1. Overview
The WINAPEX ET8104 is a pocket-sized 3 9/10-bit automatic digital multimeter designed for stable performance, high precision, and reliability. It features clear readings and overload protection. Powered by AAA 1.5V batteries, it utilizes a large-screen LCD display with a boost power supply, ensuring high backlight brightness even at low battery levels. The backlight automatically turns off after 15 seconds to conserve power.
This instrument is capable of measuring DC voltage, AC voltage, DC current, AC current, resistance, capacitance, diode, continuity, frequency, and true RMS values. It is an ideal tool for laboratories, factories, radio enthusiasts, and home use.
Image 1: Front view of the WINAPEX ET8104 Multimeter highlighting its 9999 Count display, Temperature Function, and various measurement capabilities (AC-DC current/voltage, Resistance, Capacitance, Frequency, Temp, NCV, Duty ratio, Diode, Buzzer, True RMS, Flashlight).
2. Safety Precautions
This instrument is designed to comply with IEC1010 safety standards. Please read the following precautions carefully before use:
- When measuring voltage, do not exceed the limit voltage of DC 1000V or AC 750V rms.
- Voltages below 36V are considered safe. When measuring DC voltages above 36V or AC voltages above 25V, ensure test leads are reliably connected, properly insulated, and in good condition to prevent electric shock.
- Always remove test leads from the test point before changing functions or ranges.
- Select the correct function and range for your measurement to prevent accidental operation. Although the instrument has full-range protection, caution is advised.
- When measuring current, do not input currents exceeding 10A.
- Familiarize yourself with safety symbols: ▲ (Dangerous Voltage), △ (Refer to Instruction Manual), ⏚ (Ground), ⧈ (Double Insulation), ⎕ (Low Voltage Symbol).
3. Setup
3.1. Unboxing and Contents
Upon opening the package, verify that all components are present:
- WINAPEX ET8104 Digital Multimeter
- Test Leads (Red and Black)
- Temperature Probe
- User Manual (this document)
- Protective Sleeve (pre-installed or separate)
Video 1: Product display and unboxing of the WINAPEX ET8104 Multimeter, showing the multimeter, test leads, temperature probe, and manual.
3.2. Battery Installation
The multimeter requires AAA 1.5V batteries (typically two). To install or replace batteries:
- Ensure the multimeter is turned OFF and test leads are disconnected.
- Locate the battery compartment cover on the back of the device.
- Unscrew the retaining screw(s) and remove the cover.
- Insert the AAA batteries, observing the correct polarity (+/-) as indicated inside the compartment.
- Replace the battery cover and secure it with the screw(s).
3.3. Protective Sleeve and Kickstand
The multimeter comes with a protective sleeve that enhances durability and provides a built-in kickstand for convenient hands-free operation.
- Attaching the Sleeve: If not already attached, carefully slide the multimeter into the protective sleeve, ensuring all ports and buttons align.
- Using the Kickstand: Pull out the kickstand from the back of the sleeve to prop up the multimeter at an angle for easier viewing.
Image 2: Side view of the WINAPEX ET8104 Multimeter with its kickstand extended, allowing for angled viewing on a workbench.
3.4. Connecting Test Leads
For most measurements, connect the test leads as follows:
- Insert the black test lead into the