Ohlite MC03 63AS

Contents

MINI LED Outdoor Garden Lights User Manual

Model: MC03 63AS

1. Introduction

Thank you for choosing Ohlite MINI LED Outdoor Garden Lights. These durable, waterproof (IP68) recessed lights are designed for exterior use in gardens, terraces, decks, driveways, and lawns. They operate on a safe low voltage (DC12V/24V) and offer various lighting options, including RGBW color-changing capabilities.

2. Safety Information

  • Ensure the power supply is disconnected before installation or maintenance.
  • Use only a DC12V or DC24V power supply as specified. Connecting to higher voltage will damage the lights.
  • All electrical work should be performed by a qualified electrician if you are unsure.
  • Do not attempt to modify the product.

3. Setup and Installation

Follow these steps for proper installation of your MINI LED Outdoor Garden Lights:

  1. Engineering Wiring: Plan and lay out the main power lines in the desired installation area.
  2. Install Embedded Parts: Insert the provided black plastic embedded sleeves into the ground or surface where the lights will be placed. Ensure they are level and at the correct depth.
  3. Filling Cement: Secure the embedded parts by filling around them with cement or appropriate bedding material. Allow it to cure completely.
  4. Lamp Wiring: Connect the wires from the LED lamp to your main power lines. Refer to the wiring diagram below for correct connections based on your light type (single color, RGB, or RGBW).
  5. Connection to Power Supply: Connect the entire system to a suitable DC12V or DC24V power supply.

Wiring Diagram

Wiring diagram for DC12V/24V safety voltage LED lights, showing connections for 2-wire (positive/negative), 4-wire (RGB), and 5-wire (RGBW) setups.
Wiring diagram for 2-wire (single color), 4-wire (RGB), and 5-wire (RGBW) configurations. Ensure correct polarity and color matching.
  • 2-Wire (Single Color): Red wire for Positive (+), Black wire for Negative (-).
  • 4-Wire (RGB): Black wire for Positive (+), Red for R-, Green for G-, Yellow for B-.
  • 5-Wire (RGBW): Black wire for Positive (+), Red for R-, Green for G-, Blue for B-, White for W-.

Installation Steps Visual Guide

Step-by-step installation guide for recessed ground lights, illustrating engineering wiring, embedded part installation, cement filling, lamp wiring, and DC12V power connection.
Visual representation of the 5-step installation process.

4. Operating Instructions

Once properly installed and connected to a power supply, your Ohlite LED Garden Lights will illuminate. These lights are dimmable and offer RGBW color options, which typically require an external compatible LED controller (not included) for full functionality. Refer to your controller's manual for specific operation of dimming and color changing features.

5. Maintenance

  • Cleaning: Periodically clean the stainless steel surface with a soft, damp cloth. Avoid abrasive cleaners or harsh chemicals.
  • Inspection: Regularly check the wiring connections for any signs of wear or damage, especially after extreme weather conditions.
  • Waterproofing: Although rated IP68, ensure the installation area maintains proper drainage to prevent prolonged standing water around the light fixture.

6. Troubleshooting

  • Light Does Not Turn On:
    • Check if the power supply is active and providing the correct voltage (DC12V/24V).
    • Verify all wiring connections are secure and correctly polarized.
    • Ensure the LED controller (if used) is functioning correctly.
  • Incorrect Color or No Color Change (RGB/RGBW models):
    • Re-check the RGB/RGBW wiring connections against the diagram. Incorrect wiring can lead to wrong colors or no color control.
    • Ensure your LED controller is compatible and properly configured.
  • Light Flickers:
    • Check for stable voltage from the power supply.
    • Inspect all wiring connections for looseness or corrosion.

7. Specifications

FeatureSpecification
Model NumberMC03 63AS
Brand NameOhlite
Item TypeUnderground Lamps
Light SourceLED bulbs (integrated)
Body MaterialStainless steel
VoltageDC 12V / 24V
Power SourceDC
Protection LevelIP68 (Waterproof)
Is DimmableYes
Luminous Flux60-249 Lumens
Installation MethodAssembly (Recessed)
CertificationRoHS, CE
OriginMainland China
Warranty3 years

Dimensions

Dimensional drawing of D42mm and D52mm MINI LED ground lights, showing lamp diameter, height, and embedded sleeve dimensions.
Dimensions for D42mm and D52mm models.
  • D42 Model: Lamp Diameter 42mm, Height 37mm. Embedded Sleeve Diameter 38mm, Height 42mm.
  • D52 Model: Lamp Diameter 52mm, Height 37mm. Embedded Sleeve Diameter 46mm, Height 42mm.

8. User Tips

  • For optimal performance and longevity, ensure all wiring connections are sealed with waterproof connectors or electrical tape, even with the IP68 rating.
  • When installing in driveways, ensure the top surface of the light is flush with the ground to prevent damage from vehicles.
  • Consider purchasing a compatible RGBW controller for full color-changing and dimming capabilities.

9. Warranty and Support

This product comes with a 3-year warranty from the date of purchase. The warranty covers manufacturing defects under normal use. It does not cover damage caused by improper installation, misuse, accidents, or unauthorized modifications.

For technical support, warranty claims, or further assistance, please contact your original retailer or the Ohlite customer service department.

A detailed user manual in PDF format may also be available from your seller: View User Manual (PDF)

© Ohlite. All rights reserved.

Ask a question about this manual

Ask about setup, troubleshooting, compatibility, parts, safety, or missing instructions. Manuals+ will review the question and use this page’s manual context to help answer it.

After a successful submission, we securely hash the supplied account or form email before sending it to Microsoft Advertising for conversion attribution. Privacy details.