1. Introduction
The FENVI MPE-AX3000H is a high-performance WiFi 6 (802.11ax) and Bluetooth 5.2 wireless adapter designed for laptops. This dual-band card supports 2.4GHz and 5GHz frequencies, offering speeds up to 2974Mbps (2400Mbps on 5GHz with a 160MHz router) for a fast and reliable wireless experience. It is compatible with Windows 10 (64-bit), Windows 11 (64-bit), and Linux operating systems.
Product overview video showing the FENVI WiFi 6 Card MPE-AX3000H.
2. Package Contents
Please check the package for the following items:
- 1 x FENVI WiFi 6 Card (Model: MPE-AX3000H)
- 1 x Screwdriver
- 1 x Mounting Bracket
- Several Mounting Screws

FENVI WiFi 6 Card MPE-AX3000H with included accessories (screwdriver, bracket, screws).
3. Setup and Installation
Follow these steps to install your FENVI WiFi 6 Card:
- Step 1: Prepare Your Laptop
Power off your laptop completely, unplug the power cord, and remove the back cover of the laptop. - Step 2: Remove Old Wireless Card
Locate the old wireless network card. Unscrew any retaining screws holding it in place, carefully disconnect the antenna cables, and then remove the old wireless network card from its slot. - Step 3: Install New Wireless Card
Align the FENVI WiFi 6 card with the Mini PCI-E slot. Gently insert the card until it is fully seated. Attach the antenna cables to the corresponding connectors (usually labeled '1MAIN' and '2AUX' or similar). Tighten the retaining screws to secure the card. Close the laptop cover.

Step-by-step visual guide for installing the WiFi card in a laptop.

Close-up image of the WiFi card being installed into a laptop's Mini PCI-E slot.
3.1. Driver Installation
After physical installation, power on your laptop. You may need to install drivers for the new WiFi card. Drivers can typically be downloaded from the Intel website by searching for