1. Product Overview
The SAMOLLA TX800 is an advanced baitcasting fishing reel designed for precision and durability. It features an electronic line counter with a large LED screen, a high-speed 7.2:1 gear ratio, and a maximum drag of 10kg, making it suitable for various fishing environments, including saltwater. The reel is equipped with a magnetic brake system for accurate casting and a depth positioning function to help anglers target specific depths.



2. Setup and Initial Configuration
Follow these steps to set up your TX800 reel before use. Ensure the reel is powered on for configuration.
2.1 Power On
- Long press the LEFT button to turn on the device.
- To turn off, long press the LEFT button for 2 seconds. The device will automatically turn off within 30 minutes if there is no operation.
2.2 Spool Selection
The reel comes with a standard spool (L2). If you require a deep spool (L1), please ensure you have the correct accessory.
- Long press the RIGHT button to enter the spool selection state.
- Short press the LEFT button to switch between L1 (deep spool) and L2 (standard spool).
- Long press the RIGHT button for 2 seconds to save the selected spool and proceed to wire number selection.

2.3 Wire Number Selection
- While in the power-on state, long press the RIGHT button for 2 seconds to enter the fish line number setting state.
- Short press the LEFT button to cycle through PE line numbers: 0.8, 1.0, 1.2, 1.5, 2.0, 3.0, 4.0. Select the appropriate line number for your fishing line.
- Long press the RIGHT button for 2 seconds to automatically save the selected line number and enter winding mode.
2.4 Wire Winding Operation
Note: For improved measurement accuracy, it is recommended to install the reel on a fishing rod before winding the line.
- In the winding mode, rotate the rocker arm to start winding the line onto the spool. The screen will display the actual winding length.
- After winding the desired length, press and hold the RIGHT button for 2 seconds to save the winding length and switch to normal casting mode.
- If you need to re-wind, double-click the LEFT button to reset the counter to zero.
3. Operating Instructions
3.1 Normal Working Condition (Line Counter)
The screen provides a real-time display of the line length being cast out. When retrieving the line, if there is still a remaining length displayed on the screen, double-click the LEFT button to clear the counter and reset it to zero.
3.2 Backlight Function
- After the reel is set up (Steps 1-4), the backlight can be turned on.
- Double-click the RIGHT button to turn on the backlight. The screen will display "LIGHT".
- Without any operation, the backlight will automatically turn off in 20 seconds to conserve energy.
- When the rotary rocker arm is turned, the backlight will automatically turn on again.
- To manually turn off the backlight, double-click the RIGHT button twice.
3.3 Depth Positioning Function
This function helps record and recall specific fishing depths.
- When the bait reaches the desired depth (must be greater than 1 meter), click the LEFT button to activate the depth positioning memory function.
- The "METER" letter on the screen will flash, indicating that the depth memory is active and the current depth is recorded.
- When you retrieve the bait and then cast it out again, as the line reaches the recorded memory depth, the reel will emit a beep sound to indicate that the positioning depth has been reached.
- To turn off the depth positioning function, click the LEFT button again.

3.4 Fish Alarm Hook-up Flash Function
This feature alerts you when a fish bites.
- Click the RIGHT button to turn on the alarm function. The numbers on the screen will flash, indicating the alarm is active.
- Turn on the wire release switch and adjust the fine-tuning knob to ensure the line spool has slight resistance, allowing the fish to easily pull out the line.
- When a fish pulls the fishing line, the screen will flash alternately and emit a beep sound. The screen will flash for approximately 5 seconds before automatically resetting.
- To turn off the alarm, click the RIGHT button again.
4. Maintenance
4.1 General Care
- After each use, especially in saltwater, rinse the reel with fresh water and dry it thoroughly to prevent corrosion.
- Regularly inspect the reel for any loose parts or damage.
- Lubricate moving parts as needed with appropriate fishing reel oil or grease.
4.2 Charging
The reel features a USB charging port with a waterproof plug.

If the display shows a low battery indicator (as shown in Figure 4 in the PDF manual) or if the screen figures appear blurred, charge the battery immediately. If the issue persists, the battery may need replacement.
5. Troubleshooting
5.1 Low Voltage Alarm
If the display shows a low battery icon or blurred figures, it indicates a low voltage alarm. Please charge the reel promptly. If the problem persists after charging, consider replacing the battery.
5.2 Wire Breakage Reset Function
If your fishing line breaks during use:
- Retrieve any remaining line on the spool.
- Simultaneously press and hold both the LEFT and RIGHT buttons. This action will automatically clear the length of the lost fishing line and save the current remaining line length, allowing you to continue fishing without needing to re-spool entirely.
5.3 FCC Compliance (Interference)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Important: Changes or modifications not expressly approved by the manufacturer responsible for compliance could void the user's authority to operate the equipment.
6. Specifications
| Feature | Specification |
|---|---|
| Brand Name | SAMOLLA |
| Model | TX800 |
| Gear Ratio | 7.2:1 |
| Max Drag | 10kg |
| Weight | 350g (Product), 327g (Package) |
| Material | Nylon |
| Baits Type | Fake Bait |
| Fishing Reels Type | Electric Count Wheel |
| Fishing Method | Bait Casting |
| Position | Ocean Boat Fishing, Ocean Rock Fishing, Ocean Beach Fishing, Lake, River, Reservoir Pond, Stream, Management Field |
| Origin | Mainland China |
| Package Dimensions | 14cm (Length) x 12cm (Width) x 8cm (Height) |

7. User Tips
- Line Counter Accuracy: To ensure the most accurate line counter readings, it is recommended to install the reel on your fishing rod before winding the line. Adjust the line thickness and winding length settings to match your actual line for precise measurements.
- Smooth Operation: Users report smooth and quiet operation, indicating good build quality for the price.
- Digital Display: The digital display is highly valued for its usefulness in tracking line distance and depth.
- Fish Alarm: The fish alarm function is reliable, providing both audible and visual alerts when a fish bites.
- Water Resistance: While the reel is designed to handle light water exposure, it is advisable to avoid submerging it or allowing water to enter the screen area to prevent potential damage.
8. Warranty and Support
For detailed warranty information and customer support, please refer to the official user manual PDF available at SAMOLLA TX800 User Manual (PDF). You may also contact SAMOLLA Official Store directly for assistance.