1. Safety and Cautions
Warning: Not suitable for children under 36 months. This model is not a toy; it is designed for users over 14 years of age. Read the manual before use.
General Safety Warnings
- Never run the model on public roads or streets, as it could endanger traffic.
- To prevent loss of property or personal injury, do not play against people or animals in crowded places.
- Do not play cars close to creeks, ponds, or lakes to prevent the model car from falling into the water.
- Retract transmitter antenna when not in use.
- Remove the battery when the model car and remote control are not in use for a long period.

Figure 1.1: Avoid operating the RC car on public roads.
Battery Handling Cautions
- Do not dismantle the battery or charger, or cut any battery cables. This may cause short-circuit and/or damage to the product.
- Use a matching charger to charge the battery according to the instructions. Do not change the charger or rechargeable battery.
- Do not recharge a battery that is still warm from use; allow it to cool off prior to recharging.
- Make sure to disconnect charger cables from the R/C model and electric outlet when not in use.
- Remove the battery of the remote control when it is not used for a long time, as the battery may leak and damage the remote control.
- Do not place the battery in a hot environment because they may explode, causing serious accidents.
Additional Safety Precautions
- As the product includes small and sharp parts, assemble and store this product only in places out of the reach of children.
- As the front end of the antenna may be dangerous, do not aim it toward faces.
- After the model is used, the motor generates high temperature. Do not touch it until it cools down for a while.
- Don't use the same frequency with others at the same time, or the car will lose control or even lead to serious accidents.

Figure 1.2: Keep small parts away from children.

Figure 1.3: Motor can get hot after use.
2. Setup
Tools Needed for Assembly
The following tools are commonly needed for assembly and maintenance:

Figure 2.1: Common tools for assembly.
Assembling Electronic Parts
Ensure all electronic components are correctly connected as shown in the diagram:

Figure 2.2: Electronic parts assembly diagram.
Charging Precautions
- Firstly, check and confirm that the input voltage of the charger is consistent with local voltage, and the output voltage of the charger is consistent with the battery voltage.
- Remove the battery from the model car before charging.
- Be careful to make sure there is an adult to supervise when charging.

Figure 2.3: USB Charging Cable.
Remote Control Binding (How to Code)
- Turn on the remote control power switch. The power indicator on the remote control will flash red.
- Then, turn on the model car power switch. The light on the receiver will flash.
- Turn the steering control wheel of the remote control or slightly crank the trigger. At this time, the indicator light of the remote controller will become steady red, and the indicator light of the receiver will become steady light, indicating that the frequency matching is successful.
3. Operating Instructions
Remote Control Functions

Figure 3.1: Remote Control Layout.
Proportional R/C Using Instruction
- Steering Left: Turn the steering control wheel to the left. The body will turn to the left. The angle of the left turn is controlled by the magnitude of rotation of the steering control wheel.
- Steering Right: Turn the steering control wheel to the right. The body will turn to the right. The angle of turning to the right is controlled by the magnitude of rotation of the steering control wheel.
- Forward: Pull the throttle trigger backward. The car will move forward. Adjusting the angle of the throttle trigger controls the forward speed of the car. To stop, quickly push the trigger forward.
- Backward/Brake: Loosen the trigger to allow it to return to the neutral position (brake). Push the throttle trigger forward to make the car move backward. Adjusting the forward angle of the throttle trigger controls the backward speed.

Figure 3.2: Steering Left.

Figure 3.3: Steering Right.

Figure 3.4: Forward Movement.

Figure 3.5: Backward Movement/Brake.
Operating Program
- Open the remote control power switch (1), ensure the power indicator Red light (2) flashes, then turn on the power switch of the model car.
- Place the model car on a shelf. Lightly hook the trigger (3) on the remote control, observe whether the car can move forward and backward.
- Turn the remote control's steering control wheel (4) to the left or right and make sure that the steering of the front wheels follows the command.
- Place the model car on the ground, standing behind the car. Lightly hook the throttle trigger (3) on the remote control. If the track is not a straight line, rotate the remote control front steering wheel Fine tune (5). If the model car skews to the right, rotate the front steering wheel to the left Fine tune. If the model car skews to the left, rotate the front steering wheel to the right Fine tune, until the car's track is a straight line.
- The throttle speed controller (6) can adjust the speed of the car model. Rotate right, hook the trigger, the speed of the car will become faster; Rotate left, hook the trigger, the speed will slow down.
- The car is now ready to run.

Figure 3.6: Practice Driving.
Product Video
Video 3.1: Wltoys 104001 RC Car in action, demonstrating its off-road capabilities and speed on sand and stairs.
4. Maintenance
Proper maintenance ensures the longevity and performance of your RC car.
- When the car is not in use, always remove the battery from the car.
- Completely remove any sand, mud, dirt, etc., from the car after use.
- Apply rust prevention oil to metal parts.
- Store the car and batteries separately when not in use.
- Regularly check the charger, wires, plugs, housings, and other components. Discontinue use if damaged until repairs are complete.
5. Troubleshooting
| Description | Cause | Solution |
|---|---|---|
| The car does not operate at all. | Transmitter or receiver is off. | Turn on both transmitter and receiver. |
| The battery is not properly placed in the remote control. | Place batteries in the transmitter properly. | |
| The drive battery is not charged enough. | Charge the drive battery. | |
| The car does not follow your operation and control distance is not long enough. | Someone else is using the same radio frequency as you are using. | Charge your radio frequency to one that no one else is using, wait until the driver using the same radio frequency finishes driving, or drive your car at a different place. |
| Remote control battery is low. | Replace the remote control battery. | |
| The remote control antenna is not tightened or the antenna is not fully extended. | Make sure the remote control antenna is tightened and fully extended. |
6. Specifications
| Feature | Specification |
|---|---|
| Model Number | 104001 |
| Scale | 1:10 |
| Dimensions | 40.2 x 25.5 x 16.2 cm |
| Wheelbase | 283 MM |
| Front and Rear Wheels Minimum Distance | 200 MM |
| Transmission Ratio | 1:9.1 |
| Receiving Server | Triad receiver |
| Motor | 550 Brush Motor |
| Remote Control | 2.4G remote control |
| Remote Distance | More than 100 meters |
| Remote Control Battery | 4 AA batteries (not included) |
| Car Battery | Lithium battery 7.4V 2200mAh |
| Charger | USB charging cable |
| Charging Time | About 3 hours |
| Use Time (Flight Time) | About 7 minutes |
| Server | 6 kg 5-line server |
| Car Shell | Explosion-proof PVC printing car shell, beautiful crashworthy |
| Speed | Up to 45 KM/H |
| Package Includes | Operating Instructions, Remote Controller, USB Cable |
| Material | Metal, Plastic |
| State of Assembly | Ready-to-Go |
| Certification | CE |

Figure 6.1: Detailed Product Information.
7. User Tips
Based on user feedback, here are some tips to enhance your experience:
- Shock Absorbers: The stock shock absorbers may leak. Consider replacing the seals with thicker ones and refilling with 300 CST damper oil for improved performance.
- Upgrades: The Wltoys 104001 is an excellent base for upgrades. Many users recommend upgrading to a brushless motor and ESC combo for significantly increased speed and power. Aftermarket aluminum and carbon parts (e.g., for chassis braces, diffs, knuckles) can also improve durability and performance.
- Differential Maintenance: Perform regular maintenance on the differentials to ensure smooth operation and longevity.
- Tires: The original carpet tires are generally considered good for various terrains.
8. Frequently Asked Questions (FAQ)
- Q: Are there spare parts available for this car?
- A: Yes, many buyers mention that spare parts and upgrades are widely available, making it easy to replace or enhance components like differentials, shock absorbers, and electronics.
- Q: Is the servo a 3-wire type?
- A: No, it is a 5-wire servo.
9. Warranty and Support
This product comes with a one-month warranty.
For further detailed instructions, exploded views, and fittings information, please refer to the official user manual PDF: