1. Safety Instructions
WARNING: To reduce the risk of fire, electric shock or injury, please read all instructions before using.
- This appliance is intended only for household use. Follow all user instructions in this manual.
- Do not immerse any part of this appliance in water or other liquids.
- This appliance can be used by children aged from 8 years old or above and individuals with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
- Keep all parts away from hot surfaces. Store indoors in a cool and dry place.
- Do not run this appliance over any power cord.
- Do not operate with a damaged power cord or plug, or if this appliance has been dropped/impacted and damaged.
- To avoid the risk of electric shock, do not disassemble or attempt to repair this appliance. Contact the seller for a replacement if it is defective.
- Close supervision is necessary for any part being used by or near children, pets or plants.
- Keep clothes, fingers, hair or any parts of human body away from any openings of the appliance or accessories while using.
- Do not use to pick up flammable or combustible liquids such as gasoline or use in areas where they may be present.
- Do not pick up anything that is burning or smoking such as cigarette butts, matches or hot ashes.
- Do not use without the sponge inlet filter in place.
- When pulling out the power plug from the electrical outlet, grasp the plug, not the cord.
- Do not leave the appliance plugged in when unattended. Unplug the electrical cord when not in use and before servicing.
- If the suction opening of this appliance is blocked, switch off and remove the blockages before you start the unit again.
- Before you start vacuuming, make sure to remove large or sharp objects that might damage the sponge inlet filter.
- Do not allow to be used as a toy.
- Use only manufacturer's recommended accessories.
- Do not pull power cord and, pull it around sharp edges or corners, use it as a handle or close a door on it. Do not run the appliance over power cord.
- Turn off all controls as applicable before unplugging from electrical outlet.
- Do not handle plug or vacuum with wet hands or operate without shoes.
- Do not put any objects into openings. Do not use with any opening blocked. Keep free of dust, lint, hair and anything else that may reduce air flow.
- Keep your work area well lit. Take extra care when cleaning on stairs.
- Using improper voltage may result in damage to the motor and possible injury to the user. Correct voltage is listed on nameplate.
- This appliance is provided with double insulation. Do not repair yourself to avoid electric shock. Please contact the seller to get original replacement parts.
2. Product Components & Packing List
Familiarize yourself with all parts of your INSE I5 vacuum cleaner.

Image: All components included in the package.
Product Components:
- Rotatable Cleaner Head
- Retracted Tube (Extension Wand)
- Long Crevice Nozzle
- 2-in-1 Brush
- Dust Container Release Button
- Power Switch
- Power Cord
- Dust Release Button
- Accessories Hook
Packing List:
| Item Name | Quantity | Item Name | Quantity |
|---|---|---|---|
| Main Body (includes dust container with filter pad, motor and handle with power cord) | 1 | Retracted Tube | 1 |
| Cleaner Head | 1 | Long Crevice | 1 |
| 2-in-1 Brush | 1 | Thank You Card | 1 |
| Accessories Hook | 1 | User Manual | 1 |
3. Setup Instructions
3.1 Assembling the Main Body
- Install the Dust Container: Insert the dust container by inserting its clip into the handle's slot. You will hear a click to secure it in place.
- Attach the Retracted Tube: Push the retracted tube into the suction hole opening of the main body.
3.2 Adjusting the Retracted Tube Length
Adjust the length of the retracted tube by pushing the locking button down and pulling out the bottom section of the tube to a suitable length.
3.3 Attaching the Cleaner Head
- Insert the upper hose of the cleaner head into the retracted tube.
- The cleaner head features a dual-mode brush. You can switch between modes by pressing the red button on the head:
- Press A (Brushless Mode): The nozzle brushes are retracted. This mode is ideal for carpets (large low-medium pile carpets).
- Press B (Brushed Mode): The nozzle brushes are extended. This mode is ideal for hard floors (wooden, marble, tile).
Note: Due to powerful suction, small or thin carpets might be sucked tightly, making them harder to clean.
3.4 Using Accessories
- Long Crevice Nozzle: Recommended for narrow spaces such as gaps, corners, and edges, making cleaning faster and easier.
- 2-in-1 Brush: Recommended for cleaning keyboards, curtains, dining tables, upholstery, and other delicate surfaces.
4. Operating Instructions
- Connect Power: Insert the power plug into a suitable electrical outlet. Ensure the power supply matches the correct voltage (AC220-240V 50/60Hz).
- Turn On: Turn on the appliance by pressing the power switch located on the main body.
- Start Vacuuming: Begin vacuuming, ensuring the cleaner head brush maintains contact with the floor. For high-power devices, the motor's temperature may be higher than other parts during use, which is normal. The product features overheat protection.
- Turn Off: Turn off the appliance by pressing the power switch again.
Important: Always remove the power plug from the electrical outlet before assembling, disassembling, or cleaning accessories.
Video: Product demonstration showing assembly, use on various surfaces, and accessory functions.
5. Maintenance
5.1 Cleaning the Dust Container
- Detach: Press the dust container release button and detach the dust container from the handle part.
- Empty: Open the bottom cover and expel any dust, dirt, and debris by pressing the dust release button over a waste bin.
- Wash (if needed): If further cleaning is required, wash the dust container with water only. Do not use detergents.
- Dry: Let the dust container air-dry completely before reattaching.

Image: Hygienic one-touch bin emptying.
5.2 Cleaning the Sponge Inlet Filter
- Detach: Detach the dust container from the handle part.
- Open: Twist the lid of the dust container anticlockwise to open.
- Remove: Remove the sponge inlet filter from the top of the dust container.
- Rinse: Rinse thoroughly under clean fresh water. Do not use soap or other detergents.
- Dry: Allow the filter to dry naturally before placing it back into the dust container. Do not place on radiators or use additional appliances (like a hairdryer) to dry the filter, as this may cause warping or irreparable damage.
- Reinstall: To reinstall the cover, line it up, then rotate down until it clicks into place.
5.3 Checking for Blockages
- Main Unit: Remove the extension wand from the handheld vacuum and check all dust cup intake openings for blockages.
- Wand: Remove the floor nozzle from the extension wand and check the wand for blockages.
- Floor Nozzle: Run scissors along the groove in the floor nozzle to cut or clear away any string, carpet fibers, hair, or other debris.
6. Troubleshooting Guide
| Problem | Possible Cause | Solution |
|---|---|---|
| Appliance turns off on its own | Motor protective thermostat activated due to overheating. | 1. Check for blockages in tube, accessories, and inlet connection. 2. Empty dust cup and clean filters. 3. Allow unit to cool for 30 minutes before restarting. |
| Appliance doesn't work | No power in electrical outlet or supply transformer. | Check fuse or breaker. Replace/reset breaker. |
| Dust falls out from the inner tube | 1. Dust container is full. 2. Blockages in tube, accessories, or inlet connection. | 1. Empty dust container. 2. Check for and clear blockages. |
| Doesn't pick up debris or weak suction | 1. Sponge inlet filter is filled with dust. 2. Dust cup is full or cover is loose. 3. Floor nozzle is blocked. | 1. Clean or replace sponge inlet filter. 2. Empty dust cup, ensure lid is closed and sealed. 3. Remove any string, carpet fibers, or hair from floor nozzle. |
| Dust comes out of the air outlet | 1. Sponge inlet filter not installed correctly. 2. Sponge inlet filter is punctured or has a big hole. | 1. Install sponge inlet filter correctly. 2. Replace the sponge inlet filter. |
7. Product Specifications
| Feature | Specification |
|---|---|
| Brand Name | INSE |
| Model Numbers | I5 / I5s / I500 / I550 / I560 / I570 |
| Dust Collection | Bagless |
| Power (W) | 600W |
| Rated Voltage | AC220-240V 50/60Hz |
| Dust Cup Capacity (L) | 1 liter (0.6-1 L) |
| Power Cord Length (m) | 6 meters (20ft) |
| Function | Dry |
| Working Sound-Level | 70 dB |
| Main Body Weight | 3.85 lbs (<3 kg) |
| Filter Type | Cyclone |
| Installation | Vertical/Hand Held |
| Special Suction Nozzle | Flat Suction Nozzle |
| Size (mm) | 310*108*210 |
| Certification | GS, ROHS, CE |
8. User Tips
- Cord Management: While the long cord offers great reach, it can tangle. Consider using the integrated cord wrap or external ties for neat storage and to prevent tangles during use.
- Versatile Cleaning: Users report excellent performance on both hard floors and carpets. Remember to adjust the floor brush mode accordingly (retracted for carpets, extended for hard floors).
- Powerful Suction: The vacuum offers strong suction. Be mindful that very thin or small rugs might be pulled up or sucked tightly by the cleaner head.
- Regular Filter Cleaning: To maintain optimal suction power, regularly clean the dust container and the sponge inlet filter as per the maintenance instructions.
- Value for Money: Many users highlight the vacuum's strong performance relative to its affordable price, making it a great value purchase.
9. Frequently Asked Questions (FAQ)
- Q: Where can I buy spare parts, especially replacement filters?
- A: Please contact the seller or INSE customer support for information on purchasing genuine replacement parts, including filters.
- Q: Is this vacuum cleaner suitable for carpets?
- A: Yes, it is suitable for carpets, especially low to medium pile carpets. Ensure the brush is in the retracted (brushless) mode for optimal carpet cleaning.
- Q: What is the length of the power cable?
- A: The power cable is approximately 6 meters (20 feet) long, providing ample reach for most rooms.
- Q: Can the filter be washed with water, and how often should it be changed?
- A: Yes, the sponge inlet filter can be washed with water. Rinse it thoroughly under clean fresh water and allow it to air-dry completely. The frequency of changing the filter depends on usage, but it's recommended to inspect it regularly and replace it if it shows signs of wear, damage, or if cleaning no longer restores its effectiveness.
10. Warranty and Support
For warranty information, technical support, or to purchase replacement parts, please refer to the warranty card included in your package or contact INSE customer service directly. You can also scan the QR code on the last page of the included user manual for support.
Thank you for choosing INSE!