KEMIMOTO UTV Bluetooth Sound System User Manual

1. Important Safety Information

• Read all instructions carefully before installation and operation.
• Ensure the vehicle is clean and free of debris before installation.
• For your safety and to ensure a satisfactory installation, complete all steps in the order shown.
• Retain these instructions for future reference and parts ordering.

2. Product Information

The KEMIMOTO UTV Bluetooth Sound System is designed for off-road vehicles, offering robust audio performance with durable, weather-resistant construction.

The speaker enclosure is designed to withstand harsh weather conditions with an IP67 waterproof and dustproof rating.

Package Contents

Please verify all items are present before beginning installation:

3. Setup and Installation

Estimated installation time: 50 minutes. Required tools (to be prepared by oneself): Open-ended spanner, Allen wrench.

Step 1: Speaker Pre-assembly

Pre-assemble each speaker unit [1] and its bracket [2] together using eight M6xL50 screws [4], M6 spring washers [5], and M6 flat washers [6]. Ensure all connections are secure.

Step 2: Fit Throat Clamps

Fit the throat clamps [3] onto the front and rear crossbeams of your vehicle's roof roll cage. These clamps are designed to fit 1.75-2.0 inch diameter crossbeams.

Sliding brackets allow for adjustment to fit different UTV models and roll cage configurations.

Step 3: Adjust and Secure Speakers

Adjust the position of the support bracket [2] according to the distance of the roll bar. Tighten the screw on the back of the speaker [1] when it is in the appropriate position to secure it. Then, fix the speaker [1] bracket [2] onto the roll bar through the throat pipe [3] as shown in the diagram. Note: The bracket [2] is adjustable within a length range of 450-755mm (17.7-29.5in).

Wiring Diagram

Follow the diagram below for proper connection of all components:

Detailed wiring connections for speakers, controller, USB, AUX, and power supply.

Step 4: Power Connection

Connect the red wire (+) from the power supply to a positive 12V DC source and the black wire (-) to a ground point on your vehicle.

Step 5: Control Panel Installation

Install the control panel in a convenient location on your vehicle's dash. Ensure it is securely mounted and all cables are properly routed and connected.

The control panel features USB input/charging, 3.5mm AUX-In, and easy-to-use control buttons.

4. Operating Instructions

Official product demonstration video showing installation, control, Bluetooth pairing, sound quality, and waterproof features.

Function and Operation

1. Power/Mode Button (O/MOD):
   • Power On/Off: Long press O/MOD for power on/off.
   • Mode Switch: Short press O/MOD to cycle through Bluetooth (BT), Auxiliary (AUX), and USB modes.
2. Play/Pause Button (►▮):
   • When playing USB music, AUX music, or Bluetooth music, short press ►▮ for pause, short press again to resume playback.
3. Previous Track/Decrease Volume Button (◀◀):
   • When playing USB music, AUX music, or Bluetooth music, short press ◀◀ for previous track selection.
   • During music playback, long press ◀◀ for volume decrease.
4. Next Track/Increase Volume Button (►►):
   • When playing USB music, AUX music, or Bluetooth music, short press ►► for next track selection.
   • During music playback, long press ►► for volume increase.

Bluetooth Pairing

The system supports Bluetooth 5.0 for stable wireless connection and also features a 3.5mm Aux-In port.

To pair your phone with the speaker system:

1. Long press O/MOD and hold the power button to turn on.
2. Short press O/MOD again to switch to BT mode.
3. Bring your phone close to the main unit and turn on the Bluetooth function on your phone.
4. Search for the main unit's Bluetooth name