance
7.1. Cleaning
Regularly clean the radio's exterior with a soft, damp cloth. Do not use harsh chemicals or solvents. Ensure the charging port and earpiece jack are free of dust and debris.
7.2. Battery Care
- Charge batteries only within the specified ambient temperature range (15~45°C).
- Do not short-circuit the battery terminals.
- Do not use or store the battery in extremely hot environments.
- If the battery leaks and electrolyte gets into your eyes, rinse immediately with clean water and seek medical attention.
- Dispose of used batteries safely and according to local regulations.
7.3. Storage
When not in use for extended periods, store the radio in a cool, dry place. Remove the battery if storing for a long time to prevent discharge.
8. Troubleshooting
- Radio not turning on: Ensure the battery is properly installed and charged. Long press the power key for 3 seconds.
- No sound/poor audio: Check volume level. Ensure squelch level is not set too high. Verify earpiece/headset connection if used.
- Cannot transmit/receive: Check if the channel is locked (long press CH+ to unlock). Ensure you are on the same frequency/CTCSS/DCS as the other party. Verify antenna is properly attached.
- Low battery alert: The radio will prompt "Please charge your radio" every 20 seconds when voltage is below 3.3V. Recharge immediately.
- Radio gets hot during long transmission: This is normal. The radiator and chassis may become warm.
9. Safety and Compliance Information
Before using this radio, read this guide which contains important operating instructions for safe usage and RF energy awareness and control for compliance with applicable standards and regulations.
9.1. RF Energy Exposure and Product Safety Guide
This two-way radio uses electromagnetic energy in the radio frequency (RF) spectrum. All Retevis two-way radios are designed, manufactured, and tested to ensure they meet government-established RF exposure levels. To control your exposure and ensure compliance, always adhere to the following procedures:
- Do not operate the radio without a proper antenna attached.
- Do not transmit for more than 50% of the total radio use time.
- Hold the radio in a vertical position with the microphone at least 2.5 cm (one inch) away from the nose or lips.
- When worn on the body, always place the radio in a Retevis approved clip, holder, holster, case, or body harness.
- Do not operate the transmitter in areas sensitive to electromagnetic radiation (hospitals, aircraft, blasting sites).
9.2. FCC Requirements
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

9.3. CE Requirements
Shenzhen Retevis Technology Co, Ltd. declares that the radio equipment type is in compliance with the essential requirements and other relevant provisions of RED Directive 2014/53/EU and the ROHS Directive 2011/65/EU and the WEEE Directive 2012/19/EU. The full text of the EU declaration of conformity is available at www.retevis.com.

9.4. IC Requirements
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
9.5. Safety Warnings
- Avoid Choking Hazard: Small parts. Not for children under 3 years.
- Turn off your radio power: Before removing/installing battery or accessory, when charging, in potentially hazardous environments (electrical blasting caps, explosive atmospheres), or on aircraft.
- Protect your hearing: Use the lowest volume necessary. Reduce volume before adding headset/earpiece. Limit high-volume use.
- Avoid Burns: Do not use a damaged antenna. Exercise care with batteries to avoid short circuits.
- Safety Operation: Do not use charger outdoors or in moist environments. Do not disassemble the charger. Do not operate the charger if broken. Do not place radio in airbag deployment area.
10. User Tips
- Battery Life: For optimal performance, ensure batteries are fully charged before extended use. The 1100mAh battery provides a good balance of working and standby time.
- Hands-Free Communication: Utilize the VOX function with a compatible earpiece for hands-free operation, especially useful in busy environments.
- Channel Management: Familiarize yourself with the channel lock feature (long press CH+) to prevent accidental channel changes during critical communications.
- Emergency Preparedness: Test the emergency alarm function in a safe environment to understand its operation and ensure readiness for unexpected situations.
- Charging Convenience: Take advantage of the versatile USB-C charging. A 2-in-1 charging cable can provide convenience for recharging multiple units simultaneously.
11. Warranty and Support
11.1. Guarantee
Most new products carry a two-year manufacturer's warranty from the date of purchase. Please keep your guarantee card and proof of purchase for verification.
Exclusions from Warranty Coverage:
- Damage due to accident.
- Misuse or abuse of the product.
- Unauthorized alterations or repairs.
- Altered, defaced, or removed serial number.
11.2. Support
For further resources (brochures, software/firmware, manuals), please contact your direct reseller or visit the Retevis website (www.retevis.com) and check the "support" section for your product.
EU Importer:
Name: Germany Retevis Technology GmbH
Address: Uetzenacker 29, 38176 Wendeburg
Manufacturer:
Shenzhen Retevis Technology Co.,Ltd.
Add: 7/F, 13-C, Zhonghaixin Science&Technology Park, No.12 Ganli 6th Road, Jihua Street, Longgang District, Shenzhen, China
Web: www.retevis.com
E-mail: kam@retevis.com
Facebook: facebook.com/retevis